DLA MS27749 REV F-2012 RELAYS ELECTROMAGNETIC 60 AMPERES 3 PDT MAGNETIC LATCH HERMETICALLY SEALED.pdf
《DLA MS27749 REV F-2012 RELAYS ELECTROMAGNETIC 60 AMPERES 3 PDT MAGNETIC LATCH HERMETICALLY SEALED.pdf》由会员分享,可在线阅读,更多相关《DLA MS27749 REV F-2012 RELAYS ELECTROMAGNETIC 60 AMPERES 3 PDT MAGNETIC LATCH HERMETICALLY SEALED.pdf(7页珍藏版)》请在麦多课文档分享上搜索。
1、AMSC N/A FSC 5945 INCH-POUND MS27749F 17 September 2012 SUPERSEDING MS27749E 27 November 2003 DETAIL SPECIFICATION SHEET RELAYS, ELECTROMAGNETIC, 60 AMPERES, 3 PDT MAGNETIC LATCH, HERMETICALLY SEALED INACTIVE FOR NEW DESIGN AFTER 15 NOVEMBER 2002. NO SUPERSEDING SPECIFICATION. This specification is
2、approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the relay described herein shall consist of this specification and the latest issue of MIL-PRF-6106. FIGURE 1. Dimensions and configuration. Provided by IHSNot for ResaleNo reproduction or n
3、etworking permitted without license from IHS-,-,-MS27749F 2 Inches mm .002 0.080 .005 0.127.010 0.254 .100 2.540.170 4.380 .203 5.156.375 9.525 .437 11.100 1.910 48.514 2.000 50.800 2.440 61.976 2.450 62.230 2.500 63.500 3.130 79.502 NOTES: 1. Dimensions are in inches. 2. Unless otherwise specified,
4、 tolerance is .031 (0.79 mm). 3. In the event of a conflict between the text of this specification and the references cited herein, the text of this specification shall take precedence. 4. Relay is magnetically latched in both positions. 5. Coils are not to be energized simultaneously (unless connec
5、ted series aiding). 6. Metric equivalents are given for general information only. MS part number Type Coil Terminal type Mounting Max weight in pounds 1/ MS27749-1 I dc Stud Plate .875 MS27749-2 I dc Stud Plate .9381/ Weight includes terminal barriers. FIGURE 1. Dimensions and configurations - Conti
6、nued. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS27749F 3 REQUIREMENTS: Contact data: Load ratings: See table I and table III. Initial contact voltage drop: 0.150 volt. After life test: 0.175 V. Overload current: 50 amperes dc; 80 amperes ac.
7、Rupture current: 60 amperes dc; 100 amperes ac. Coil data: See table II. Duty rating: Continuous. Electrical data: Insulation resistance: Initial: 100 megohms. After life or environmental test: 50 megohms. Dielectric withstanding voltage: Sea level: Initial After life tests Coil to case 1,000 1,000
8、Aux contacts N/A N/A All other points 1,250 1,000 Altitude: 80,000 ft 300,000 ft Coil to case 350 500 Aux contacts N/A All other points 350 500 Environmental characteristics: Temperature range: -70C to +125C. Maximum altitude rating: 300,000 feet. Shock g-level: 200 gs. Duration: 6 ms. Max duration
9、contact opening: 10 s. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS27749F 4 Vibration - sinusoidal: G-level 30 gs. Frequency range 10 - 3,000 Hz. Vibration - random: Applicable specification: MIL-STD-202, method 214. Test condition: IG. Duratio
10、n: 15 minutes each plane. Acceleration 15 gs. Physical data: Dimensions and configurations: See figure 1. Weight: 0.938 pound maximum. Part or Identifying Number (PIN): MS27749- (dash number from table II). Qualification by similarity: See MIL-PRF-6106. TABLE I. Rated contact load (amperes per pole)
11、 case grounded. Type of load Life operating cycles x 10328 V dc 115 V ac, phase 115/200 V ac, 3 phase 1/ See appropriate notes Main Aux Main Aux Main Aux NO NC NO NC 400 Hz 60 Hz 400 Hz 60 Hz 400 Hz 400 Hz 60 Hz Resistive 2/ 50 25 25 25 25 Inductive 10 12 12 Inductive 20 15 15 Motor 50 10 10 10 10 L
12、amp 50 5 5 5 5 Transfer load - - - 3/ Mechanical life reduced current 200 6 6 6 6 Mixed loads Applicable per specification 1/ Absence of value indicates relay is not rated for 3 phase applications. 2/ For full rated load, temperature, and altitude, use number 12 wire or larger. Relays shall be mount
13、ed so that mounting bracket temperature is limited to +135C maximum. 3/ Transfer load indicates relay is suitable for transfer between unsynchronized ac power supplies at rating indicated. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS27749F 5 Ta
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLAMS27749REVF2012RELAYSELECTROMAGNETIC60AMPERES3PDTMAGNETICLATCHHERMETICALLYSEALEDPDF

链接地址:http://www.mydoc123.com/p-696870.html