CEPT T R 22-07 E-1994 Frequency Bands Planning and Co-Ordination for Systems Using the Dcs 1800 Standards《使用Dcs 1800标准的系统频带、规划和协调》.pdf

《CEPT T R 22-07 E-1994 Frequency Bands Planning and Co-Ordination for Systems Using the Dcs 1800 Standards《使用Dcs 1800标准的系统频带、规划和协调》.pdf》由会员分享，可在线阅读，更多相关《CEPT T R 22-07 E-1994 Frequency Bands Planning and Co-Ordination for Systems Using the Dcs 1800 Standards《使用Dcs 1800标准的系统频带、规划和协调》.pdf（10页珍藏版）》请在麦多课文档分享上搜索。

1、1 CEPT T/R*22-07*E 74 - 2326414 001Z817 3TB TIR 22-07 E Page 1 Recommendation T/R 22-07 E (Montreux 1993) FREQUENCY BANDS, PLANNING AND CO-ORDINATION FOR SYSTEMS USING THE DCS 1800 STANDARDS Recommendation proposed by the Working Group “Frequency Management“ (FM) Text of the Recommendation adopted b

2、y the “European Radiocommunications Comniittee “ (ERC): The European Conference of Postal and Telecommunications Administrations, considering: that the frequency bands 1710 - 1785 MHz/1805 - 1880 MHz are allocated to the Mobile Service and the Fixed Service on a Co-primary basis that the ETSI has de

3、veloped standards for digital cellular mobile systems (DCS 1800) in the bands 1710 - 1785 MHz and 1805 - 1880 MHz that there is a need for such systems in some countries in Europe that in the implementation of DCS 1800 systems it is necessary to take account of national policies for the use of the f

4、requency bands in question that national frequency planning for the DCS 1800 systems is carried out by the operators and approved by the Radio-regulatory Administrations or carried out by such Administrations in co-operation with the operators that frequency planning in border areas will be based on

5、 Co-ordination between Radio-regulatov Administrations noting: a) b) c) that the DCS 1800 system is not intended to be a pan European System and therefore might be implemented only on a national basis that in many CEPT member countries these frequency bands are used for fixed services both analogue

6、and digital that frequency Co-ordination procedure and interservice sharing is necessary both between countries operating DCS 1800 systems and between those countries and countries operating other services in accordance with Radio Regulations recommends: 1. 2. that frequency Co-ordination between DC

7、S 1800 systems in border areas shall be based on the concept of preferential frequencies that frequency Co-ordination between DCS 1800 systems and other systems in neighbouring countries shall be based on bilateral agreements 0 Edition of February 1, 1994 CEPT T/R*22-07*E 94 232b4L4 OOL28L8 234 T/R

8、2247 E Page 2 3. 4. 5. 5.1 5.2 5.3 5.4 5.5 6. 7. 7.1 that the national DCS 1800 systems should use all or parts of the frequency bands 1710 - 1785 MHZ and 1805 - 1880 MHZ in accordance with the relevant ETSI standards that in order to ease frequency Co-ordination introduction of DCS 1800 should star

9、t in the upper parts of the bands that frequency Co-ordination between DCS 1800 systems in border areas is based on the following concept: Preferential frequencies or preferential frequency bands shall be agreed between Administrations concerned. Preferential frequencies may be used without co- ordi

10、nation with a neighbouring country if the field strength of each camer produced by the base station does not exceed a value of 25 dBpV/m at a height of 3 m above ground at a distance of 15 km inside the neighbouring country. When blocks of preferential frequencies are allocated to different countrie

11、s in border areas one RF channel in each end of the blocks shall be treated as non- preferential frequencies, in order to take account of adjacent channel interference. Ail other frequencies are subject to Co-ordination between Administrations if the interfering field strength produced by the base s

12、tation exceeds 25 dBpV/m at a height of 3 m above ground at the border line between two countries. Frequency planning in coastal areas is based on the concept of preferential frequencies and Co-ordinated frequencies assuming a middleline between the countries involved. Other principles for frequency

13、 planning and frequency co- ordination in coastal areas may be agreed between the Administrations concerned. Propagation criteria for calculating the interfering field strength are described in Annex 1. For adding multiple interferers the simplified algorithm described in Annex 2 can be used. that t

14、he technical parameters described in Annex 3 are used in the frequency co- ordination for the DCS 1800 system that the following frequency Co-ordination procedure for Co-ordination between DCS 1800 systems is used: When requesting Co-ordination the relevant characteristics of the base station shall

15、be forwarded using the Co-ordination form indicated in recommendation T/R 25-08 E. Administrations may diverge from the use of this form by common agreement but at least the following characteristics should be forwarded to the Administrations affected: a) frequency in MHz b) name of transmitter stat

16、ion c) d) geographical Co-ordinates e) effective antenna height f) antenna polarisation g) antenna azimuth country of location of transmitter station Edition of Februas, 1, 1994 CEPT T/R*22-07*E 94 2326434 0032837 170 W TIR 22-07 E Page 3 h) directivity in antenna systems i) effective radiated power

17、 j) expected coverage zone k) date of entry into service The Administration affected shall evaluate the request for Co-ordination and shall within 30 days noti the result of the evaluation to the Administration requesting Co-ordination. If in the course of the Co-ordination procedure the Administrat

18、ion affected requires additional information, it may request such information. If no reply is received by the Administration requesting Co-ordination within 30 days it may send a reminder to the Administration affected. An Administration not having responded within 30 days following communications o

19、f the reminder shall be deemed to have given its consent and the frequency may be put into use with the characteristics given in the request for Co-ordination. The periods mentioned above may be extended by common consent. In general Administrations may diverge from the technical parameters and proc

20、edures described in this Recommendation subject to bilateral agreements. 7.2 7.3 7.4 7.5 8. e Edition of February 1, 1994 T/R 22-07 E Annex 1, Page 1 ANNEX 1 Propagation curves The curves attached to this Annex should be used to determine the interfering field strength. Administrations may agree on

21、other curves, e.g. the latest version of CCIR Report 567. Correction factors A general correction factor of - 9 dB is used in the 1800 MHz band. Correction factor for receiving antenna from 10 m to 3 m: Distance 100 km: -3 dB Linear interpolation is used for intermediate distances. For sea path prop

22、agation the correction factor for receiving antenna from 10 m to 3 m is -10 dB. Effective antenna height The effective antenna height used to determine interfering field strength is the difference between the physical height of the antenna and the average height of the terrain. The evaluation of the

23、 average height of the terrain may be subject to agreement between Administrations. 0 Edition of February 1, 1994 CEPT T/R*22-07*E 94 = 2326414 0012821 829 T/R 22-07 E Annex 1, Page 2 (o YO LO m a em mm 4 - + In Logarithmic scale Linear scale Distance km) Field strength (dB (iiV/iii) for 1 kW c.r.p.

24、 ficqiiciicy: .13) IO 1000 hlll7. (Ikiiitls IV :iiicI V) - Cold sc:i iil“;, 01 Ilic iiiiic ZO!.;, cil ilic locaiiotis h. =- IO 111 e Edition of February 1, 1994 e CEPT T/R*22-07*E 94 2326434 0032822 7b5 9 T/R 22-07 E Annex 1, Page 3 PR0PAf;ATION CIJRVES FOR FREQUENCIES AROVE 400 MI1z Edition of Febr

25、uary 1,1994 CEPT T/R*22-07*E 94 W 232bV1V 0032823 bTL TIR 22-07 E Annex 2, Page 1 Annex 2 i. 1.1 Notation Simplified algorithm for frequency co-ordination P = e.i.r.p of wanted transmitter in direction of receiver (dBm) L = Isotropic path loss from wanted transmitter to receiver (dB Pi = e.i.r.p of

26、interfering transmitter i in direction of receiver Li = Isotropic path loss from interfering transmitter i to receiver a = Receiver antknna gain towards wanted transmitter (dBi) ai = Receiver antenna gain towards interfering transmitter i (dBi) i = Gain due to receiver filter selectivity on interfer

27、ence from y = Estimated shadowing margin to be allowed on CA value (dB) C = Total wAnted carrier power at receiver input (dBm) li = Effedive interfering power due to transmitter i at receiver input (allowing for the effect of receiver filtering) (dBm) I = Total effective interfering power at receive

28、r input (allowing for shadawing margin) (dBm) h = Cn threshold value (dBm) (d B) transmitter i (dB) i -2. Base-mobile Path Algorithm (a) For each cell in question, take one or more korst case“ mobile statibn MS locations. These are locations at which the CA is known, or believed to be, lowest. (b) C

29、alculate the Wanted carrier power at the receiver input: C=P-L+a (c) Calculate the effective interfering power due to each potentially intrfering transmitter (whether cochannel or adjacent channel) at the receiver input (allowing for the effect of receiver filtering): li = Pi - Li + ai + i Sum aie i

30、nterfering powers at the receiver and allow for the shadowing margin: (d) I = 10 lag10 c lO(li10) + y (e) Check the effective Cil ratio (C-I) against the threshod valueh. . i .3. Mobile-base Path Algorithm (a) Take each cell that has a potentially interfering mobile station (MS). If N is the number

31、of carrier frequencies allocated to that cell that can cause potential interference to the base station (BC). assume there are N MSs, one radiating each carrier, in that cell A proportion of the total number of MS.s so identified (e.g. 20%) should be assumed to be at the worst case locations of thei

32、r cells and the rest at the mid-point of their cells. Edition of Febniary i, i994 CEPT T/R*22-07*E 94 m 23264L4 0032824 538 m TIR 22-07 E Annex 2, Page 2 3 -.- .- O 4 -.- e -e 1 Um O O (D O O (rl O O Tt O O rn O O N O O c O O r- O O O d ln (D O o 7 N Edition of February 1, 1994 CEPT T/R*22-07*E 74 2

33、326434 0012825 474 T/R 22-07 E Annex 3, Page 1 ANNEX 3 Technical parameters of the DCS-1800 system C/I ratios The C/I ratio is the ratio between signal power to interfering signal power at the receiver input during the active part of the DCS-1800 timeslot including multiple interferers. The followin

34、g CA ratios apply : Wanted Interferer Co-channel 200 kHz 400 kHz 600 kHz DCS-1800“ DCS-1800 9 dB - 9 dB -41 dB - 49 dB A curve indicating C/I values for intermediate values of fiequency offset are attached to this Annex. Notes : Minimum field strength to be protected (Emi,) : (50 % of location - 50

35、% of time) DCS-1800 MS 42 dBpV/m“ DCS-1800 BS 38 dBpV/m“ . ( Values from GSM recommendation 05-05 (Version 4.3.0) 0 Edition of Februaq 1, 1994 CEPT T/R*22-07*E T/R 22-07 E Annex 3, Page 2 94 2326434 L2826 300 h m Yo, o ? f r i I r f - -1 b O O e I O I- o o O O ni - O .- o .- O Edition of February 1, 1994