ASTM F2576-2013 Standard Terminology Relating to Declarable Substances in Materials《料中相关可申报物质的标准术语》.pdf

《ASTM F2576-2013 Standard Terminology Relating to Declarable Substances in Materials《料中相关可申报物质的标准术语》.pdf》由会员分享，可在线阅读，更多相关《ASTM F2576-2013 Standard Terminology Relating to Declarable Substances in Materials《料中相关可申报物质的标准术语》.pdf（4页珍藏版）》请在麦多课文档分享上搜索。

1、Designation: F2576 11F2576 13Standard Terminology Relating toDeclarable Substances in Materials1This standard is issued under the fixed designation F2576; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A

2、 number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This terminology standard contains terms, definitions, descriptions of terms, nomenclature, and explanations of acronymsand symbols sp

3、ecifically associated with standards under the jurisdiction of ASTM International Committee F40 on DeclarableSubstances in Materials.1.2 This terminology may also be applicable to documents not under the jurisdiction of ASTM F40, in which case thisterminology may be referenced in those documents.2.

4、Referenced Documents2.1 ASTM Standards:2E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications2.2 Other References:ASTM Dictionary of Engineering Science available fromASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA19428-2959

5、;ASTM Stock Number: DEF00.4 Standard ISO 472 is under the jurisdiction of ISO TC 61 on Plastics and is the direct responsibility of ISO TC 61 SC 1 on Terminology.5 ISO/IEC Guide 2 is under the jurisdiction of the ISO Technical Management Board.6 VIM is under the jurisdiction of the Joint Committee f

6、or Guides in Metrology (JCGM) and is the direct responsibility of JCGM-WG2.7 Currie, Lloyd A., Pure or (B)any other mineral or its derivatives determined by the Secretary of State to be financing conflict in the Democratic Republic of the Congo or anadjoining country.conflict mineral free article, n

7、an article not containing conflict minerals (or metals derived from conflict minerals) as definedin the United States by H. R. 4173 (Dodd-Frank Wall Street Reform and Consumer Protection Act), section 1502.de minimus limit, nfrom Latin de minimus meaning of no significant consequence; in regulatory

8、contexts, the maximumamount that evokes no legal consequence, that is, the maximum allowed amount.detection limit, nthe smallest net signal or the derived concentration that can be distinguished from the background signal orblank at a specified confidence level using a specified measurement process.

9、DISCUSSIONIUPAC definition per Lloyd A. Currie, Nomenclature in Evaluation of Analytical Methods Including Detection and Quantification Capabilities.intentionally added substance, na chemical element, compound or ion that is purposely included within or on a substance,material or object.percent by m

10、ass, nunits expressing the ratio of analyte mass to sample mass multiplied by 100.DISCUSSIONFor expression in SI units, the simple ratio of mass units (for example, mg/kg) is to be preferred over percent by mass. However, percent by mass (alsowritten as % mass or mass %) is commonly used. In additio

11、n, the expressions weight % and % by weight are often substituted as synonyms for themore correct % mass. Definition comes from the International Vocabulary of Basic and General Terms in Metrology (VIM).percent by weight, nsee percent by mass.quantification limit, nperformance characteristic that ma

12、rks the ability of a chemical measurement process to adequately“quantify” an analyte.DISCUSSIONThe ability to quantify is generally expressed in terms of the signal or analyte value that will produce estimates having a specified relative standarddeviation, commonly 10 %. IUPAC definition per Lloyd A

13、. Currie, Nomenclature in Evaluation of Analytical Methods Including Detection andQuantification Capabilitiesrounding method, nin conformity assessment, a practice allowing rounding of results prior to assessing conformance to theconformity assessment limit(s).DISCUSSIONF2576 132Results shall not be

14、 rounded to a number of decimal places less than those expressed by the conformity assessment limit(s).substancea chemical element, compound or ion.4.1 Acronyms:BFRBrominated Flame RetardantCASChemical Abstracts ServiceCEFICEuropean Chemical Industry CouncilCMRCarcinogenic Mutagenic ReprotoxicCPSIAC

15、onsumer Product Safety Improvement Act of 2008 (U.S.)DNELDerived No Effect ConcentrationEChAEuropean Chemicals AssociationECEuropean CommissionEECEuropean Economic CommunityEEEElectrical and Electronic EquipmentELINCSEuropean List of Notified Chemical SubstancesELVEnd-of-Life Vehicles; refers to Eur

16、opean Commission Directive 2000/53/EC on End-of-Life VehiclesEUEuropean UnionGCIGreen Chemistry InitiativeGRASGenerally Recognized as SafeIUCLIDInternational Uniform Chemical Information DatabaseMCVMaximum Concentration Value; plural is MCVsMSDSMaterial Safety Data SheetNESNew and Existing Substance

17、sPAHPolycyclic Aromatic HydrocarbonPBBPolybrominated BiphenylPBDEPolybrominated Diphenyl EtherPBTPersistent Bioaccumulative and ToxicPCBPolychlorinated BiphenylPWBPrinted Wiring BoardREACHRegistration, Evaluation,Authorization and Restriction of Chemical substances; as originally established in Regu

18、lation(EC)No. 1907/2006RIPREACH Implementation ProjectSB20California Senate Bill 20; refers to State of California, USA Bill approved 9/29/2003 entitled Solid waste; hazardouselectronic wasteSB50California Senate Bill 50; refers to State of California, USA bill approved 9/24/2004 entitled Solid wast

19、e; hazardouselectronic waste: solid waste disposal feesSCCPShort Chain Chlorinated ParaffinsSDoCSupplier Declaration of ConformanceSVHCSubstances of Very High ConcernDISCUSSIONF2576 133As defined in REACH regulation (article 57).RoHSRestriction of Hazardous Substances; refers to Euopean Commission D

20、irective 2002/95/EC on Restriction of the Use ofCertain Hazardous Substances in Electrical and Electronic EquipmentWEEEWaste Electrical and Electronic Equipment; refers to European Commission Directive 2002/96/EC on Waste Electricaland Electronic Equipment5. Keywords5.1 declarable; definitions; glos

21、sary; restricted; terminologyASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof inf

22、ringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn.Your comments are invited either for revision of this standa

23、rd or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your vie

24、ws known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the ASTM website (www.astm.org/COPYRIGHT/).F2576 134