ASTM D7878 D7878M-2013 0000 Standard Tables for Body Measurements for Adult Female Misses Petite Figure Type Size Range 00P &ndash 20P《尺寸范围为00P至20P的成年女性身形测量用标准表》.pdf
《ASTM D7878 D7878M-2013 0000 Standard Tables for Body Measurements for Adult Female Misses Petite Figure Type Size Range 00P &ndash 20P《尺寸范围为00P至20P的成年女性身形测量用标准表》.pdf》由会员分享,可在线阅读,更多相关《ASTM D7878 D7878M-2013 0000 Standard Tables for Body Measurements for Adult Female Misses Petite Figure Type Size Range 00P &ndash 20P《尺寸范围为00P至20P的成年女性身形测量用标准表》.pdf(7页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D7878/D7878M 13Standard Tables forBody Measurements for Adult Female Misses Petite FigureType, Size Range 00P 20P1This standard is issued under the fixed designation D7878/D7878M; the number immediately following the designation indicates theyear of original adoption or, in the case of
2、revision, the year of last revision. A number in parentheses indicates the year of lastreapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval.INTRODUCTIONThese tables were developed from data published by the U.S. Department of Commerce, CaesarStudy,
3、 and Size USAStudy,ASTM Misses Figure Type standard D5585-11, Current USAindustry andStudies, Scans and documentation from Alvanon Inc.2This standard takes into consideration MissesPetite figure at a standard height of 5 ft 212 in. (65 % of average USA population) taking into accountthe decrease and
4、 increase in body weight that shift a person from one size to another, while this persondoes not gain in height. Also included is a definition of body type, Curvy or Straight as applied towaist, high hip, hip/seat, thigh and mid-thigh girths that result in a different body shape (silhouette).Major r
5、eview and evaluation was done. The incremental growth at different key body points has beenaddressed and defined, which resulted in identifying increases and decreases at different rates inspecific areas; bust, waist, high hip and hip/seat. Additionally to better serve the industry, incrementalmovem
6、ent between sizes was reviewed ensuring smooth transition between sizes. To verify theproposed body measurements, a three-dimensional Avatar was created in the Misses Petite size range00P through 20P (Curvy and Straight) by Alvanon Inc. for a visual reference and is also attached inthe documentation
7、.1. Scope1.1 These tables list body measurements of adult femalemisses petite figure type sizes 00P through 20P. Although theseare body measurements, they can be used as a baseline indesigning apparel for Misses Petite in this size range whenconsidering such factors as fabric type, ease for bodymove
8、ment, styling, and fit.1.2 These tables list body measurements for the completerange of misses petite sizing.1.3 The values stated in either SI units or inch-pound unitsare to be regarded separately as standard. The values stated ineach system may not be exact equivalents; therefore, eachsystem shal
9、l be used independently of the other. Combiningvalues from the two systems may result in non-conformancewith the standard.1.4 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-
10、priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:3D123 Terminology Relating to TextilesD5219 Terminology Relating to Body Dimensions for Ap-parel SizingD5585 Tables of Body Measurements for Adult Fema
11、leMisses Figure Type, Size Range 00202.2 ISO Standard:4ISO 3635 Size Designation of Clothes, Definitions, andBody Measurement Procedures3. Terminology3.1 Definitions:3.1.1 For definitions relating to body dimensions, refer toTerminology D5219.1These tables are under the jurisdiction of ASTM Committe
12、e D13 on Textilesand is the direct responsibility of Subcommittee D13.55 on Body Measurement forApparel Sizing.Current edition approved July 1, 2013. Published August 2013. DOI: 10.1520/D7878-13.2U.S. Department of Commerce, Voluntary Product Standard: Body Measure-ments for the Sizing of childrens
13、Apparel, NIST Publication No. PS 54-172,Washington DC.3For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.4Availa
14、ble from American National Standards Institute (ANSI), 25 W. 43rd St.,4th Floor, New York, NY 10036, http:/www.ansi.org.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States13.1.2 For definitions of other textile terms used in thisstandard,
15、 refer to Terminology D123.4. Significance and Use4.1 The use of the body measurement information in Tables1 and 2 will assist manufacturers in developing patterns andgarments that are consistent with the current anthropometriccharacteristics of the population of interest. This practiceshould in tur
16、n reduce or minimize consumer confusion anddissatisfaction related to apparel sizing. (Also refer to ISO3635 Size Designation Procedures.)4.2 Three-dimensional avatars depicting each of the MissesPetite sizes and sub categories Curvy and Straight on certainmeasures were created by Alvanon, Inc. and
17、included in thisstandard to assist manufacturers in visualizing the posture,shape, and proportions generated by the measurements chartsin the accompanying Tables5(Avatar 1-6) (see Figs. 1 and 2).5. Apparatus5.1 Tape Measure, dimensionally stable and approximately1.5 cm 12 in. wide and graduated accu
18、rately in cm 116 in.5.2 Plastic Goniometer, to measure the radian (degree) ofshoulder slope.5.3 Scale, standard, calibrated, body weight type.5.4 Metal Ruler.6. Procedure6.1 General:6.1.1 For all vertical and most horizontal measurements,subject is to be standing erect without shoes and with feetapp
19、roximately 15-cm 6-in. apart. (for Infant special cases)For all vertical and most horizontal measurements, subject is tobe lying down flat with legs extended and foot positioned at1.57 rad (90) to the leg.6.1.2 Take measurements over regular undergarments nor-mally worn.6.1.3 Take all measurements f
20、rom the same side of the bodyfor consistency.6.1.4 Refer to Terminology D5219 for the location of allpoints to be measured.6.2 Body Measurements:6.2.1 Body WeightWeight as measured on a calibratedscale taken with the subject in undergarments.6.2.2 Head GirthMeasure the maximum horizontal cir-cumfere
21、nce of the head above the ears.6.2.3 Neck Base GirthMeasure the circumference of theneck, taken over the cervicale at the back and the top of thecollarbone at the front.6.2.4 Mid-Neck GirthMeasure the horizontal circumfer-ence of the neck, taken approximately 25 mm 1 in. above theneck base level.6.2
22、.5 Shoulder GirthMeasure the horizontal circumfer-ence around the shoulders, taken at the front break-point levelwith the arms down.6.2.6 Chest/Bust GirthMeasure the horizontal circumfer-ence around the body, taken under the arms and across thefullest part of the chest/bust apex including the lower
23、portion ofthe shoulder blades.6.2.7 Under-Bust GirthMeasure the horizontal circumfer-ence around the body under the arms and bust.6.2.8 Upper-Chest GirthMeasure the horizontal circum-ference around the body, taken under the arms and above thefullest part of the chest/bust including the lower portion
24、 of theshoulder blades.6.2.9 Waist GirthMeasure the minimum horizontal cir-cumference around the body at waist height.6.2.10 High-Hip GirthMeasure the maximum horizontalcircumference around the body, taken at high hip level approxi-mately 7.5 cm 3 in. below the waist level including theabdominal ext
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD7878D7878M20130000STANDARDTABLESFORBODYMEASUREMENTSFORADULTFEMALEMISSESPETITEFIGURETYPESIZERANGE00PNDASH20P
链接地址:http://www.mydoc123.com/p-526468.html