ASTM D7566-2015c 3811 Standard Specification for Aviation Turbine Fuel Containing Synthesized Hydrocarbons《含有合成烃类的航空涡轮机燃料的标准规格》.pdf
《ASTM D7566-2015c 3811 Standard Specification for Aviation Turbine Fuel Containing Synthesized Hydrocarbons《含有合成烃类的航空涡轮机燃料的标准规格》.pdf》由会员分享,可在线阅读,更多相关《ASTM D7566-2015c 3811 Standard Specification for Aviation Turbine Fuel Containing Synthesized Hydrocarbons《含有合成烃类的航空涡轮机燃料的标准规格》.pdf(32页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D7566 15c An American National StandardStandard Specification forAviation Turbine Fuel Containing SynthesizedHydrocarbons1This standard is issued under the fixed designation D7566; the number immediately following the designation indicates the year oforiginal adoption or, in the case of
2、 revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S. Department of Defense.1. Scope*1.1 This spe
3、cification covers the manufacture of aviationturbine fuel that consists of conventional and synthetic blend-ing components.1.2 This specification applies only at the point of batchorigination, as follows:1.2.1 Aviation turbine fuel manufactured, certified, andreleased to all the requirements of Tabl
4、e 1 of this specification(D7566), meets the requirements of Specification D1655 andshall be regarded as Specification D1655 turbine fuel. Dupli-cate testing is not necessary; the same data may be used forboth D7566 and D1655 compliance. Once the fuel is releasedto this specification (D7566) the uniq
5、ue requirements of thisspecification are no longer applicable: any recertification shallbe done in accordance with Table 1 of Specification D1655.1.2.2 Field blending of synthesized paraffinic kerosine(SPK) blendstocks, as described in Annex A1 (FT SPK),Annex A2 (HEFA SPK), Annex A3 (SIP), or synthe
6、sizedparaffinic kerosine plus aromatics (SPK/A) as described inAnnexA4 with D1655 fuel (which may on the whole or in parthave originated as D7566 fuel) shall be considered batchorigination in which case all of the requirements of Table 1 ofthis specification (D7566) apply and shall be evaluated. Sho
7、rtform conformance test programs commonly used to ensuretransportation quality are not sufficient. The fuel shall beregarded as D1655 turbine fuel after certification and release asdescribed in 1.2.1.1.2.3 Once a fuel is redesignated as D1655 aviation turbinefuel, it can be handled in the same fashi
8、on as the equivalentrefined D1655 aviation turbine fuel.1.3 This specification defines specific types of aviationturbine fuel that contain synthesized hydrocarbons for civil usein the operation and certification of aircraft and describes fuelsfound satisfactory for the operation of aircraft and engi
9、nes. Thespecification is intended to be used as a standard in describingthe quality of aviation turbine fuels and synthetic blendingcomponents at the place of manufacture but can be used todescribe the quality of aviation turbine fuels for contractualtransfer at all points in the distribution system
10、.1.4 This specification does not define the quality assurancetesting and procedures necessary to ensure that fuel in thedistribution system continues to comply with this specificationafter batch certification. Such procedures are definedelsewhere, for example in ICAO 9977, EI/JIG Standard 1530,JIG 1
11、, JIG 2, API 1543, API 1595, and ATA-103.1.5 This specification does not include all fuels satisfactoryfor aviation turbine engines. Certain equipment or conditionsof use may permit a wider, or require a narrower, range ofcharacteristics than is shown by this specification.1.6 While aviation turbine
12、 fuels defined by Table 1 of thisspecification can be used in applications other than aviationturbine engines, requirements for such other applications havenot been considered in the development of this specification.1.7 Synthetic blending components, synthetic fuels, andblends of synthetic fuels wi
13、th conventional petroleum-derivedfuels in this specification have been evaluated and approved inaccordance with the principles established in Practice D4054.1.8 The values stated in SI units are to be regarded asstandard. No other units of measurement are included in thisstandard.1.9 This standard d
14、oes not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM St
15、andards:2D56 Test Method for Flash Point by Tag Closed Cup Tester1This specification is under the jurisdiction of ASTM Committee D02 onPetroleum Products, Liquid Fuels, and Lubricants and is the direct responsibility ofSubcommittee D02.J0.06 on Emerging Turbine Fuels.Current edition approved Nov. 1,
16、 2015. Published December 2015. Originallyapproved in 2009. Last previous edition approved in 2015 as D7566 15b. DOI:10.1520/D7566-15C.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume inf
17、ormation, refer to the standards Document Summary page onthe ASTM website.*A Summary of Changes section appears at the end of this standardCopyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States1D86 Test Method for Distillation of Petroleum P
18、roducts atAtmospheric PressureD93 Test Methods for Flash Point by Pensky-MartensClosed Cup TesterD129 Test Method for Sulfur in Petroleum Products (Gen-eral High Pressure Decomposition Device Method)D130 Test Method for Corrosiveness to Copper from Petro-leum Products by Copper Strip TestD156 Test M
19、ethod for Saybolt Color of Petroleum Products(Saybolt Chromometer Method)D240 Test Method for Heat of Combustion of Liquid Hy-drocarbon Fuels by Bomb CalorimeterD323 Test Method for Vapor Pressure of Petroleum Products(Reid Method)D381 Test Method for Gum Content in Fuels by Jet Evapo-rationD445 Tes
20、t Method for Kinematic Viscosity of Transparentand Opaque Liquids (and Calculation of Dynamic Viscos-ity)D1266 Test Method for Sulfur in Petroleum Products (LampMethod)D1298 Test Method for Density, Relative Density, or APIGravity of Crude Petroleum and Liquid Petroleum Prod-ucts by Hydrometer Metho
21、dD1319 Test Method for Hydrocarbon Types in Liquid Petro-leum Products by Fluorescent Indicator AdsorptionD1322 Test Method for Smoke Point of Kerosine andAviation Turbine FuelD1405 Test Method for Estimation of Net Heat of Combus-tion of Aviation FuelsD1655 Specification for Aviation Turbine FuelsD
22、1840 Test Method for Naphthalene Hydrocarbons in Avia-tion Turbine Fuels by Ultraviolet SpectrophotometryD2276 Test Method for Particulate Contaminant in AviationFuel by Line SamplingD2386 Test Method for Freezing Point of Aviation FuelsD2425 Test Method for Hydrocarbon Types in Middle Dis-tillates
23、by Mass SpectrometryD2622 Test Method for Sulfur in Petroleum Products byWavelength Dispersive X-ray Fluorescence SpectrometryD2624 Test Methods for Electrical Conductivity of Aviationand Distillate FuelsD2710 Test Method for Bromine Index of Petroleum Hydro-carbons by Electrometric TitrationD2887 T
24、est Method for Boiling Range Distribution of Pe-troleum Fractions by Gas ChromatographyD2892 Test Method for Distillation of Crude Petroleum(15-Theoretical Plate Column)D3227 Test Method for (Thiol Mercaptan) Sulfur inGasoline, Kerosine, Aviation Turbine, and Distillate Fuels(Potentiometric Method)D
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD75662015C3811STANDARDSPECIFICATIONFORAVIATIONTURBINEFUELCONTAININGSYNTHESIZEDHYDROCARBONS 含有 合成

链接地址:http://www.mydoc123.com/p-525829.html