ASTM D7510-2010(2016)e1 3972 Standard Practice for Performing Detection and Quantitation Estimation and Data Assessment Utilizing DQCALC Software based on ASTM Practices D6091 and .pdf

《ASTM D7510-2010(2016)e1 3972 Standard Practice for Performing Detection and Quantitation Estimation and Data Assessment Utilizing DQCALC Software based on ASTM Practices D6091 and .pdf》由会员分享，可在线阅读，更多相关《ASTM D7510-2010(2016)e1 3972 Standard Practice for Performing Detection and Quantitation Estimation and Data Assessment Utilizing DQCALC Software based on ASTM Practices D6091 and .pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、Designation: D7510 10 (Reapproved 2016)1Standard Practice forPerforming Detection and Quantitation Estimation and DataAssessment Utilizing DQCALC Software, based on ASTMPractices D6091 and D6512 of Committee D19 on Water1,2This standard is issued under the fixed designation D7510; the number immedia

2、tely following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1NOTEReapproved wit

3、h editorial change to 4.2.3 in December 2016.1. Scope1.1 This software was developed to automate calculationswithin three ASTM standards: Practices D2777 (outlier re-moval section), D6091, and D6512.1.2 The program calculates detection estimates (DE) andquantitation estimates (QE) for the constant,

4、straight-line,exponential, and hybrid (Rocke-Lorenzato) models of thevariation of inter or intra laboratory standard deviation(ILSD) with concentration. Calculations are shown in theDE_QE worksheet and results are shown in the DLs DQCALC; IDE; IQE; quantitationASTM International takes no position re

5、specting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility.This

6、 standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM Inter

7、national Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown b

8、elow.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the Copyright Clearance Center, 222Rosewood Drive, Danvers, MA 01923, Tel: (978) 646-2600; http:/ 10 (2016)12