ASTM D5585-2011e1 Standard Tables of Body Measurements for Adult Female Misses Figure Type Size Range 00&ndash 20 《尺寸范围为00-20的成年女性身体测量的标准表格》.pdf
《ASTM D5585-2011e1 Standard Tables of Body Measurements for Adult Female Misses Figure Type Size Range 00&ndash 20 《尺寸范围为00-20的成年女性身体测量的标准表格》.pdf》由会员分享,可在线阅读,更多相关《ASTM D5585-2011e1 Standard Tables of Body Measurements for Adult Female Misses Figure Type Size Range 00&ndash 20 《尺寸范围为00-20的成年女性身体测量的标准表格》.pdf(7页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D 5585 111Standard Tablesof Body Measurements for Adult Female Misses FigureType, Size Range 00201This standard is issued under the fixed designation D 5585; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of
2、last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1NOTEMeasurements in Tables 1 and 2 for Upper-Chest Girth, Size 8, Shoulder Slope, Shoulder and Arm Length and ArmLength were corr
3、ected editorially in May 2012.INTRODUCTIONThese body measurement tables were developed from evaluation of data currently used in theapparel industry. These tables were developed from data published by the U.S. Department ofCommerce,2Caesar Study3, Size USA Study,4Current USA industry and studies, an
4、d scans anddocumentation from Alvanon Inc.5This standard takes into consideration Misses figure at a standardheight of 5 ft 5 in. ( 65 % of average USA population) taking into account the decrease and increasein body weight that shift a person from one size to another, while this person does not gai
5、n in height.Also included is a definition of body type, Curvy or Straight as applied to waist, high hip, hip seat,thigh and mid-thigh girths that result in a different body shape (silhouette). Major review andevaluation was done. The incremental growth at different key body points has been addressed
6、 anddefined, which resulted in identifying increases and decreases at different rates in specific areas; bust,waist, high hip and hip/seat. Additionally, to better serve the industry, incremental movement betweensizes was reviewed ensuring smooth transition between sizes. To verify the proposed body
7、measurements, a three-dimensional Avatar was created in the Misses size range 00 through 20 (Curvyand Straight) by Alvanon Inc. for a visual reference and is also attached in the documentation.1. Scope1.1 These tables list body measurements of adult femalemisses figure Type sizes 00 through 20. Alth
8、ough these arebody measurements, they can be used as a baseline in design-ing apparel for Missy in this size range when considering suchfactors as fabric type, ease for body movement, styling, and fit.1.2 These tables list body measurements for the completerange of Missy sizing.1.3 The values stated
9、 in either SI units or inch-pound unitsare to be regarded separately as standard. The values stated ineach system may not be exact equivalents; therefore, eachsystem shall be used independently of the other. Combiningvalues from the two systems may result in non-conformancewith the standard.2. Refer
10、enced Documents2.1 ASTM Standards:6D 123 Terminology Relating to Textile MaterialsD 5219 Terminology Relating to a Body Dimension forApparel Sizing2.2 ISO Standards:7ISO 3635 Size Designation of Clothes, Definitions, andBody Measurement Procedures3. Terminology3.1 Definitions3.1.1 For definitions re
11、lating to body dimensions, refer toTerminology D 5219.1This table is under the jurisdiction of ASTM Committee D13 on Textiles andis the direct responsibility of Subcommittee D13.55 on Body Measurement forApparel Sizing.Current edition approved July 1, 2011. Published August 2011. Originallyapproved
12、in 1994. Last previous edition approved in 2001 as D5585-95(2001)which was withdrawn January 2010 and reinstated in July 2011. DOI: 10.1520/D5585-11.2U.S. Department of Commerce, Voluntary Product Standard: Body Measure-ments for Sizing of Girls Apparel, NIST Publication No. PS 54172, WashingtonDC.3
13、Caesar: Summary Statistics for theAdult population (Ages 18-65) of the UnitedStates of America, 2002.4Available from: http:/ Inc., 145 W. 30th Street, Suite 1000, New York, NY 10001.6For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.o
14、rg. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.7Available from American National Standards Institute (ANSI), 25 W. 43rd St.,4th Floor, New York, NY 10036, http:/www.ansi.org.1Copyright ASTM International, 100 Barr Harbor Drive
15、, PO Box C700, West Conshohocken, PA 19428-2959, United States.3.1.2 For definitions of other textile terms used in thisstandard, refer to Terminology D 12303.4. Significance and Use4.1 The use of the body measurement information in Table1 and Table 2 will assist manufacturers in developing patterns
16、and garments that are consistent with the current anthropomet-ric characteristics of the population of interest. This practiceshould in turn reduce or minimize consumer confusion anddissatisfaction related to apparel sizing. (Also refer toISO 3635.)4.2 Three-dimensional avatars depicting each of the
17、 missysizes and sub category curvy and straight on certain measures,were created by Alvanon, Inc. and included in this standard toassist manufacturers in visualizing the posture, shape, andproportions generated by the measurements charts in theaccompanying tables. (Avatar 1-6) See Fig. 1 and Fig. 2.
18、5. Apparatus5.1 Tape Measure, dimensionally stable and approximately1.5 cm (12-in.) wide and graduated accurately in cm (116 in.).5.2 Plastic Goniometry, to measure the radian (degree) ofshoulder slope.5.3 Scale, standard, calibrated, body weight type.5.4 Metal Ruler.6. Procedure6.1 General:6.1.1 Fo
19、r all vertical and most horizontal measurements,subject is to be standing erect without shoes and with feetapproximately 15 cm (6 in.) apart. (for Infant special cases) Forall vertical and most horizontal measurements, subject is to belying down flat with legs extended and foot positioned at 1.57rad
20、 (90) to the leg.6.1.2 Take measurements over regular undergarments nor-mally worn.6.1.3 Take all measurements from the same side of the bodyfor consistency.6.1.4 Refer to Terminology D 5219 for the location of allpoints to be measured.6.2 Body Measurements:6.2.1 Body WeightWeight as measured on a c
21、alibratedscale taken with the subject in undergarments.6.2.2 Head GirthMeasure the maximum horizontal cir-cumference of the head above the ears.6.2.3 Neck Base GirthMeasure the circumference of theneck, taken over the cervicale at the back and the top of thecollarbone at the front.6.2.4 Mid-Neck Gir
22、thMeasure the horizontal circumfer-ence of the neck, taken approximately 25 mm (1 in.) above theneck base level.6.2.5 Shoulder GirthMeasure the horizontal circumfer-ence around the shoulders, taken at the front break-point levelwith the arms down.6.2.6 Chest/Bust GirthMeasure the horizontal circumfe
23、r-ence around the body, taken under the arms and across thefullest part of the chest/bust apex including the lower portion ofthe shoulder blades.6.2.7 Under-Bust GirthMeasure the horizontal circumfer-ence around the body under the arms and bust.6.2.8 Upper-Chest GirthMeasure the horizontal circum-fe
24、rence around the body, taken under the arms and above thefullest part of the chest/bust including the lower portion of theshoulder blades.6.2.9 Waist GirthMeasure the minimum horizontal cir-cumference around the body at waist height.6.2.10 High-Hip GirthMeasure the maximum horizontalcircumference ar
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD55852011E1STANDARDTABLESOFBODYMEASUREMENTSFORADULTFEMALEMISSESFIGURETYPESIZERANGE00NDASH20 尺寸 范围

链接地址:http://www.mydoc123.com/p-520172.html