ASTM D5566-1995(2006) Standard Test Method for Determination of Inorganic Salt Content of Sulfated and Sulfonated Oils《硫酸化油和磺酸化油的无机盐含量测定的标准试验方法》.pdf

《ASTM D5566-1995(2006) Standard Test Method for Determination of Inorganic Salt Content of Sulfated and Sulfonated Oils《硫酸化油和磺酸化油的无机盐含量测定的标准试验方法》.pdf》由会员分享，可在线阅读，更多相关《ASTM D5566-1995(2006) Standard Test Method for Determination of Inorganic Salt Content of Sulfated and Sulfonated Oils《硫酸化油和磺酸化油的无机盐含量测定的标准试验方法》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、Designation: D 5566 95 (Reapproved 2006)Standard Test Method forDetermination of Inorganic Salt Content of Sulfated andSulfonated Oils1This standard is issued under the fixed designation D 5566; the number immediately following the designation indicates the year oforiginal adoption or, in the case o

2、f revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon (e) indicates an editorial change since the last revision or reapproval.1. Scope1.1 This test method covers the determination of a sample ofsulfonated or sulfated oil, or both,

3、the inorganic sulfates,chlorides, and all other salts that are insoluble in a mixture ofoleic acid and carbon tetrachloride.1.2 The values stated in SI units are to be regarded as thestandard.1.3 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It

4、 is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Significance and Use2.1 This test method is intended to be used for the determi-nation of the inorganic salt content of

5、sulfated and sulfonatedfats and oils for the purpose of quality control.3. Apparatus3.1 Gooch Crucible or Filter PaperEither may be usedfor filtering. Ignite the Gooch crucible in a larger crucible,supported by a ring and assembled as shown in Fig. 1. If filterpaper is used, it may be a 9-cm general

6、 purpose ashless filterpaper.3.2 Thermometer.4. Reagents4.1 Carbon Tetrachloride (CCl4).4.2 Ethyl Ether.4.3 Oleic Acid.5. Procedure5.1 The procedure consists of dehydrating the sample,dissolving in a solvent, filtering, igniting, and weighing theresidue. In the presence of ammonium salts, the residu

7、e is notignited but only dried to constant weight. The presence ofsodium acetate does not interfere with this test method.5.1.1 In the Absence of Ammonium SaltsWeigh3to5gofthe sample and place in a 250-mL beaker, add an approxi-mately equal amount of oleic acid, and heat the mixture on anoil bath, w

8、hile stirring constantly with a thermometer, at atemperature of 105 to 110C until practically free from water.Continue the heating until the temperature of the contentsreaches 118 to 120C and maintain at that temperature forabout 5 min. If the dehydrated sample upon cooling does notremain liquid, ad

9、d more oleic acid. Dissolve the dehydratedsample in 100 mL of CCl4warmed to 50 to 55C, and filterthrough a counterpoised filter paper or a Gooch crucible. Pass75 mL of CCl4through the crucible and again ignite, cool in adesiccator, and weigh. Repeat the process of washing withCCl4until there is no f

10、urther loss in weight. Wash the residuewith three 15-mL portions of a solution of oleic acid inCCl4(2 %), then with six 15-mL portions of hot CCl4, andfinally with two 15-mL portions of ether or until the residue isfree from oil. Take care that the top of the filter is thoroughlywashed. Transfer the

11、 last traces of the residue to the filter byallowing the solvent to evaporate when the salts become freeflowing. Dry the residue at 125 to 130C for 45 min, cool in adesiccator, and weigh. Ignite the residue at a dull red heat for15 min, weigh, and repeat the ignition until constant weight isobtained

12、.5.1.2 In the Presence of Ammonium SaltsProceed asdescribed in 6.1.1 for the determination of inorganic salts in theabsence of ammonium salts with the following exceptions: (1)in preparing the Gooch crucible, do not ignite but heat it at 1056 2C for 45 min and repeat the heating until constant weigh

13、tis obtained, and (2) heat the residue, whether in a Goochcrucible or on a filter paper as in (1), but do not ignite it.1This test method is under the jurisdiction of ASTM Committee D31 on Leatherand is the direct responsibility of Subcommittee D31.08 on Fats and Oils. This testmethod was developed

14、in cooperation with the American Leather Chemists Assn.(Method H 48-1957).Current edition approved April 1, 2006. Published April 2006. Originallyapproved in 1994. Last previous edition approved in 2001 as D 5566 95(2001).FIG. 1 Gooch Crucible Assembly for Determination of InorganicSalts1Copyright A

15、STM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959, United States.6. Calculation6.1 The method of calculation depends upon whether or notammonium salts are present in the sample.6.1.1 Calculate the inorganic sulfates and chlorides includ-ing ammonium salts as fol

16、lows:Inorganic sulfates and chlorides, including (1)ammonium salts, % 5 A/B! 3 100where:A = weight of dried residue, g, andB = weight of sample, g.6.1.2 Calculate the nonvolatile inorganic sulfates and chlo-rides (in the absence of ammonium salts) as follows:Nonvolatile, inorganic sulfates and chlor

17、ides; % 5 A/B! 3 100(2)where:A = weight of ignited residue, g, andB = weight of sample, g.NOTE 1In the absence of ammonium salts, the difference between thepercentage of the dried residue and the percentage of the ignited residueshall not be greater than 0.25 %.7. Precision and Bias7.1 This test met

18、hod is adopted from the procedures of theAmerican Leather Chemists Association, where it has longbeen in use and was approved for publication before theinclusion of precision and bias statements was mandated. Theoriginal interlaboratory test data are no longer available. Theuser is cautioned to veri

19、fy by the use of reference materials, ifavailable, that the precision and bias (or reproducibility) of thistest method is adequate for the contemplated use.8. Keywords8.1 inorganic salts; leather; sulfated and sulfonated oils;sulfated oilsASTM International takes no position respecting the validity

20、of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility.This standard is subject t

21、o revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters.

22、 Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below.This standard is

23、copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org).D 5566 95 (2006)2