ASTM D2832-1992(2016) Standard Guide for Determining Volatile and Nonvolatile Content of Paint and Related Coatings《用于测定油漆和相关涂料的挥发性和非挥发性含量的标准指南》.pdf
《ASTM D2832-1992(2016) Standard Guide for Determining Volatile and Nonvolatile Content of Paint and Related Coatings《用于测定油漆和相关涂料的挥发性和非挥发性含量的标准指南》.pdf》由会员分享,可在线阅读,更多相关《ASTM D2832-1992(2016) Standard Guide for Determining Volatile and Nonvolatile Content of Paint and Related Coatings《用于测定油漆和相关涂料的挥发性和非挥发性含量的标准指南》.pdf(3页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D2832 92 (Reapproved 2016)Standard Guide forDetermining Volatile and Nonvolatile Content of Paint andRelated Coatings1This standard is issued under the fixed designation D2832; the number immediately following the designation indicates the year oforiginal adoption or, in the case of rev
2、ision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This guide is intended to aid in the selection of theproper ASTM standard for determining the volat
3、ile and non-volatile content of paint and related coatings.NOTE 1Test methods for determining the composition of the volatilefraction are not covered by this guide.1.2 The standards included are as follows:Type of Coating SectionASTMDesignationAerosol coatings 4.1 D3062Architectural wall coatings, i
4、nterior, highperformance4.3 D1644Asphalt roof coatings 4.4 D2823Asphalt roof coatings, aluminum-pigmented 4.5 D2824Bitumens, emulsified 4.6 D2939Bleached lac varnish 4.7 D1650Coil coatings 4.8 D1353D2697Electrical insulation varnishes 4.9 D115House paints, gloss D2697Industrial baking enamel D2697La
5、cquers, clear and pigmented 4.11 D1644D333Latex paint, exterior D2697Latex paint, interior D2697Magnet wire enamels 4.12 D3288Plastics, coatings for 4.13 D1644Powder coatings 4.14 D3451Shellac varnish, orange 4.7 D1650Silanes, Siloxanes and Silane-Siloxane Blends 4.18 D5095Solvent-reducible coatings
6、 4.2 D2369Traffic paints 4.15 D2205Varnishes 4.16 D1644Wall and trim enamels, interior semigloss,solvent-based4.17 D2697Wall paints, flat 4.10 D2697Water-reducible coatings 4.2 D23691.3 The values stated in SI units are to be regarded as thestandard. The values given in parentheses are for informati
7、ononly.1.4 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Refer
8、enced Documents2.1 ASTM Standards:2D115 Test Methods for Testing Solvent Containing Var-nishes Used for Electrical InsulationD333 Guide for Clear and Pigmented LacquersD1353 Test Method for Nonvolatile Matter in Volatile Sol-vents for Use in Paint, Varnish, Lacquer, and RelatedProductsD1644 Test Met
9、hods for Nonvolatile Content of VarnishesD1650 Test Methods for Sampling and Testing ShellacVarnish (Withdrawn 1997)3D2205 Guide for Selection of Tests for Traffic PaintsD2369 Test Method for Volatile Content of CoatingsD2697 Test Method for Volume Nonvolatile Matter in Clearor Pigmented CoatingsD28
10、23 Specification for Asphalt Roof Coatings, Asbestos-ContainingD2824 Specification forAluminum-PigmentedAsphalt RoofCoatings, Nonfibered, Asbestos Fibered, and Fiberedwithout AsbestosD2939 Test Methods for Emulsified Bitumens Used asProtective Coatings (Withdrawn 2012)3D3062 Test Method for Solids C
11、ontent of Aerosol Coatings(Withdrawn 1994)3D3288 Test Methods for Magnet-Wire EnamelsD3451 Guide for Testing Coating Powders and PowderCoatingsD5095 Test Method for Determination of the NonvolatileContent in Silanes, Siloxanes and Silane-Siloxane BlendsUsed in Masonry Water Repellent Treatments1This
12、 guide is under the jurisdiction of ASTM Committee D01 on Paint andRelated Coatings, Materials, and Applications and is the direct responsibility ofSubcommittee D01.21 on Chemical Analysis of Paints and Paint Materials.Current edition approved April 1, 2016. Published April 2016. Originallyapproved
13、in 1969. Last previous edition approved in 2011 as D2832 92 (2011).DOI: 10.1520/D2832-92R16.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document S
14、ummary page onthe ASTM website.3The last approved version of this historical standard is referenced onwww.astm.org.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States13. Significance and Use3.1 The nonvolatile content of paint and related
15、 coatings isuseful to producers and users and to environmental and healthand safety interests in comparing the coverage of competingproducts and in estimating the volatile organic content.4. Procedure4.1 Aerosol CoatingsTest Method D3062 covers the de-termination of solids content (weight %) in aero
16、sol coatings.4.2 Volatile Content of Coatings (Test Method D2369)This test method covers the determination of the volatilecontent of coatings. It is considered to be applicable to mostsolvent-reducible and water-reducible paints.4.3 High Performance Interior Architectural Wall Coatings(HIPAC)Determi
17、ne the nonvolatile content of HIPAC coat-ings in accordance with Test Methods D1644. Calculate thevolatile content (weight %) by difference.4.3.1 Method A3 h at 105C for paints with nonsolventcomponents that decompose at higher temperature.4.3.2 Method B10 min at 149C for most paints withnonsolvent
18、components that are reasonably stable at 149C.4.4 Asphalt Roof CoatingsDetermine the nonvolatile con-tent (weight %) of asphalt roof coatings of brushing or spray-ing consistency in accordance with the Physical RequirementsConsistency section of Specification D2823.4.5 Aluminum-Pigmented Asphalt Roo
19、f CoatingsThe non-volatile content (weight %) of asphalt-based aluminum roofcoatings suitable for application to roofing or masonry surfacesby brush or spray is determined in accordance with thePhysical Requirements Consistency section of SpecificationD2824.4.6 Emulsified Bitumens Used as Protective
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD283219922016STANDARDGUIDEFORDETERMININGVOLATILEANDNONVOLATILECONTENTOFPAINTANDRELATEDCOATINGS 用于

链接地址:http://www.mydoc123.com/p-513587.html