ASTM D341-2009(2015) Standard Practice for Viscosity-Temperature Charts for Liquid Petroleum Products《液态石油产品粘度-温度图的标准实施规程》.pdf
《ASTM D341-2009(2015) Standard Practice for Viscosity-Temperature Charts for Liquid Petroleum Products《液态石油产品粘度-温度图的标准实施规程》.pdf》由会员分享,可在线阅读,更多相关《ASTM D341-2009(2015) Standard Practice for Viscosity-Temperature Charts for Liquid Petroleum Products《液态石油产品粘度-温度图的标准实施规程》.pdf(6页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D341 09 (Reapproved 2015)Standard Practice forViscosity-Temperature Charts for Liquid PetroleumProducts1This standard is issued under the fixed designation D341; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year
2、 of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S. Department of Defense.1. Scope1.1 This practice covers kinemat
3、ic viscosity-temperaturecharts (see Figs. 1 and 2), which are a convenient means toascertain the kinematic viscosity of a petroleum oil or liquidhydrocarbon at any temperature within a limited range, pro-vided that the kinematic viscosities at two temperatures areknown.1.2 The charts are designed to
4、 permit petroleum oil kine-matic viscosity-temperature data to plot as a straight line. Thecharts here presented provide a significant improvement inlinearity over the charts previously available under MethodD34143. This increases the reliability of extrapolation tohigher temperatures.1.3 The values
5、 provided in SI units are to be regarded asstandard. The values given in parentheses are provided forinformation only.2. Referenced Documents2.1 ASTM Standards:2D445 Test Method for Kinematic Viscosity of Transparentand Opaque Liquids (and Calculation of Dynamic Viscos-ity)2.2 ASTM Adjuncts:3Viscosi
6、ty-Temperature Charts 173. Technical Hazard3.1 WarningThe charts should be used only in that rangein which the hydrocarbon or petroleum fluids are homogeneousliquids. The suggested range is thus between the cloud point atlow temperatures and the initial boiling point at higher tem-peratures. The cha
7、rts provide improved linearity in both lowkinematic viscosity and at temperatures up to 340 C (approxi-mately 650 F) or higher. Some high-boiling point materialscan show a small deviation from a straight line as low as280 C (approximately 550 F), depending on the individualsample or accuracy of the
8、data. Reliable data can be usefullyplotted in the high temperature region even if it does exhibitsome curvature. Extrapolations into such regions from lowertemperatures will lack accuracy, however. Experimental datataken below the cloud point or temperature of crystal growthwill generally not be of
9、reliable repeatability for interpolationor extrapolation on the charts. It should also be emphasizedthat fluids other than hydrocarbons will usually not plot as astraight line on these charts.1This practice is under the jurisdiction of ASTM Committee D02 on PetroleumProducts, Liquid Fuels, and Lubri
10、cants and are the direct responsibility ofSubcommittee D02.07 on Flow Properties.Current edition approved June 1, 2015. Published June 2015. Originallyapproved in 1932. Last previous edition approved in 2009 as D341 09. DOI:10.1520/D0341-09R15.2For referenced ASTM standards, visit the ASTM website,
11、www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3Available from ASTM International Headquarters. Order Adjunct No.ADJD0341CS. Original adjunct produced in 1965.Copyr
12、ight ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States1FIG.1FacsimileofKinematicViscosity-TemperatureChartIHighRange(TemperatureindegreesCelsius)D341 09 (2015)2FIG.2FacsimileofKinematicViscosity-TemperatureChartIILowRange(TemperatureindegreesCels
13、ius)D341 09 (2015)34. Description4.1 The charts are designed to permit kinematic viscosity-temperature data for a petroleum oil or fraction, and hydrocar-bons in general, to plot as a straight line over a wide range.Seven charts are available as follows:3Chart IKinematic Viscosity, High Range:Kinema
14、tic Viscosity: 0.3 cSt to 20 000 000 cStTemperature: 70 C to +370 CSize: 680 mm by 820 mm (26.75 in. by 32.25 in.)Pad of 50ADJD034101Chart IIKinematic Viscosity, Low Range:Kinematic Viscosity: 0.18 cSt to 6.5 cStTemperature: 70 C to +370 CSize: 520 mm by 820 mm (20.5 in. by 32.25 in.)Pad of 50ADJD03
15、4102Chart IIIKinematic Viscosity, High Range:Kinematic Viscosity: 0.3 cSt to 20 000 000 cStTemperature: 70 C to +370 CSize: 217 mm by 280 mm (8.5 in. by 11.0 in.)Pad of 50ADJD034103Chart IVKinematic Viscosity, Low Range:Kinematic Viscosity: 0.18 cSt to 6.5 cStTemperature: 70 C to +370 CSize: 217 mm
16、by 280 mm (8.5 in. to 11.0 in.)Pad of 50ADJD034104Chart VKinematic Viscosity, High Range:Kinematic Viscosity: 0.3 cSt to 20 000 000 cStTemperature: 100 F to +700 FSize: 680 mm by 820 mm (26.75 in. by 32.25 in.)Pad of 50ADJD034105Chart VIKinematic Viscosity, Low Range:Kinematic Viscosity: 0.18 cSt to
17、 3.0 cStTemperature: 100 F to +700 FSize: 520 mm by 820 mm (20.5 in. by 32.25 in.)Pad of 50ADJD034106Chart VIIKinematic Viscosity, Middle Range:Kinematic Viscosity: 3 cSt to 200 000 cStTemperature: 40 C to +150 CSize: 217 mm by 280 mm (8.5 in. by 11.0 in.)Pad of 50ADJD0341074.2 Charts I, II, V, and
18、VI are preferred when convenienceand accuracy of plotting are desired. Chart VII is the middlerange section of Chart I at somewhat reduced scale. It isprovided for convenience in connection with reports and dataevaluation. Charts III and IVare the same as Charts I and II andare provided in greatly r
19、educed scale for convenience inconnection with reports or quick evaluation of data. Theselatter charts are not recommended for use where the mostaccurate interpolations or extrapolations are desired.5. Procedure5.1 Plot two known kinematic viscosity-temperature pointson the chart. Draw a sharply def
20、ined straight line through them.A point on this line, within the range defined in Section 3,shows the kinematic viscosity at the corresponding desiredtemperature and vice versa.45.2 Alternatively, the interpolated and extrapolated kine-matic viscosities and temperatures may be calculated asdescribed
21、 in Annex A1, within the range identified for thecharts in Section 3.6. Extrapolation6.1 Kinematic viscosity-temperature points on the extrapo-lated portion of the line, but still within the range defined inSection 3, are satisfactory provided the kinematic viscosity-temperature line is located quit
22、e accurately. For purposes ofextrapolation, it is especially important that the two knownkinematic viscosity-temperature points be far apart. If thesetwo points are not sufficiently far apart, experimental errors inthe kinematic viscosity determinations and in drawing the linemay seriously affect th
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD34120092015STANDARDPRACTICEFORVISCOSITYTEMPERATURECHARTSFORLIQUIDPETROLEUMPRODUCTS 液态 石油 产品 粘度 温度
链接地址:http://www.mydoc123.com/p-511564.html