ASHRAE 55 ADD A-2014 Thermal Environmental Conditions for Human Occupancy.pdf

《ASHRAE 55 ADD A-2014 Thermal Environmental Conditions for Human Occupancy.pdf》由会员分享，可在线阅读，更多相关《ASHRAE 55 ADD A-2014 Thermal Environmental Conditions for Human Occupancy.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、ANSI/ASHRAE Addendum a toANSI/ASHRAE Standard 55-2013Thermal EnvironmentalConditions forHuman OccupancyApproved by the ASHRAE Standards Committee on June 28, 2014; by the ASHRAE Board of Directors on July 2, 2014; and by theAmerican National Standards Institute on July 31, 2014.This addendum was app

2、roved by a Standing Standard Project Committee (SSPC) for which the Standards Committee has estab-lished a documented program for regular publication of addenda or revisions, including procedures for timely, documented, con-sensus action on requests for change to any part of the standard. The change

3、 submittal form, instructions, and deadlines may beobtained in electronic form from the ASHRAE website (www.ashrae.org) or in paper form from the Manager of Standards. The latest edition of an ASHRAE Standard may be purchased on the ASHRAE website (www.ashrae.org) or from ASHRAE Cus-tomer Service, 1

4、791 Tullie Circle, NE, Atlanta, GA 30329-2305. E-mail: ordersashrae.org. Fax: 678-539-2129. Telephone: 404-636-8400 (worldwide), or toll free 1-800-527-4723 (for orders in US and Canada). For reprint permission, go towww.ashrae.org/permissions. 2014 ASHRAE ISSN 1041-2336SPECIAL NOTEThis American Nat

5、ional Standard (ANS) is a national voluntary consensus standard developed under the auspices of ASHRAE.Consensus is defined by the American National Standards Institute (ANSI), of which ASHRAE is a member and which has approved thisstandard as an ANS, as “substantial agreement reached by directly an

6、d materially affected interest categories. This signifies the concurrenceof more than a simple majority, but not necessarily unanimity. Consensus requires that all views and objections be considered, and that aneffort be made toward their resolution.” Compliance with this standard is voluntary until

7、 and unless a legal jurisdiction makes compliancemandatory through legislation.ASHRAE obtains consensus through participation of its national and international members, associated societies, and public review.ASHRAE Standards are prepared by a Project Committee appointed specifically for the purpose

8、 of writing the Standard. The ProjectCommittee Chair and Vice-Chair must be members of ASHRAE; while other committee members may or may not be ASHRAE members, allmust be technically qualified in the subject area of the Standard. Every effort is made to balance the concerned interests on all ProjectC

9、ommittees.The Manager of Standards of ASHRAE should be contacted for:a. interpretation of the contents of this Standard,b. participation in the next review of the Standard,c. offering constructive criticism for improving the Standard, ord. permission to reprint portions of the Standard.DISCLAIMERASH

10、RAE uses its best efforts to promulgate Standards and Guidelines for the benefit of the public in light of available information andaccepted industry practices. However, ASHRAE does not guarantee, certify, or assure the safety or performance of any products, components,or systems tested, installed,

11、or operated in accordance with ASHRAEs Standards or Guidelines or that any tests conducted under itsStandards or Guidelines will be nonhazardous or free from risk.ASHRAE INDUSTRIAL ADVERTISING POLICY ON STANDARDSASHRAE Standards and Guidelines are established to assist industry and the public by off

12、ering a uniform method of testing for ratingpurposes, by suggesting safe practices in designing and installing equipment, by providing proper definitions of this equipment, and by providingother information that may serve to guide the industry.The creation of ASHRAE Standards and Guidelines is deter

13、mined by the need for them,and conformance to them is completely voluntary.In referring to this Standard or Guideline and in marking of equipment and in advertising, no claim shall be made, either stated or implied,that the product has been approved by ASHRAE.ASHRAE Standing Standard Project Committ

14、ee 55CognizantTC: 2.1, Physiology and Human EnvironmentSPLS Liaison: John F. DunlapGwelen Paliaga, Chair* Gail S. Brager Brian M. LynchLawrence J. Schoen, Vice Chair* Richard de Dear Michael P. ORourke*Peter F. Alspach, Secretary* Josh Eddy* Abhijeet Pande*Sahar Abbaszadeh Fard* Thomas B. Hartman* J

15、ulian Rimmer*Edward A. Arens* Daniel Int-Hout, III* Stefano SchiavonRichard M. Aynsley* Michael A. Humphreys Peter Simmonds*Robert Bean* Essam Eldin Khalil* Stephen C. Turner*Atze Boerstra Baizhan Li*Denotes members of voting status when the document was approved for publicationASHRAE STANDARDS COMM

16、ITTEE 20132014William F. Walter, Chair John F. Dunlap Rick A. LarsonRichard L. Hall, Vice-Chair James W. Earley, Jr. Mark P. ModeraKarim Amrane Steven J. Emmerich Cyrus H. NasseriJoseph R. Anderson Julie M. Ferguson Janice C. PetersonJames Dale Aswegan Krishnan Gowri Heather L. PlattCharles S. Barna

17、by Cecily M. Grzywacz Douglas T. ReindlSteven F. Bruning Rita M. Harrold Julia A. Keen, BOD ExOJohn A. Clark Adam W. Hinge Thomas E. Werkema, Jr., COWaller S. Clements Debra H. KennoyDavid R. Conover Malcolm D. KnightStephanie C. Reiniche, Manager of StandardsASHRAE is a registered trademark of the

18、American Society of Heating, Refrigerating and Air-Conditioning Engineers, Inc.ANSI is a registered trademark of the American National Standards Institute. ASHRAE (www.ashrae.org). For personal use only. Additional reproduction, distribution, or transmission in either print or digital form is not pe

19、rmitted without ASHRAEs prior written permission.ANSI/ASHRAE Addendum a to ANSI/ASHRAE Standard 55-2013 1(This foreword is not part of this standard. It is merelyinformative and does not contain requirements necessaryfor conformance to the standard. It has not been pro-cessed according to the ANSI r

20、equirements for a standardand may contain material that has not been subject topublic review or a consensus process. Unresolved objec-tors on informative material are not offered the right toappeal at ASHRAE or ANSI.)FOREWORDThis addendum separates vertical air stratification limitsfor standing vs.

21、seated occupants because the previousrequirement did not distinguish between the two and would beoverly restrictive when applied to standing occupants. Thisclarification only applies to occupants who are standing stillwith metabolic rates less than 1.3 met because the entire Sec-tion 5.3.4, “Local T

22、hermal Discomfort,” does not applyabove 1.3 met.Note: In this addendum, changes to the current standardare indicated in the text by underlining (for additions) andstrikethrough (for deletions) unless the instructions specifi-cally mention some other means of indicating the changes.5.3.4.4 Vertical A

23、ir Temperature Difference. Air tem-perature difference between head level and ankle level shallnot exceed 3C (5.4F) for seated occupants or 4C (7.2F)for standing occupants (see note in Section 5.3.4.1).6.2 Documentationg. Air speed, radiant temperature asymmetry, vertical radiantair-temperature diff

24、erence asymmetry, surface tempera-tures, and temperature variations with time shall be deter-mined in accordance with generally accepted engineeringstandards (e.g., Chapter 57 of ASHRAE HandbookHVAC Applications). The method used and quantifiedselection criteria, characteristics, sizes, and indices

25、thatare applicable to the method shall be stated.Addendum a to Standard 55-2013Modify Section 5.3.4.4 as shown below.Modify Section 6.2(g) as shown below. ASHRAE (www.ashrae.org). For personal use only. Additional reproduction, distribution, or transmission in either print or digital form is not per

26、mitted without ASHRAEs prior written permission. ASHRAE (www.ashrae.org). For personal use only. Additional reproduction, distribution, or transmission in either print or digital form is not permitted without ASHRAEs prior written permission.POLICY STATEMENT DEFINING ASHRAES CONCERNFORTHE ENVIRONMEN

27、TAL IMPACT OF ITS ACTIVITIESASHRAE is concerned with the impact of its members activities on both the indoor and outdoor environment. ASHRAEsmembers will strive to minimize any possible deleterious effect on the indoor and outdoor environment of the systems andcomponents in their responsibility whil

28、e maximizing the beneficial effects these systems provide, consistent with acceptedstandards and the practical state of the art.ASHRAEs short-range goal is to ensure that the systems and components within its scope do not impact the indoor andoutdoor environment to a greater extent than specified by

29、 the standards and guidelines as established by itself and otherresponsible bodies.As an ongoing goal, ASHRAE will, through its Standards Committee and extensive technical committee structure,continue to generate up-to-date standards and guidelines where appropriate and adopt, recommend, and promote

30、 those newand revised standards developed by other responsible organizations.Through its Handbook, appropriate chapters will contain up-to-date standards and design considerations as the material issystematically revised.ASHRAE will take the lead with respect to dissemination of environmental inform

31、ation of its primary interest and will seekout and disseminate information from other responsible organizations that is pertinent, as guides to updating standards andguidelines.The effects of the design and selection of equipment and systems will be considered within the scope of the systemsintended

32、 use and expected misuse. The disposal of hazardous materials, if any, will also be considered.ASHRAEs primary concern for environmental impact will be at the site where equipment within ASHRAEs scopeoperates. However, energy source selection and the possible environmental impact due to the energy s

33、ource and energytransportation will be considered where possible. Recommendations concerning energy source selection should be made byits members. ASHRAE (www.ashrae.org). For personal use only. Additional reproduction, distribution, or transmission in either print or digital form is not permitted without ASHRAEs prior written permission.ASHRAE 1791 Tullie Circle NE Atlanta, GA 30329 www.ashrae.org8/14