ARMY MIL-F-43987 A (2)-1984 FOOTWEAR COVER CHEMICAL PROTECTIVE (OVERBOOTS)《化学防护鞋罩(胶皮套鞋)》.pdf

《ARMY MIL-F-43987 A (2)-1984 FOOTWEAR COVER CHEMICAL PROTECTIVE (OVERBOOTS)《化学防护鞋罩(胶皮套鞋)》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-F-43987 A (2)-1984 FOOTWEAR COVER CHEMICAL PROTECTIVE (OVERBOOTS)《化学防护鞋罩(胶皮套鞋)》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-F-43987A AMENDMENT-2 . . i6 Novenber i984 SUPERSEDING AMENDMENT- 1 8 March 1983 MILITARY SPECIFICATION FOOTWEAR COVER, CHEMICAL PROTECTIVE (OVERBOOTS) This amendment forms a part of Military Specification MIL-F-43987A, dated 21 May 1981, and is approved for use by all Departments and Agencies of

2、 the Department of Defense. .PAGE 2 * 2,1, under “STANDARDS MILITARYtf: Delete “MIL-STD-1188 - Commercial Packaging of Supplies and Equipment“. * 2.2, under AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)“: Add “D 3951 - Standard Practice for Commercial Packaging“. * 3.2,2: Delete the first senten

3、ce and substitute “The laces shall be flat spun nylon laces conforming to type I, class 2, 10/32 inch width or type I, class 3, 9/32 inch width of V-L-61.“ PAGE 13 * 4.4.4: Delete the third and fourth sentences and substitute “The sample unit shall be one shipping container fully packaged.“ PAGE 17

4、5.1,1, line 6, after “measure“: Insert “not more than“. * 5,1.2, line 2: Delete “MIL-STD-1188 and substitute “ASTM D 3951“, FSC 8430 Page 1 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-P _II MIL-F-43B7A (2) 84 W 9977906 0463352 5 MIL-F-43987A

5、 Amendment-2 $i( 5.2.3, line 2: Delete “MIL-STD-1188 and substitute “ASTM D 3951“. = J( 5.3: Delete and substitute: * “5.3 Palletization. When specified (see 6.2), footwear covers, packed as specified in 5.2, shall be palletized on a 4-way entry pallet in accordance with load type Ia of MIL-STD-147.

6、 Each prepared load shall be bonded with primary and secondary straps in accordance with bonding means K and L or film bonding means O or P. MIL-STD-147. of each course. If the container is of a size which does not conform to any of the patterns specified in MIL-STD-147, the pallet pattern used shal

7、l first be approved by the contracting officer.“ Pallet patterns shall be in accordance with the appendix of Interlocking of loads shall be effected by reversing the pattern * 5,.4, line 3: Delete tIMIL-STD-11881f and substitute “ASTM D 3951“. 5.4.1, line 3: .Delete 9IXED SIZES“. and substitute “MIX

8、ED NSNs“. Line 5: Delete “sizes“ and.substitute “NSNs“. PAGE 19 k 6.4, line 2: Delete “DAR 7-104.55“ and substitute “FAR 52.209“. NOTE: The margins of this amendment are marked with an asterisk to indicate where changes (additions, modifications, corrections, deletions) from the previous amendment w

9、ere made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the previous amendment. Custodians: Army - GL Navy - Nu Air Force - 11 Review activities: Army - EA Air Force - 82,99 DLA - CT User activities: Navy - SH Air Force - 45 2 Preparing activity: Army - GL Project No. 8430-0343 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-