BS PD ISO TR 17427-8-2015 Intelligent transport systems Cooperative ITS Liability aspects《智能运输系统 协作ITS 责任方面》.pdf
《BS PD ISO TR 17427-8-2015 Intelligent transport systems Cooperative ITS Liability aspects《智能运输系统 协作ITS 责任方面》.pdf》由会员分享,可在线阅读,更多相关《BS PD ISO TR 17427-8-2015 Intelligent transport systems Cooperative ITS Liability aspects《智能运输系统 协作ITS 责任方面》.pdf(32页珍藏版)》请在麦多课文档分享上搜索。
1、BSI Standards Publication Intelligent transport systems Cooperative ITS Part 8: Liability aspects PD ISO/TR 17427-8:2015National foreword This Published Document is the UK implementation of ISO/TR 17427- 8:2015. The UK participation in its preparation was entrusted to Technical Committee EPL/278, In
2、telligent transport systems. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. The British Standards Institutio
3、n 2015. Published by BSI Standards Limited 2015 ISBN 978 0 580 87425 3 ICS 03.220.01; 35.240.60 Compliance with a British Standard cannot confer immunity from legal obligations. This Published Document was published under the authority of the Standards Policy and Strategy Committee on 30 November 20
4、15. Amendments/corrigenda issued since publication Date Text affected PUBLISHED DOCUMENT PD ISO/TR 17427-8:2015 ISO 2015 Intelligent transport systems Cooperative ITS Part 8: Liability aspects Systmes intelligents de transport Systmes intelligents de transport coopratifs Partie 8: Aspects relatifs l
5、a responsabilit TECHNICAL REPORT ISO/TR 17427-8 Reference number ISO/TR 17427-8:2015(E) First edition 2015-11-01 PD ISO/TR 17427-8:2015 ISO/TR 17427-8:2015(E)ii ISO 2015 All rights reserved COPYRIGHT PROTECTED DOCUMENT ISO 2015, Published in Switzerland All rights reserved. Unless otherwise specifie
6、d, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISOs
7、member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyrightiso.org www.iso.org PD ISO/TR 17427-8:2015 ISO/TR 17427-8:2015(E)Foreword v Introduction vii 1 Scope . 1 2 T erms and
8、definitions . 1 3 Abbreviations and acronyms . 2 4 How to use this Technical Report 3 4.1 Acknowledgement . 3 4.2 Guidance . 3 4.3 C-ITS Liability aspects 3 5 What are the key liability issues 5 5.1 Effects of different types of C-ITS applications technology risk . 5 5.2 Crash causation 6 5.3 Types
9、of parties in C-ITS . 7 5.4 Human factors . 8 5.5 What is the standard of safety expected? . 8 6 Legal Status 8 6.1 Regional and National variations 8 6.1.1 General 8 6.1.2 Europe . 9 6.1.3 USA . 9 6.1.4 Australia .10 6.1.5 China 10 6.1.6 Japan 10 6.1.7 Other Countries 10 6.2 Driver remains in charg
10、e .10 6.3 Tort .11 6.3.1 General issues regarding tort 11 6.3.2 Consequences of breach of duty .12 6.3.3 Contract law 13 6.4 Product liability .13 6.5 Compulsory third party systems 13 7 Policy questions and options 14 7.1 General 14 7.2 Option 1: Continue current approach 14 7.3 Option 2: Enact spe
11、cific C-ITS liability laws to clarify issues .14 7.4 Option 3: Non-legislative approaches 14 7.5 Option 4: Information and education campaigns 15 8 C-ITS Actors and Liability .15 8.1 C-ITS and jurisdictions 15 8.2 C-ITS and road operators/managers 15 8.3 C-ITS and manufacturers 16 8.4 C-ITS informat
12、ion/application service providers .16 8.5 C-ITS and drivers 16 9 Summary of findings17 9.1 General 17 9.2 Explicit regulation by jurisdictions 17 9.3 Opt-in to service provision 18 9.4 Advisory systems Driver remains in charge 18 9.5 Interventionist systems 18 9.6 Service providers need to make user
13、s aware and limit risks through opt-in conditions of use.18 ISO 2015 All rights reserved iii Contents Page PD ISO/TR 17427-8:2015 ISO/TR 17427-8:2015(E)9.7 Manufacturers need to test thoroughly and have explicit conditions of use 18 9.8 Need for audit trail .18 9.9 Minimize the points of opportunity
14、 of failure .18 9.10 Advise driver of status of systems .18 9.11 Human factor considerations will be critical .18 9.12 Road managers need to assess and manage risk implications .19 9.13 Expectations will change .19 9.14 Clear guidance and regulation required 19 9.15 Driver training 19 Bibliography .
15、20 iv ISO 2015 All rights reserved PD ISO/TR 17427-8:2015 ISO/TR 17427-8:2015(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
16、 ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborate
17、s closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval cri
18、teria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives). Attention is drawn to the possibility that some of the elements of this document may be the subject
19、of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents). Any trade na
20、me used in this document is information given for the convenience of users and does not constitute an endorsement. For an explanation on the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISOs adherence to the WTO principles in the Techni
21、cal Barriers to Trade (TBT) see the following URL: Foreword - Supplementary information The committee responsible for this document is ISO/TC 204, Intelligent transport systems. ISO 17427 consists of the following parts, under the general title Intelligent transport systems Cooperative ITS: Part 2:
22、Framework Overview Technical Report Part 3: Concept of operations (ConOps) for core systems Technical Report Part 4: Minimum system requirements and behaviour for core systems Technical Report Part 6: Core system risk assessment methodology Technical Report Part 7: Privacy aspects Technical Report P
23、art 8: Liability aspects Technical Report Part 9: Compliance and enforcement aspects Technical Report Part 10: Driver distraction and information display Technical Report The following parts are under preparation: Part 1: Roles and responsibilities in the context of co-operative ITS architecture(s)
24、Part 5: Common approaches to security Technical Report Part 11: Compliance and enforcement aspects Technical Report Part 12: Release processes Technical Report Part 13: Use case test cases Technical Report Part 14: Maintenance requirements and processes Technical Report ISO 2015 All rights reserved
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BSPDISOTR1742782015INTELLIGENTTRANSPORTSYSTEMSCOOPERATIVEITSLIABILITYASPECTS 智能 运输 系统 协作 ITS 责任 方面 PDF

链接地址:http://www.mydoc123.com/p-398790.html