ISO 8607 AMD 1-2011 Artificial insemination of animals - Frozen semen of breeding bulls - Enumeration of living aerobic microorganisms Amendment 1《动物的人工受精 公牛冷冻精.pdf

《ISO 8607 AMD 1-2011 Artificial insemination of animals - Frozen semen of breeding bulls - Enumeration of living aerobic microorganisms Amendment 1《动物的人工受精 公牛冷冻精.pdf》由会员分享，可在线阅读，更多相关《ISO 8607 AMD 1-2011 Artificial insemination of animals - Frozen semen of breeding bulls - Enumeration of living aerobic microorganisms Amendment 1《动物的人工受精 公牛冷冻精.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、 Reference number ISO 8607:2003/Amd.1:2011(E) ISO 2011INTERNATIONAL STANDARD ISO 8607 First edition 2003-02-01 AMENDMENT 1 2011-04-01 Artificial insemination of animals Frozen semen of breeding bulls Enumeration of living aerobic microorganisms AMENDMENT 1 Insmination artificielle des animaux Semenc

2、es congeles de taureaux reproducteurs Dnombrement des micro-organismes arobies vivants AMENDEMENT 1 ISO 8607:2003/Amd.1:2011(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless t

3、he typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of

4、Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the

5、 unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO 2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, elec

6、tronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.

7、org Web www.iso.org Published in Switzerland ii ISO 2011 All rights reservedISO 8607:2003/Amd.1:2011(E) ISO 2011 All rights reserved iiiForeword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing

8、International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaiso

9、n with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of tec

10、hnical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is dra

11、wn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Amendment 1 to ISO 8607:2003 was prepared by Technical Committee ISO/TC 34, Food products. ISO 8607:2003/Amd.1:2011(E

12、) ISO 2011 All rights reserved 1Artificial insemination of animals Frozen semen of breeding bulls Enumeration of living aerobic microorganisms AMENDMENT 1 Add a new sentence at the end of subclause 6.5 so that it reads “6.5 Pipettes, having a nominal capacity of 1 ml, graduated in 0,1 ml divisions. Blow-out pipettes shall not be used. However, micropipettes of capacity 1,0 ml 0,01 ml can be used. ISO 8607:2003/Amd.1:2011(E) ICS 65.020.30 Price based on 1 page ISO 2011 All rights reserved