ISO 1017-2006 Brown coals and lignites - Determination of acetone-soluble material ( resinous substance ) in the benzene-soluble extract《褐炭和褐煤 可溶苯萃取物中丙酮可溶物( 树脂状.pdf

《ISO 1017-2006 Brown coals and lignites - Determination of acetone-soluble material ( resinous substance ) in the benzene-soluble extract《褐炭和褐煤 可溶苯萃取物中丙酮可溶物( 树脂状.pdf》由会员分享，可在线阅读，更多相关《ISO 1017-2006 Brown coals and lignites - Determination of acetone-soluble material ( resinous substance ) in the benzene-soluble extract《褐炭和褐煤 可溶苯萃取物中丙酮可溶物( 树脂状.pdf（10页珍藏版）》请在麦多课文档分享上搜索。

1、 Reference number ISO 1017:2006(E) ISO 2006INTERNATIONAL STANDARD ISO 1017 Third edition 2006-12-01 Brown coals and lignites Determination of acetone-soluble material (“resinous substance”) in the benzene-soluble extract Charbons bruns et lignites Dtermination des matires solubles dans lactone de le

2、xtrait au tolune soluble (substances rsineuses) ISO 1017:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed o

3、n the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products us

4、ed to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please

5、inform the Central Secretariat at the address given below. ISO 2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing fr

6、om either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2006 All rights reservedISO 1017:2006(E)

7、 ISO 2006 All rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body int

8、erested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnic

9、al Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the

10、technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights.

11、ISO shall not be held responsible for identifying any or all such patent rights. ISO 1017 was prepared by Technical Committee ISO/TC 27, Solid mineral fuels, Subcommittee SC 5, Methods of analysis. This third edition cancels and replaces the second edition (ISO 1017:1985), which has been technically

12、 revised. INTERNATIONAL STANDARD ISO 1017:2006(E) ISO 2006 All rights reserved 1 Brown coals and lignites Determination of acetone-soluble material (“resinous substance”) in the benzene-soluble extract 1 Scope This International Standard specifies a method of determining the mass fraction of acetone

13、-soluble material (“resinous substance”) in the benzene-soluble extract from brown coals and lignites. NOTE The acetone extract will also contain a percentage of wax dissolved simultaneously with the “resinous substance“. 2 Normative references The following referenced documents are indispensable fo

14、r the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 975, Brown coals and lignites Determination of yield of benzene-soluble extract Semi-automatic metho

15、d 3 Principle The sample of benzene-soluble extract from brown coal or lignite obtained by the procedure described in ISO 975 is extracted with acetone at a temperature of 18 to 22 C. The soluble fraction is filtered or centrifuged off and, after evaporation of the solvent, dried to constant mass. T

16、he percentage of acetone-soluble material is calculated from the mass of residue after drying. 4 Reagent 4.1 Acetone, of analytical reagent grade. WARNING Acetone is flammable, and toxic by inhalation, ingestion or skin absorption 5 Apparatus 5.1 Centrifuge, capable of operating at 1 600 r/min. The

17、rotational frequency of the centrifuge shall be sufficient to ensure separation of the soluble fraction from the parent coal. 5.2 Glass centrifuge vessels, either cylindrical or conical, of capacity 15 ml and fitted with ground-glass stoppers, for use in the centrifuge. 5.3 Evaporating dish, of glas

18、s or silica, about 20 mm high and 50 mm in diameter. ISO 1017:2006(E) 2 ISO 2006 All rights reserved5.4 Vacuum drying oven, electrically heated, in which a temperature of 80 2 C and a pressure of about 50 kPa can be maintained. 5.5 Air oven, electrically heated, capable of maintaining a temperature

19、of 100 to 110 C. 5.6 Infrared drying lamp. 5.7 Wire-cloth test sieve, of nominal aperture size 100 m. 6 Preparation of sample The residue obtained from the benzene-soluble extract obtained by the method specified in ISO 975 shall be crushed to pass the sieve (5.7). If the residue is viscous liquid,

20、it shall be cooled in solid carbon dioxide to 80 C, and then crushed. 7 Procedure 7.1 Test condition The high selectivity of acetone requires a strict temperature control during the determination. The temperature of the solvent, the room temperature at the beginning of the determination and the room

21、 temperature at the end of the determination shall not differ from each other by more than 0,5 C and shall be within the range 18 to 22 C. 7.2 Determination Record the room temperature at the beginning of the extraction (t 2 ) and the temperature of the acetone (t 1 ). Weigh, to the nearest 1 mg, ab

22、out 0,5 g of the sample into a glass vessel (5.2). Add 7 ml of the acetone (Clause 4) and shake for exactly 2 min. Minimise warming of the solvent by holding the glass vessel at the upper end between the index and middle fingers, while the thumb secures the ground-glass stopper. Rubber finger-shield

23、s should be worn. Allow the acetone-soluble fraction to clear and decant it into a tared, dry evaporating dish (5.3). If the fraction does not clear, it may be centrifuged for 1 min and then decanted, or filtered if necessary using the smallest convenient size of filter paper, into the evaporating d

24、ish. Wash back any particles of benzene-soluble extract adhering to the upper end of the glass vessel, after shaking by cautiously tilting the vessel. Let any washed fraction settle or centrifuge it. Add a further 7 ml of the acetone to the glass vessel and repeat the above extraction (but not more

25、than 4 times) until the extract fraction is colourless. Record the room temperature at the end of the extraction (t 3 ) to the nearest 0,1 C. If a filter has been used, rinse it with a few millilitres of acetone and add the rinsings to the evaporating dish. Place the evaporating dish in the vacuum d

26、rying oven (5.4) and evaporate off the acetone at 80 2 C and about 50 kPa. Alternatively, the evaporation may be carried out using the infrared drying lamp (5.6). Transfer the dish to the air oven (5.5) and dry to constant mass at 105 3 C. ISO 1017:2006(E) ISO 2006 All rights reserved 3 8 Expression

27、 of results The mass fraction of acetone-soluble material, w Ac,20 , in the sample analysed, expressed as a percentage, is given by the equation , 2 Ac 20 1 Km w m = where m 1is the mass, in grams, of benzene-soluble extract taken; m 2is the mass, in grams, of acetone-soluble material recovered; K =

28、 100 + 2,5(20 t) in which 123 3 ttt t + = t 1being the temperature, in degrees Celsius, of the acetone used for the extraction; t 2being the room temperature, in degrees Celsius, at the beginning of the determination; t 3being the room temperature, in degrees Celsius, at the end of the determination

29、. The result (the mean of duplicate determinations, see 9.1) should be reported to the nearest 0,1 % (mass fraction). 9 Precision of the method Maximum acceptable difference between Mass fraction of acetone-soluble material results % repeatability reproducibility less than 20 0,3 % absolute 0,5 % ab

30、solute 20 to 30 0,4 % absolute 0,7 % absolute 30 to 50 0,5 % absolute 0,9 % absolute over 50 1,0 % of the mean result 1,8 % of the mean result 9.1 Repeatability The results of duplicate determinations, carried out in the same laboratory, by the same operator, using the same apparatus, on the same be

31、nzene-soluble extract, within short intervals of time, should not differ by more than the above value. 9.2 Reproducibility The means of the results of duplicate determinations, carried out in two different laboratories on representative test portions taken from the same benzene-soluble extract, shou

32、ld not differ by more than the above value. ISO 1017:2006(E) 4 ISO 2006 All rights reserved10 Test report The test report should include the following information: a) identification of the product tested; b) a reference to this International Standard; c) the results and the method of expression used. ISO 1017:2006(E) ICS 73.040 Price based on 4 pages ISO 2006 All rights reserved