VA 27 41 31-2009 MASTER ANTENNA TELEVISION EQUIPMENT AND SYSTEMS.pdf

《VA 27 41 31-2009 MASTER ANTENNA TELEVISION EQUIPMENT AND SYSTEMS.pdf》由会员分享，可在线阅读，更多相关《VA 27 41 31-2009 MASTER ANTENNA TELEVISION EQUIPMENT AND SYSTEMS.pdf（30页珍藏版）》请在麦多课文档分享上搜索。

1、08-09M 27 41 31 - 1 SECTION 27 41 31 MASTER ANTENNA TELEVISION EQUIPMENT AND SYSTEMS SPEC WRITER NOTES: 1. Edit between /-/ Delete if not applicable to project. Defer to VA TVE (005OP3B see Paragraph 1.3.D for specific contact info) for technical assistance. 2. Included throughout this specification

2、 are references to the systems interface capability and various related features. The system designer shall verify availability of this system and coordinate associated requirements and subsequent interface(s). PART 1 - GENERAL 1.1 SECTION SUMMARY A. Work covered by this document includes design, en

3、gineering, labor, material, products, guarantee, training and services for, and incidental to the complete installation of new and fully operating NFPA listed Master Antenna Television (TV) equipment and systems as detailed herein. B. Work shall be complete, complete, labeled, VA Central Office (VAC

4、O) tested and certified and ready for operation 1.2 RELATED SECTIONS A. Section 01 33 23, SHOP DRAWINGS, PRODUCT DATA AND SAMPLES. B. Section 26 05 21, LOW-VOLTAGE ELECTRICAL POWER CONDUCTORS AND CABLES (600 Volts and Below). C. Section 26 41 00, FACILITY LIGHTNING PROTECTION. D. Section 27 10 00, S

5、TRUCTURED COMMUNICATIONS SYSTEMS CABLING. E. Section 27 05 11, REQUIREMENTS FOR COMMUNCATIONS INSTALLATIONS. F. Section 27 05 26, GROUNDING AND BONDING FOR COMMUNCATIONS SYSTEMS. G. Section 27 05 33, RACEWAYS AND BOXES FOR COMMUNICATIONS SYSTEMS. H. Section 27 10 00, STRUCTURED CABLING. I. Section 2

6、7 15 00, COMMUNICATIONS HORIZONTAL CABLING. / J. Section 27 15 00.61/71, RADIO ENTERTAINMENT HORIZONTAL CABLING AND EXTENSION./ / K. Section 27 52 23, NURSE CALL/CODE BLUE EQUIPMENT AND SYSTEMS./ 1.3 DEFINITIONS A. Provide: Design, engineer, furnish, install, connect complete, test, certify and guar

7、antee. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-08-09M 27 41 31 - 2 B. Work: Materials furnished and completely installed. C. Review of contract drawings: A service by the engineer to reduce the possibility of materials being ordered which do

8、not comply with contract documents. The engineers review shall not relieve the Contractor of responsibility for dimensions or compliance with the contract documents. The reviewers failure to detect an error does not constitute permission for the Contractor to proceed in error. D. Headquarters Techni

9、cal Review, for National/VA communications and security, codes, frequency licensing, standards, guidelines compliance: Office of Telecommunications Special Communications Team (005OP2B) 1335 East West Highway 3rd Floor Silver Spring, Maryland 20910 (O) 301-734-0350, (F) 301-734-0360 E. Engineer: /XX

10、XXXXX/ /XXXXXXX/ /XXXXXXX/ /XXXXXXX/ /XXXXXXX/ F. Owner: /XXXXXXX/ G. General Contractor (GC): /XXXXXXX/ H. Contractor: Radio Contractor; you; successful bidder 1.4 REFERENCES A. The installation shall comply fully with all governing authorities, laws and ordinances, regulations, codes and standards

11、, including, but not limited to: 1. United States Federal Law/Codes: a. Departments of: 1) CFR, Title 15 Department of Commerce, Under the Information Technology Management Reform Act (Public Law 104-106), the Secretary of Commerce approves standards and guidelines that are developed by the: a) Chap

12、ter II, National Institute of Standards Technology (NIST formerly the National Bureau of Standards). Under Section 5131 of the Information Technology Management Reform Act of 1996 and the Federal Information Security Management Act of 2002 (Public Law 107-347), NIST develops Federal Information Proc

13、essing Standards Publication Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-08-09M 27 41 31 - 3 (FIPS) 140-2Security Requirements for Cryptographic Modules. b) Chapter XXIII, National Telecommunications and Information Administration (NTIA aka Red B

14、ook) Chapter 7.8/9 Federal communications Commission (FCC) Title 47 (CFR), Part 15, Radio Frequency Restriction of Use and Compliance in “Safety of Life” Functions and Locations. 2) CFR, Title 29, Department of Labor, Chapter XVII - Occupational Safety and Health Administration (OSHA), Part 1910 Occ

15、upational Safety and Health Standard: a) Subpart 7 - Definition and requirements for a National Recognized Testing Laboratory (NRTL 15 Laboratorys, for complete list, contact http:/www.osha.gov/dts/otpca/nrtl/faq_nrtl.html) (1) Underwriters Laboratories (UL): 65 Standard for Wired Cabinets. 468 Stan

16、dard for Grounding and Bonding Equipment. 1449 Standard for Transient Voltage Surge Suppressors. 1069 Hospital Signaling and Nurse Call Equipment. 60950-1/2 Information Technology Equipment Safety. (2) Canadian Standards Association (CSA): same tests as for UL. (3) Communications Certifications Labo

17、ratory (CCL): same tests as for UL. (4) Intertek Testing Services NA, Inc. (ITSNA formerly Edison Testing Laboratory ETL): same tests as for UL. b) Subpart 35, Compliance with NFPA 101 Life Safety Code. c) Subpart 36, Design and construction requirements for exit routes. d) Subpart 268, Telecommunic

18、ations. e) Subpart 305, Wiring methods, components, and equipment for general use. 3) Public Law No. 100-527, Department of Veterans Affairs: Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-08-09M 27 41 31 - 4 a) Office of Telecommunications: Handboo

19、k 6100 Telecommunications. b) Office of Cyber and Information Security (OCIS): (1) Handbook 6500 - Information Security Program. (2) Wireless and Handheld Device Security Guideline Version 3.2, August 15, 2005. c) Spectrum Management FCC and NTIA Radio Frequency Compliance and Licensing Program. d)

20、Office of Cyber and Information Security (OCIS): (1) Handbook 6500 - Information Security Program. (2) Wireless and Handheld Device Security Guideline Version 3.2, August 15, 2005. 4) Title 42, CFC, Department of Health, Chapter IV Health and Human Services, Subpart 1395(a)(b) Joint Commission on Ac

21、creditation of Healthcare Organizations (JCAHO) “a hospital that meets JCAHO accreditation is deemed to meet the Medicare conditions of Participation by meeting Federal Directives:” All guidelines for Life, Personal and Public Safety; and, Essential and Emergency Communications. 5) CFR, Title 47 - T

22、elecommunications, in addition to FCC: Part 15 Restrictions of use for Part 15 listed Radio Equipment in Safety of Life/Emergency Functions/Equipment/Locations (also see CFR, Title 15 Department of Commerce, Chapter XXIII NTIA): Part 73 Radio Broadcast Service, Part 90 Rules and Regulations, Appendi

23、x C. Form 854 Antenna Structure Registration. 6) Public Law 89-670, Department of Transportation, CFR-49, Part 1, Subpart C Federal Aviation Administration (FAA): a) Standards AC 110/460-ID and AC 707/460-2E Advisory Circulars for Constructions of Antenna Towers. b) Forms 7450 and 7460-2 Antenna Con

24、struction Registration. 2. National Codes: a. American Institute of Architects (AIA): Guidelines for Healthcare Facilities. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-08-09M 27 41 31 - 5 b. American National Standards Institute/Electronic Indust

25、ries Association/Telecommunications Industry Association (ANSI/EIA/TIA): 568-B Commercial Building Telecommunications Wiring Standards: 569 Commercial Building Standard for Telecommunications Pathways and Spaces. 606 Administration Standard for the Telecommunications Infrastructure of Communications

26、 Buildings. 607 Commercial Building Grounding and Bonding Requirements for Telecommunications. REC 127-49 Power Supplies. RS 27 Tools, Crimping, Solderless Wiring Devices, Recommended Procedures for User Certification. c. Institute of Electrical and Electronics Engineers (IEEE): SO/TR 21730:2007 Use

27、 of mobile wireless communication and computing technology in healthcare facilities - Recommendations for electromagnetic compatibility (management of unintentional electromagnetic interference) with medical devices. 0739-5175/08/$25.002008IEEE Medical Grade Mission Critical Wireless Networks. C62.4

28、1 Surge Voltages in Low-Voltage AC Power Circuits. d. American Society of Mechanical Engineers (ASME): 1) Standard 17.4, Guide for Emergency Personnel. 2) Standard 17.5, Elevator and Escalator Equipment (prohibition of installing non-elevator equipment in Elevator Equipment Room/Mechanical Penthouse

29、). e. NFPA: 70 National Electrical Code (current date of issue) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-08-09M 27 41 31 - 6 Articles 517, 645 and 800. 75 Standard for Protection of Electronic Computer Data- Processing Equipment. 77 Recommende

30、d Practice on Static Electricity. 99 Healthcare Facilities. 101 Life Safety Code. 3. State Hospital Code(s). 4. Local Codes. 1.5 QUALIFICATIONS A. The OEM shall have had experience with three or more installations of systems of comparable size and complexity about type and design as specified herein

31、. Each of these installations shall have performed satisfactorily for at least 1 year after final acceptance by the user. Include the names, locations and point of contact for these installations as a part of the submittal. B. The Contractor shall submit certified documentation that they have been a

32、n authorized distributor and service organization for the OEM for a minimum of 3 years. The Contractor shall be authorized by the OEM to pass thru the OEMs warranty of the installed equipment to VA. In addition, the OEM and Contractor shall accept complete responsibility for the design, installation

33、, certification, operation, and physical support for the system. This documentation, along with the System Contractor and OEM certifications must be provided in writing as part of the Contractors Technical submittal. C. The Contractors Communications Technicians assigned to the system shall be fully

34、 trained, qualified, and certified by the OEM on the engineering, installation, operation, and testing of the system. The Contractor shall provide formal written evidence of current OEM certification(s) for the installer(s) as a part of the submittal or to the Resident Engineer before being allowed

35、to commence work on the system. D. Applicable national, state and local licenses. E. Certificate of successful completion of OEMs installation/training school for installing technicians of the equipment being proposed. 1.6 CODES AND PERMITS A. Provide all necessary permits and schedule all inspectio

36、ns as identified in the contracts milestone chart, so that the system is Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-08-09M 27 41 31 - 7 proof of performance tested and ready for operation on a date directed by the Owner. B. The contractor is res

37、ponsible to adhere to all codes described herein and associated contractual, state and local codes. 1.7 SCHEDULING A. After the award of contract, the Contractor shall prepare a detailed schedule (aka milestone chart) using “Microsoft Project” software or equivalent. The Contractor Project Schedule

38、(CPS) shall indicate detailed activities for the projected life of the project. The CPS shall consist of detailed activities and their restraining relationships. It will also detail manpower usage throughout the project. B. It is the responsibility of the Contractor to coordinate all work with the o

39、ther trades for scheduling, rough-in, and finishing all work specified. The owner will not be liable for any additional costs due to missed dates or poor coordination of the supplying contractor with other trades. 1.8 REVIEW OF CONTRACT DRAWINGS AND EQUIPMENT DATA SUBMITTALS A. Submit at one time wi

40、thin 10 days of contract awarding, drawings and product data on all proposed equipment and system. Check for compliance with contract documents and certify compliance with Contractors “APPROVED“ stamp and signature. B. Support all submittals with descriptive materials, i.e., catalog sheets, product

41、data sheets, diagrams, and charts published by the manufacturer. These materials shall show conformance to specification and drawing requirements. C. Where multiple products are listed on a single cut-sheet, circle or highlight the one that you propose to use. Provide a complete and through equipmen

42、t list of equipment expected to be installed in the system, with spares, as a part of the submittal. Special Communications (TVE-005OP3B herein after referred to as 005OP3B) will not review any submittal that does not have this list. D. Provide 4 copies to the PM for technical review. The PM will pr

43、ovide a copy to the offices identified in Paragraph 1.3.C and D, at a minimum for compliance review as described herein where each responsible individual(s) should respond to the PM within 10 days of receipt of their acceptance or rejection of the submittal(s). Provided by IHSNot for ResaleNo reprod

44、uction or networking permitted without license from IHS-,-,-08-09M 27 41 31 - 8 E. Head End and each interface distribution cabinet layout drawing, as they are to be installed. F. Equipment technical literature detailing the electrical and technical characteristics of each item of equipment to be fu

45、rnished. H. Engineering drawings of the system, showing calculated signal levels at the Head End input and output, each input and output distribution point, and signal level at each telecommunications outlet. I. Antenna Signal Survey: 1. The Contractor shall submit a computerized signal survey for t

46、he system radiated and receive RF signals. The survey(s) shall be made by a recognized industry source that is derived mathematically from fixed information and projects an approximation of the signal levels that can be expected at the actual site using a given antenna. 2. The signal survey can usua

47、lly be obtained from the OEM for the radio equipment at no charge. An on-site survey, using actual transmitting and receiving equipment of the type the Contractor has specified, is an acceptable alternate. 3. The approximate longitude and latitude of the Facility along with the elevation above mean

48、sea level can be obtained from the Resident Engineer. 4. The Contractor shall record all findings on a geographic map with the Facility residing in its center and shall outline all coverage locations, radiating in a 360-degree pattern. The primary, secondary, marginal and out of range areas operatio

49、n shall be depicted by different colors for each frequency of operation. 1.9 PROJECT RECORD DOCUMENTS (AS BUILTS) A. Throughout progress of the work, maintain an accurate record of changes in Contract Documents. Upon completion of Work, transfer recorded changes to a set of Project Record Documents. B. The flo