ITU-T J 81 AMD 1-1995 Transmission of Component-Coded Digital Television Signals for Contribution-Quality Applications at the Third Hierarchical Level of ITU-T Recommendation G 702nt 1.pdf

《ITU-T J 81 AMD 1-1995 Transmission of Component-Coded Digital Television Signals for Contribution-Quality Applications at the Third Hierarchical Level of ITU-T Recommendation G 702nt 1.pdf》由会员分享，可在线阅读，更多相关《ITU-T J 81 AMD 1-1995 Transmission of Component-Coded Digital Television Signals for Contribution-Quality Applications at the Third Hierarchical Level of ITU-T Recommendation G 702nt 1.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、 - STD-ITU-T RECMN J.BL-ENGL 1995 4b2591 b32178 411 m INTERNATIONAL TELECOMMUNICATION UNION TU-T TELECOMMUNICATION STANDARDIZATION SECTOR OF ITU Amendment 1 TELEVISION AND SOUND TRANSMISSION J.81 (1 0/95) TRANSMISSION OF COMPONENT-CODED DIGITAL TELEVISION SIGNALS FOR AT THE THIRD HIERARCHICAL LEVEL

2、CONTRIBUTION-QUALITY APPLICATIONS OF ITU-T RECOMMENDATION G.702 APPENDIX II: GUIDELINES FOR IMPLEMENTATION OF A COMPLETE TELEVISION CODEC Amendment I to ITU-T Recommendation J.81 (Previously “CCITT Recommendation“) STD-ITU-T RECMN J-81-ENGL 1775 W 48b257L Ob32177 358 FOREWORD The ITU-T (Telecommunic

3、ation Standardization Sector) is a permanent organ of the International Telecommunication Union (IT). The ITU-T is responsible for studying technical, operating and tariff questions and issuing Recommen- dations on them with a view to standardizing telecommunications on a worldwide basis. The World

4、Telecommunication Standardization Conference (WTSC), which meets every four years, establishes the topics for study by the ITU-T Study Groups which, in their turn, produce Recommendations on these topics. The approval of Recommendations by the Members of the IT-T is covered by the procedure laid dow

5、n in WTSC ResolutionNo. 1 (Helsinki, March 1-12, 1993). Amendment 1 to ITU-T Recommendation J.81, was prepared by ITU-T Study Group 9 (1993-1996) and was approved under the WTSC Resolution No. 1 procedure on the 24th of October 1995. NOTE In this Amendment, the expression “Administration” is used fo

6、r conciseness to indicate both a telecommunication administration and a recognized operating agency. O ITU 1996 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permissi

7、on in writing from the ITU. STD-ITU-T RECMN J-81-ENGL 1945 48b259L Ob32LBO 07T = CONTENTS Appendix II . Guidelines for implementation of a complete television codec II . 1 Interoperability 11.2 Networking requirements Page 1 1 2 STD-ITU-T RECMN JmBL-ENGL 1775 = 4Bb257L Ob32181 TOb M Amendment 1 to R

8、ecommendation 5.81 TRANSMISSION OF COMPONENT-CODED DIGITAL TELEVISION SIGNALS FOR CONTRIBUTION-QUALITY APPLICATIONS AT THE THIRD HIERARCHICAL LEVEL OF ITU-T RECOMMENDATION 6.702 Appendix II (to Annex A to Recommendation J.81) Guidelines for implementation of a complete television codec (Geneva, 1995

9、) To add this Appendix II, renumber the present Appendix II to Annex A as Appendix III Whilst Appendix I to Annex A to Recommendation 5.81 provides guidelines for implementation of the video codec, a number of parameters are still left unspecified as regards a complete TV codec providing the complet

10、e set of services (i.e. video, sound, data and scrambling). Thus, for the purpose of international programme exchange, it is necessary to specifj a few more parameters, some in order to meet basic intenvorking between codecs, others to achieve consistent networking operation. The following indicates

11、 the choices made by the EBU (European Broadcasting Union) for the implementation of its own network. 11.1 Interoperability 11.1.1 Sound A stereo/2-channel audio codec should be used, according to Recommendation 5.57 (formerly CMTT.724). The sampling frequency used for audio analogue to digital conv

12、ersion at the encoder, if needed, should be locked to the video time-base and should neither be free-running nor locked directly to the transmission network clock. 11.1.2 Scrambling Scrambling should be implemented but will be performed on all components together. 11.1.3 Ancillary channels Channels

13、for teletext (T,T) and time codes LTC (Longitudinal Time Code) and VITC (Vertical Interval Time Code) are not presently envisaged to be used. 11.1.4 Component decoding It is expected that composite sources may feed destinations operating in component modes or in another composite format. Thus, compl

14、ementary decoding as used for PAL to PAL applications is not suited, unless an adequate luminance/chrominance separation is provided, for example by means of comb-filters. STD-ITU-T RECMN J.L-ENGL 3775 m 4862593 Ob32L2 742 m 11.2 Networking requirements 11.2.1 Video inputs Access to the video channe

15、l should be either via a digital interface at the IT-R Recommendation 601 4:2:2 level or via one single composite analogue input. When accessed through a digital interface, the codec should automatically support 625- and 525-line systems. The single composite input should accept PAL and SECAM, and m

16、ust recognize the input standard and automatically decode to 4:2:2 components, The video format should be signalled in the video multiplex. 11.2.2 Video outputs Digital outputs should support both 625- and 525-line systems. The analogue output should be able to deliver on a single connector either P

17、AL or SECAM signals depending on the format of the original signal. Composite coders in the 34-45 Mbits decoders must be protected against wide-bandwidth chrominance signals from component sources. 11.2.3 Insertion Data Signals The Insertion Data Signals (IDS), which identifies the origin of the tra

18、nsmission, is described in EBU Document Tech 3217 (January 1986). In practice however, the information is limited to 8 ASCII characters. This information should not be transmitted over the teletext channel, but should be demodulated an inserted into the supervision channel, in the source identificat

19、ion field. If there is no IDS present in the input signal, then the encoder should transfer its own identification (coder identification field, up to 15 characters) into the source identification. The information recovered at the decoder side should be reinserted according to EBU Document Tech 3217.

20、 11.2.4 Insertion Test Signals (ITS) The ITS signals are defined in Recommendation 5.63 (formerly CMTT 473-5). Their handling should be as described in the Recommendation with the following additions: When the encoder detects the absence of IDS in the incoming composite signal, or in the case of com

21、ponent signal, new ITS should be generated in the encoder and line 22 should be blanked. For 625-line systems, lines 17, 18, 330, 331 and 22 should be carried. The number of test-lines may be limited to 4, provided that the presence of a greater number of testlines in the input signal does not disru

22、pt the coding of the desired four testlines. In this case, line 18 should be discarded and lines 17, 330,33 1 and 22 preserved. - - 11.2.5 Decoder output under fault conditions - In case of absence of video input to the encoder and/or in case of an encoder failure, the decoder should provide black l

23、evel at its video output. In case of interruption of the transmission link, the decoder should initially provide a freeze of the last received video signal, changing to mid-grey or black level after about five seconds. If the fault condition affects the audio only, information should be provided at the monitoring outputs. - -