HOLDEN HN 2493-2008 ADHESIVE - HOT MELT High Softening Point《粘接剂 热熔 高软化温度》.pdf

《HOLDEN HN 2493-2008 ADHESIVE - HOT MELT High Softening Point《粘接剂 热熔 高软化温度》.pdf》由会员分享，可在线阅读，更多相关《HOLDEN HN 2493-2008 ADHESIVE - HOT MELT High Softening Point《粘接剂 热熔 高软化温度》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、ABN 84 006 893 232 GM Holden Limited Engineering Department M ATERI AL SPECI FI CATI O N NUMBER SHEET RELEASE REVISION : HN 2493 1 of 2 June, 2008 NAME: ADHESIVE - HOT MELT, High Softening Point THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPO

2、NSIBLE TO CONFIRM THE DOCUMENT ISSUE DATE IS STILL VALID. FORM : S:EngBusProcessEngMaterialsMatlsAndAppearanceNBRspecific0AdminMgmtStandardFormsMatspec.doc 1. SCOPE: This specification describes a hot melt adhesive with high softening point showing good adhesion to a variety of surfaces including PP

3、, PE, ABS, foams and interior trims. 2. PROPERTIES 2.1 Softening point, ASTM E28 138 C minimum, (ring and ball) 2.2 Solid content, GM9010P 100% 2.3 Specific Gravity 0.9 - 0.95 2.4 Viscosity at 191 C, ASTM D3236 2450 - 12000 cps 2.5 Flash Point, ASTM E502 270 C 2.6 Physical State Solid 2.7 Peel Adhes

4、ion Cohesive Failure 2.8 Odour, GM9832P The material shall not have a noxious odour in solid, heated or cured conditions 3. APPROVAL, INSPECTION AND REJECTION Refer HN 1000, Clauses A and C. 4. HAZARDOUS MATERIALS Refer HN 1000, Clause H. Copyright Holden Limited Provided by IHS under license with H

5、OLDEN Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-ABN 84 006 893 232 GM Holden Limited Engineering Department M ATERI AL SPECI FI CATI O N NUMBER SHEET RELEASE REVISION : HN 2493 2 of 2 June, 2008 NAME: ADHESIVE - HOT MELT, High Softening Point THIS DOCUMENT MU

6、ST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFIRM THE DOCUMENT ISSUE DATE IS STILL VALID. FORM : S:EngBusProcessEngMaterialsMatlsAndAppearanceNBRspecific0AdminMgmtStandardFormsMatspec.doc 5. RESTRICTED AND REPORTABLE SUBSTANCES (i) All substan

7、ces and parts must meet the requirements of GMW3059. (ii) All chemical components present in materials supplied to this specification must comply with Australian NICNAS (National Industrial Chemicals Notification and Assessment Scheme) obligations. 6. APPROVED SUPPLIERS AND MATERIALS Material known

8、to meet the full requirements of this specification: APPROVED SUPPLIER APPROVED MATERIAL 3M Bostik Findley Bostik Findley Jet-melt 3731 H3225 H9446 Prepared by: Y. Zia Copyright Holden Limited Provided by IHS under license with HOLDEN Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-