FORD WSS-M1H954-A-2005 FABRIC LUMINAIRE PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《灯具图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD WSS-M1H954-A-2005 FABRIC LUMINAIRE PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《灯具图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M1H954-A-2005 FABRIC LUMINAIRE PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《灯具图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2005 03 18 Activated N. J. Komatsu Printed copies are uncontrolled Copyright 2005, Ford Global Technologies, Inc. Page 1 of 2 FABRIC, LUMINAIRE PATTERN, WOVEN JACQUARD, WSS-M1H954-A UNLAMINATED 1. SCOPE The material defined by this specificati

2、on is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for use in the 2006 Model Year. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A

3、2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 365 ends/10 c

4、m Weft 165 picks/10 cm 3.2.2 Fabric Weight, +/- 15% tolerance (FLTM BN 106-01) 315 g/m23.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 494-546 dtex f 91-101 (semi-dull) Weft 520-580 dtex f137-152 (air texturized, bright) ENGINEERING MATERIAL SPECIFICATIONW

5、SS-M1H954-APrinted copies are uncontrolled Copyright 2005, Ford Global Technologies, Inc. Page 2 of 2 3.5 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.6 FINISHED OPERATIONS As approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.