FORD ESA-M1A35-C-2013 STEEL SHEET & PLATE 36 000 PSI (248 MPa) YIELD STRENGTH TO BE USED WITH FORD WSS-M99P1111-A (No direct replacement use CBP strategy).pdf

《FORD ESA-M1A35-C-2013 STEEL SHEET & PLATE 36 000 PSI (248 MPa) YIELD STRENGTH TO BE USED WITH FORD WSS-M99P1111-A (No direct replacement use CBP strategy).pdf》由会员分享，可在线阅读，更多相关《FORD ESA-M1A35-C-2013 STEEL SHEET & PLATE 36 000 PSI (248 MPa) YIELD STRENGTH TO BE USED WITH FORD WSS-M99P1111-A (No direct replacement use CBP strategy).pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2013 05 06 N Status No direct replacement, use CBP strategy D. Rhuno, NA 2002 09 25 Revised Updated and renumbered 1971 01 06 Released CAA2-968518 Controlled document at www.MATS Page 1 of 2 Copyright 2013,

2、Ford Global Technologies, Inc. STEEL, SHEET & PLATE 36,000 PSI (248 MPa) ESA-M1A35-C YIELD STRENGTH NOT TO BE USED FOR NEW DESIGN 1. SCOPE This specification defines hot rolled sheet, strip, or plate steel with noted minimum mechanical properties. The steel is a low carbon rimmed or killed steel, pr

3、oduced by open hearth or basic oxygen processes, with subsequent operations controlled to provide necessary mechanical properties and adequate formability. 2. APPLICATION This specification was released originally for material used for frame crossmember applications. 3. REQUIREMENTS 3.1 STANDARD REQ

4、UIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 CHEMICAL COMPOSITION Carbon 0.13 - 0.20 Manganese 0.30 - 0.60 Phosphorus 0.04 max Sulfur 0.05 max Deviations in carbon and mangan

5、ese will be allowed provided mechanical property requirements are met and the total of the % carbon plus 1/6% manganese does not exceed 0.30. 3.3 MECHANICAL PROPERTIES (ASTM E 8) 3.3.1 Tensile Strength, min 50,000 psi (345 MPa) 3.3.2 Yield Strength, min 36,000 psi (248 MPa) 3.3.3 Elongation, min 20

6、% ENGINEERING MATERIAL SPECIFICATION ESA-M1A35-C Page 2 of 2 Copyright 2013, Ford Global Technologies, Inc. 3.4 FABRICATORS RESPONSIBILITY The supplier of fabricated parts or assemblies is responsible for assuring that all steel used for producing applicable parts meets the minimum mechanical property requirements of this specification. Annealing prior or during forming is not permitted without Product Engineering Authorization.