ETSI GSM 04 03-1992 MS - BSS Interface Channel Structures and Access Capabilities《MS-BSS接口 信道结构和接入能力》.pdf

《ETSI GSM 04 03-1992 MS - BSS Interface Channel Structures and Access Capabilities《MS-BSS接口 信道结构和接入能力》.pdf》由会员分享，可在线阅读，更多相关《ETSI GSM 04 03-1992 MS - BSS Interface Channel Structures and Access Capabilities《MS-BSS接口 信道结构和接入能力》.pdf（12页珍藏版）》请在麦多课文档分享上搜索。

1、3i104583 0070489 OTb ETSI/TC SMG Released by : ETSI/PT 12 Release date: February 1992 RELEASE NOTE Recommendation GSM 04.03 MS-BSS Interface : Channel Structures and Access Capabilities Previously distributed version : 3.0.3 (Updated Release 1/90 New Released version February 92 : 3.0.3 (Release 92,

2、 Phase 1) 1 No changes since the previously distributed version. m 3404583 0070490 818 m ETS I -G S M Tech n ica I Specification GSM 04.03 Version 3.0.3 UDC: 621.396.21 Key words: European Digital Cellular Telecommunications System, Global System for Mobile Communications (GSM) MS - BSS Interface: C

3、hannel Structures and Access Capabilities ETSI European Telecommunications Standards Institute ETSI Secretarlat: B.P.152 . F - 06561 Valbonne Cedex . France Tp. + 33 92 94 42 O0 TF. + 33 93 65 47 16 Tx. 47 O0 40 F Previous page is blank Copyright European Telecommunications Standards Institute 1992.

4、 All rights reserved. No part may be reproduced or used except as authorised by contract or other written permission. The copyright and the foregoing restriction on reproduction and use extend to all media in which the information may be embodied. rn 3404583 0070491 754 rn PREFATORY NOTE ETSI has co

5、nstituted stable and consistent documents which give specifications for the implementation of the European Cellular Telecommunications System. Historically, these documents have been identified as “GSM recommendations“. Some of these recommendations may subsequently become Interim European Telecommu

6、nications Standards (I-ETSs) or European Telecommunications Standards (ETSs), whilst some continue with the status of ETSI-GSM Technical Specifications. These ETSI-GSM Technical Specifications are for editorial reasons still referred to as GSM recommendations in some current GSM documents, The numbe

7、ring and version control system is the same for ETSI-GSM Technical Specifications as for “GSM recommendations1. 3404583 0070472 670 ETSI/GSM Release: ETSI - PT 12 Date: February 1992 RECOMMENDATION GSM 04.03 Version 3.0.3 Title : MS-BS interface - Channel structures and access capabilities List of c

8、ontents: 1. 2. 3. 4. 5. 6. Scope Definitions Channel types and their use : traffic channels 3.4 Bm channels 3.5 Lm channels Channel types and their use : control channels BS access capability Channel configurations Language of origin: English Number of pages: 9 m 3404583 0070473 527 m GSM 04.03 - 3.

9、0.3 - page 2 1 2 2.1 2.2 2.3 2.4 2.5 SCOPE This Recommendation defines limited sets of channel types, access capabilities and channel configurations at reference point Um (radio interface). DEFINITIONS A channel represents a specified portion of the information-carrying capacity of an interface. Cha

10、nnels are classified by channel types, which have common characteristics. Channel types appearing on the radio interface are specified in sections 3 and 4. At a given time, the complete interface between a Base Station and the set of Mobile Stations in relation corresponds to some interface structur

11、e. The interface structure may change in time. The number of possible different such interface structures can be large. The BS access capability is a description of all the possible interface structures of the considered BS. BS access capabilities are specified in section 5. At a given moment, the c

12、hannel configuration of a Mobile Station is the interface structure this Mobile Station actually uses to transmit information to or receive information from the Base Station. The channel configuration may change in time. A limited number of channel configurations are identified, and are specified in

13、 section 6. A Mobile Station access capability is the description of the set of its possible channel configurations. MS access capabilities are specified in section 7. 3404583 0070474 463 GSM 04.03 - 3.0.3 - Page 3 3 * 3.1 3.2 CHANNEL TYPES AND THEIR USE: TRAFFIC CHANNELS Traffic channels (TCH) are

14、fixed physical gross rate channels, accompanied with timing. Traffic channels are intended to carry a wide variety of user information streams. A distinguishing characteristic is that traffic channels do not carry signalling information for circuit switching, mobile management or channel configurati

15、on management. This signalling information is carried over other types of channels, e.g. control channels. Traffic channels may be used to provide access to a variety of communication modes within the PLMN and the networks it permits access to. Examples of these modes are : i) circuit switching; and

16、 ii) packet switching, supporting packet-mode terminals. In case i), the PLMN can provide either a transparent connection, or a connection specifically suited to a particular service, such as telephony. In case ii), the traffic channel will carry protocols at layers 2 and 3 according to Recommendati

17、on X.25 or other packet-mode standardised protocols. 3.3 Different types of traffic channels are distinguished by their rates. 3.4 Bm Channel 3.4.1 A Bm channel is a traffic channel able to carry : a 13 kbit/s rate bit stream with an error structure and a transmission delay compatible with some grad

18、e of service, intended to carry voice encoded according to GSM Recommendation series 06; or a bit stream at a rate of 12, 6 or 3.6 kbit/s, with an error structure and a transmission delay adapted to a wider range of services, including data transmission; or other kinds of bit stream adapted to a wid

19、er range of services, including data transmission (for further study). m 3404583 O070495 3TT m GSM 04.03 - 3.0.3 - page 4 3.4.2 User information streams are carried on the Bm channel on a dedicated, alternate (within one call or as separate calls), or simultaneous basis, consistent with the Bm chann

20、el carrying capability. The following are samples of user information streams i) voice encoded at i3 kbit/s according to GSM Recommendation series 06; and ii) data information corresponding to circuit or packet switching user classes of services at bit rates compatible with the channel capability. 3

21、.4.3 In the circuit switching communication mode, a Bm channel is used to provide either a non transparent connection specifically suited to telephony, or to provide a transparent connection. 3.5 Lm Channels 3.5.1 Lm channels are traffic channels with a carrying capability lower than a Bm channel. O

22、nly one kind of Lm channel is defined. Other kinds are possible as future evolution. The remaining of section 3.5 addresses only the unique Lm channel. A Lm channel is a traffic channel able to carry : - some bit stream to be defined with an error structure and a transmission delay compatible with s

23、ome grade of service, intended to carry voice encoded according to a method to be defined in the future as system evolution; - a bit stream at a rate of 6 or 3.6 kbit/s, with an error structure and a transmission delay adapted to a wider range of services, including data transmission; or - other kin

24、ds of bit stream adapted to a wider range of services, including data transmission (for further study). 3.5.2 User information streams are carried on a Lm channel on a dedicated, alternate (within one call or as separate calls), or simultaneous basis, consistent with the Lm channel carrying capabili

25、ty. The following are samples of user information streams i) voice encoded at some rate according to a method to be specified in the future (this is not foreseen to be implemented at system introduction time); and ii) data information corresponding to circuit or packet switching user classes of serv

26、ices at bit rates compatible with the channel capability. 3404583 0070496 236 = GSM 04.03 - 3.0.3 - page 5 4 4.1 4.2 CHANNEL TYPES AND THEIR USE: CONTROL CHANNELS Note : The term “Dm channel“ may be used to refer to the controls channels used by a Mobile Station at a given moment, independently of t

27、heir type. Control channels are used to provide all active Mobile Stations with a continuous frame oriented means of communication across the MS- BS interface. A Mobile Station Channel Configuration contains one or more control channels. These control channels may change in time, with the channel co

28、nfiguration. Access management signalling functions are used to insure the continuity when a change in the control channels occurs. Control channels are classified by control channel types, which have common characteristics. These control channel types are specified in section 4.3. The control chann

29、els are primarily intended to carry signalling information for circuit switching, mobility management and access management. In addition to signalling information control channels may also be used to carry packet-switched data, including those relating to Short Message Services. 4.3 4.3.1 4.3.1.1 4.

30、3.2 4.3.2.1 3404583 0070497 172 = GSM 04.03 - 3.0.3 - page 6 Control channel types Broadcast Control Channel A broadcast control channe (BCCH) is a point-to-multipoint unidirectionnal control channel, from the fixed sub-system to the Mobile Stations. A BCCH is intended to broadcast a variety of info

31、rmations to MSs, including informations necessary for MS to register in the system (e.g. synchronisation data). A BCCH uses a protocol specified in GSM Recommendation Series 04. Common Control Channel A common control channel (CCCH) is a point-to-multipoint bidirectionnal control channel. A CCCH is

32、primarily intended to carry signalling information necessary for access management functions (e.g. allocation of dedicated channels). The CCCH can be used for other signalling purposes. A CCCH uses a layered protocol according to GSM Recommendation Series 04. In particular the multipoint to point ma

33、nagement is achieved through random access techniques. The following terms may be used when the context requires it : - The RACH (Random Access Channel) is the uplink (MS to network) part of the CCCH. - The AGCH (Access Grant Channel) is the part of the downlink (network to MS) part of the CCCH rese

34、rved for assignment messages. - The PCH (Paging Channel) is the remaining part. 3404583 0070498 O09 GSM 04.03 - 3.0.3 - page 7 4.3.3 Dedicated Control Channel 4.3.3.1 A dedicated control channel (DCCH) is a point-to-point bidirectionnal control channel. DCCHs exist with a variety of bit rates. DCCHs

35、 are further classified as follows according to some technical particularities : A SDCCH (Stand-alone DCCH) is a DCCH whose allocation is not linked to the allocation of a TCH. SDCCHs exist with bit rates of 781 107/153, 4600 or 9200 bit/s. A FACCH (Fast Associated DCCH) is a DCCH obtained by preemp

36、tive dynamic multiplexing on respectively a Bm or a Lm channel. The allocation of a FACCH is obviously linked to the allocation of a TCH. The bit rate of a FACCH is 9200 or 4600 bit/s. A SACCH (Slow Associated DCCH) is a DCCH of rate 115/300 or 299/765 kbit/s. A independant SACCH is always allocated

37、 together with a TCH or a SDCCH. The terms Bm, or Bm + ACCHs can be used to refer to a Bm channel together with the corresponding FACCH and the Co-allocated SACCH when the context avoids any ambiguities. Similar remarks apply to the terms Lm, Lm + ACCHs, Lm + Lm, Lm + Lm + ACCHs. The term SDCCH can

38、be used to refer specifically to a SDCCH of bit rate 598/765 kbit/s together with the Co-allocated SACCH when the contexts avoids any ambiguities. 4.3.3.2 The DCCHs use a layered protocol according to GSM Recommendations Series 04 and 05. M 3404583 O070499 T45 M 5 5.1 GSM 04.03 - 3.0.3 - page 8 BS A

39、CCESS CAPABILITY The BS access capability is composed of one BCCH; one CCCH physically related to the BCCH; (O to 3 additional CCCHs; and a global resource. OR: BCCH, CCCH plus 4 SDCCHs and a global resource. The global resource can be used to accomodate i) nl ( Bm + FACCH + SACCH) ii) 2n2 ( Lm + FA

40、CCH + SACCH) iii) n3 ( SDCCH of rate 9200 bit/s + SACCH) iv) 2n4 ( SDCCH of rate 4600 bit/s + SACCH) and v) 8x15 ( SDCCH of rate 598/765 kbit/s + SACCH) with the constraint ni + n2 + n3 + n4 + n5 lower than some value characterising the BS capability. The exact use of the global resource may vary in

41、 time. - 3404583 0070500 597 - 6 6.1 6.2 GSM 04.03 - 3.0.3 - page 9 CHANNEL CONFIGURATIONS At a given moment, a Mobile Station accesses only a limited number of the channels appearing on its radio interface. Different compositions for the accessed channels set are identified, and specified below. Di

42、fferent channel configurations are : i) BCCH ; ii) CCCH ; iii) CCCH + BCCH ; iv) SDCCH + SACCH; v) Bm + FACCH + SACCH; vi) Lm + FACCH + SACCH; vii) Lm + Lm + FACCH + SACCH. Configuration i) is normally used only in the phase when the physical connection is not set (i.e. just after switch-on, or afte

43、r a too.long interruption of the physical connection due to poor propagation conditions). Configurations ii) or iii) are used by active but idle MS. Configurations iv) is used in phases when only a dedicated control channel is needed. Configurations v) to vii) are used in particular when a circuit- switched communication is in progress.