ETSI EN 300 718-1-2018 Avalanche Beacons operating at 457 kHz Transmitter-receiver systems Part 1 Harmonised Standard for access to radio spectrum (V2 1 1).pdf

《ETSI EN 300 718-1-2018 Avalanche Beacons operating at 457 kHz Transmitter-receiver systems Part 1 Harmonised Standard for access to radio spectrum (V2 1 1).pdf》由会员分享，可在线阅读，更多相关《ETSI EN 300 718-1-2018 Avalanche Beacons operating at 457 kHz Transmitter-receiver systems Part 1 Harmonised Standard for access to radio spectrum (V2 1 1).pdf（31页珍藏版）》请在麦多课文档分享上搜索。

1、 ETSI EN 300 718-1 V2.1.1 (2018-01) Avalanche Beacons operating at 457 kHz; Transmitter-receiver systems; Part 1: Harmonised Standard for access to radio spectrum HARMONISED EUROPEAN STANDARD ETSI ETSI EN 300 718-1 V2.1.1 (2018-01) 2 Reference REN/ERM-TG28-512-1 Keywords harmonised standard, radio,

2、testing ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice The present document can be downloaded

3、from: http:/www.etsi.org/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or p

4、erceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to r

5、evision or change of status. Information on the current status of this and other ETSI documents is available at https:/portal.etsi.org/TB/ETSIDeliverableStatus.aspx If you find errors in the present document, please send your comment to one of the following services: https:/portal.etsi.org/People/Co

6、mmiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the writte

7、n authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. ETSI 2018. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTMand the ETSI logo are trademarks of ETSI registered for the benefit of its Members. 3GPPTM and LTE are trademarks of ETSI registered fo

8、r the benefit of its Members and of the 3GPP Organizational Partners. oneM2M logo is protected for the benefit of its Members. GSM and the GSM logo are trademarks registered and owned by the GSM Association. ETSI ETSI EN 300 718-1 V2.1.1 (2018-01) 3 Contents Intellectual Property Rights 5g3Foreword

9、. 5g3Modal verbs terminology 6g31 Scope 7g32 References 7g32.1 Normative references . 7g32.2 Informative references 7g33 Definitions, symbols and abbreviations . 8g33.1 Definitions 8g33.2 Symbols 8g33.3 Abbreviations . 9g34 Technical requirements specifications . 9g34.1 Environmental profile . 9g34.

10、2 Conformance requirements for transmitters . 9g34.2.1 Modulation and carrier keying 9g34.2.1.1 Definition 9g34.2.1.2 Method of measurement 9g34.2.1.3 Limits 9g34.2.2 Frequency error . 10g34.2.2.1 Definition 10g34.2.2.2 Method of measurement 10g34.2.2.3 Limits 10g34.2.3 Output field strength (H-fiel

11、d) 10g34.2.3.1 Definition 10g34.2.3.2 Method of measurement 10g34.2.3.3 Limits 10g34.2.3.3.1 Minimum transmitted field 10g34.2.3.3.2 Maximum transmitted field . 10g34.2.4 Transmitter spurious emissions . 11g34.2.4.1 Definition 11g34.2.4.2 Radiated H-field 11g34.2.4.2.1 Method of measurement ( 1 if f

12、c 4,78 MHz then He= Hm, (i.e. far field). The method allows an electric generated E-field to be measured as a magnetic generated H-field by adding a correction factor derived from (D.6). For a graphical representation of the correction factor, see figure D.1. ETSI ETSI EN 300 718-1 V2.1.1 (2018-01) 29 Figure D.1 -60-50-40-30-20-100100,001 0,01 0,1 1 10 100Correction factorforrelevant H-field, dB Frequency, MHzETSI ETSI EN 300 718-1 V2.1.1 (2018-01) 30 Annex E (informative): Change history Version Information about changes 2.1.1 Receiver sensitivity was added