ECMA 381-2007 Procedure for the Registration of Assigned Numbers for ECMA-368 and ECMA-369《ECMA-368和ECMA-369分配号码登记程序 第1版》.pdf

《ECMA 381-2007 Procedure for the Registration of Assigned Numbers for ECMA-368 and ECMA-369《ECMA-368和ECMA-369分配号码登记程序 第1版》.pdf》由会员分享，可在线阅读，更多相关《ECMA 381-2007 Procedure for the Registration of Assigned Numbers for ECMA-368 and ECMA-369《ECMA-368和ECMA-369分配号码登记程序 第1版》.pdf（11页珍藏版）》请在麦多课文档分享上搜索。

1、 ECMA-381 1stEdition / December 2007 Procedure for the Registration of Assigned Numbers for ECMA-368 and ECMA-369 Ecma International Rue du Rhne 114 CH-1204 Geneva T/F: +41 22 849 6000/01 www.ecma-international.orgStandard ECMA-381 1stEdition / December 2007 Procedure for the Registration of Assigne

2、d Numbers for ECMA-368 and ECMA-369 IW ECMA-381.doc 10/13/2009 9:29:00 AM . Introduction This Ecma Standard specifies the registration procedures for the PHY ID, Specifier ID and Regulatory Domain registers used in ECMA-368 and ECMA-369. Entries in these registers are likely to be added over time. T

3、herefore, these contents are implemented as registers rather than as tables in the base standards. This Ecma Standard has been adopted by the General Assembly of December 2007. Table of contents 1 Scope 1 2 Normative references 1 3 Definitions 1 3.1 bit 1 3.2 string 1 3.3 octet 1 4 International Reg

4、isters 1 4.1 PHY ID 1 4.2 Specifier ID 1 4.3 Regulatory Domain 1 5 Registration authority 2 5.1 Appointment 2 5.2 Duties 2 5.2.1 Maintenance of International Registers 2 5.2.2 Publication of public content of International Registers 2 5.2.3 Inform the requestor of the decision 6 Registration request

5、s 2 7 Registration procedure 8 Withdrawal procedure 9 Amendment procedure 3 10 Appeal procedure 3 - i - 1 Scope This Standard specifies the procedure to be followed by a Registration Authority in preparing, maintaining and publishing International Registers of assigned numbers and associated descrip

6、tions for entries specied in 4, for use with ECMA-368 and ECMA-369. 2 Normative references ECMA-368 High Rate Ultra Wideband PHY and MAC Standard ECMA-369 MAC-PHY Interface Specification for ECMA-368 ISO/IEC 8859-1 Information technology - 8-bit single-byte coded graphic character sets - Part 1: Lat

7、in alphabet No. 1 ISO/IEC JTC 1 Directives, 5thEdition 3 Definitions In addition to the terms defined herein, the terms defined in Annex E of the 5thEdition of the ISO/IEC JTC 1 Directives apply. 3.1 bit binary digit with value ZERO or ONE 3.2 string sequence of at least one and at most 50 character

8、s encoded in ISO/IEC 8859-1 3.3 octet sequence of eight bits 4 International Registers 4.1 PHY ID The PHY ID is one octet that uniquely identifies a specific implementation of the PHY, as specified in Annex B of ECMA-369. Requestors shall specify a unique string for registeration with a PHY ID value

9、. 4.2 Specifier ID The Specifier ID is a two octet value that uniquely identifies the owner of any Specifier ID as specified in Annex C of ECMA-368. Requestors shall specify a unique string for registeration with a Specifier ID value. 4.3 Regulatory Domain The Regulatory Domain Number is a value tha

10、t uniquely identifies a specific regulatory domain, as specified in 16.8.18 of ECMA-368. The Registration Authority shall specify a unique string for each Regulatory Domain Number value as required by regulatory changes. - 1 - 5 Registration authority 5.1 Appointment Ecma International shall be the

11、Registration Authority for the International Registers defined in 4. 5.2 Duties 5.2.1 Maintenance of International Registers The Registration Authority shall maintain the International Registers specified in 4.1 and 4.2 due to Registration as specified in 7, withdrawal (as specified in 8) or amendme

12、nt (as specified in 9) of assigned strings for allocated PHY ID or Specifier ID values. The Registration Authority shall maintain the International Regulatory Domain Register specified in 4.3 if and when regulations so require. 5.2.2 Publication of public content of International Registers The Regis

13、tration Authority shall publish the assigned values and associated descriptions from the International Registers for public access at http:/www.ecma-international.org/publications/standards/Ecma-368.htm at no cost. 5.2.3 Inform the requestor of the decision The Registration Authority shall inform th

14、e requestor of the decision to register, reject, withdraw or amend. 6 Registration requests Using the forms at the International PHY-ID and Specifier-ID Registers, implementers of ECMA-369 and/or ECMA-368 respectively, may request registration of a unique string for a value in the International Regi

15、sters specified in 4.1 and 4.2. 7 Registration procedure The Registration Authority shall: a) Review registration requests as specified in 6; b) Ascertain that registration requests are in accordance with this Standard; c) If required, indicate to the requestor the changes needed to meet the require

16、ments of this Standard; d) Approve or reject the registration request; e) In case of approval, allocate and add the PHY ID and/or the Specifier ID value to the International Registers with the assigned string; f) Inform the requestor of the registration or rejection within 15 business days. 8 Withdr

17、awal procedure The requestor may declare withdrawal of its support for its entry in an International Register by using the form accessible from http:/www.ecma-international.org/publications/standards/Ecma-368.htm, if so desired accompanied with the reason. Withdrawal shall not change the registered

18、string and allocated value in the International Register; the Registration Authority shall mark the entry as withdrawn with the withdrawal date and inform the requestor accordingly. - 2 - - 3 - 9 Amendment procedure The requestor may request amendment of the strings in one of its entries in an Inter

19、national Register by using the form accessible at http:/www.ecma-international.org/publications/standards/Ecma-368.htm. Only when the RA confirms the mistake or in case of name changes, the Registration Authority is permitted to correct the string in the International Registers and shall inform the

20、requestor accordingly. The Registration Authority may periodically query the requestor to validate its assigned entry and amend or withdraw it as needed. 10 Appeal procedure Appeals shall be filed using the form accessible at http:/www.ecma-international.org/publications/standards/Ecma-368.htm within 20 business days of receipt of the decision from the Registration Authority. The Registration Authority shall respond to the appeal within 20 business days after receipt of the appeal.