DLA MS18015 REV C-2009 CATCH CLAMPING AND STRIKE (CONCEALED SPRING TYPE).pdf

《DLA MS18015 REV C-2009 CATCH CLAMPING AND STRIKE (CONCEALED SPRING TYPE).pdf》由会员分享，可在线阅读，更多相关《DLA MS18015 REV C-2009 CATCH CLAMPING AND STRIKE (CONCEALED SPRING TYPE).pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A FSC 5340 DETAIL SPECIFICATION SHEET CATCH, CLAMPING AND STRIKE (CONCEALED SPRING TYPE) This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet.

2、2.906 REF.25 (APPROX)-3 (STRIKE)1.562(SEE NOTE 6)1.938(MOUNTINGDISTANCE)-2 (CATCH)FIGURE 1. -1 CATCH CLAMPING (CATCH AND STRIKE ASSEMBLY) MS18015C 21 JULY 2009 SUPERSEDING MS18015B 19 OCTOBER 1972 INCH-POUND Inactive for new design after 31 July 1997Provided by IHSNot for ResaleNo reproduction or ne

3、tworking permitted without license from IHS-,-,-MS18015C 2 .594.1282 HOLES+ .005- .001.781.562 .0051.125.281.093THRU HOLE+ .004- .001.125.125.406FIGURE 2. -2 CATCH .072.375R .078.625.188.156 .312 .005.1282 HOLES+ .005- .001FIGURE 3. -3 STRIKE Provided by IHSNot for ResaleNo reproduction or networkin

4、g permitted without license from IHS-,-,-MS18015C 3 TABLE I. Part Numbers and Dimensions PART NO. PART IDENTIFICATION MS18015-1 CATCH, CLAMPING (CATCH AND STRIKE ASSEMBLY MS18015-2 CATCH, CLAMPING (WITHOUT STRIKE) MS18015-3 STRIKE, CATCH NOTES: 1. Material: (A) Yoke, Spring Housing Corrosion resisti

5、ng steel per ASTM A666. (B) Springs, Wire, Spring per SAE-AMS-QQ-W-428 and ASTM A228/A228M (springs concealed). (C) All remaining parts Carbon steel per QQ-S-698. 2. Finish. Carbon steel parts Cadmium plate per SAE AMS-QQ-P-416, Type II, Class 2. . 3. Remove all burrs and break all sharp edges. 4. D

6、imensions in inches unless otherwise specified, Tolerances: .015. 5. Tension: Standard spring tension with .125 deflection to 1.562 dimension = 70 pounds. 6. This assembly is made for use on containers with overlapping edges, containers with even mating edges require the use of shims. 7. Ultimate st

7、rength: 300 lbs for strike, 600 lbs for catch. 8. For design feature purposes, this standard takes precedence over documents referenced herein. 9. Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of

8、 the changes. Custodians: Preparing activity: Army - AR DLA IS Navy - OS (Project 5340-2009-017) Review Activities: Army CR, CR4, MI Navy - AS NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-