DLA A-A-59235-2003 COIL RF CHIP FIXED POWER MAGNETICALLY SHIELDED SURFACE MOUNT《表面装磁屏蔽固定功率芯片阻力系数线圈》.pdf

《DLA A-A-59235-2003 COIL RF CHIP FIXED POWER MAGNETICALLY SHIELDED SURFACE MOUNT《表面装磁屏蔽固定功率芯片阻力系数线圈》.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-59235-2003 COIL RF CHIP FIXED POWER MAGNETICALLY SHIELDED SURFACE MOUNT《表面装磁屏蔽固定功率芯片阻力系数线圈》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、INCH-POUND A-A-59235 3 June 2003 COMMERCIAL ITEM DESCRIPTION COIL, RF, CHIP, FIXED, POWER, MAGNETICALLY SHIELDED, SURFACE MOUNT The General Services Administration has authorized the use of this commercial item description (CID) for all federal agencies. 1. SCOPE. This CID covers the general require

2、ments for a radio frequency coil. Coils covered by this CID are intended for commercial/industrial applications. 2. CLASSIFICATION. This CID uses a classification system which is included in the Part Identification Number (PIN) as shown in the following example (see 7.1). AA59235 - 001 CID number Da

3、sh number (see table I) 3. SALIENT CHARACTERISTICS. 3.1 Interface and physical dimensions. Coils supplied to this CID shall be as specified herein. (see figure 1). 3.2. Electrical characteristics. The electrical characteristics shall be as specified in table I. 3.3 Weight. The weight shall be no gre

4、ater than 0.5 gram maximum. 3.4 Operating temperature range. The operating temperature range is 40C to +85C. 3.5 Temperature rise. DC current rating for a 15C rise. 3.6 Altitude. The maximum altitude is 70,000 feet. 3.7 Marking. Inductors supplied to this CID shall be marked with the manufacturers s

5、tandard commercial PIN. Beneficial comments recommendations, additions, deletions, clarifications, etc., and any data which may improve this document should be addressed to: Defense Supply Center, Columbus, ATTN: DSCC-VAT, Post Office Box 3990, Columbus, OH 43216-5000, or telephone (614) 692-0557, o

6、r facsimile (FAX) (614) 692-6939. AMSC N/A FSC 5950 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59235 Dimension Inches mm Dimension Inches mm A B C D E F .175 M

7、ax .260 Max .160 Dia .115 Max .050 .170 4.45 Max 6.60 Max 4.06 Dia 2.92 Max 1.27 4.32 G H I J K L .040 .120 .055 .160 .270 .140 1.02 3.05 1.40 4.06 6.86 3.56 NOTES: 1. Dimensions are in Inches. 2. Metric equivalents (in parenthesis) are listed for general information only. FIGURE 1. Configuration an

8、d dimensions. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59235 TABLE I. Electrical characteristics. CID dash number AA59235- L 20% (H) DCR Max (Ohms) SRF typ (MHz) 001 1.0 .065 130 002 1.5 .070 120 003 2.2 .075 100 004 3.3 .080 70 005 4.7

9、.085 60 006 6.8 .090 50 007 10 .125 45 008 15 .135 35 009 22 .160 25 010 33 .275 20 011 47 .300 17 012 68 .575 14 013 100 1.10 12 014 150 1.40 7 015 220 2.25 7 016 330 2.90 6 017 470 3.60 4 018 680 4.55 3.5 019 1000 8.10 2.5 4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use rec

10、overed materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR). 5. PRODUCT CONFORMANCE PROVISIONS 5.1 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawi

11、ngs, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial market. The Government reserves the right to require proof of such conformance. 5.2 Market acceptance. The following market acceptance criteria are necessary to document the qu

12、ality of the product to be provided under this CID: a. The company producing the item must have been producing a product meeting the requirements of this CID for at least 2 years. b. The company must have sold 1,000 units meeting this CID in the commercial marketplace over the past 2 years. 3 Provid

13、ed by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59235 6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order. 7. NOTES. 7.1 PIN. The PIN should be used for Government purposes to buy commercial products to this

14、CID. See section 2 for PIN format example. 7.2 Commercial and Government Entity (CAGE) code. For ordering purposes, inventory control, and submission of these inductors to DSCC under the Military Parts Control Advisory Group (MPCAG) evaluation program, CAGE code 58536 should be used. 7.3 Ordering da

15、ta. The contract or order should specify the following: a. CID document number, revision, and CID PIN. b. Product conformance provisions. c. Packaging requirements. 7.4 Commercial products. As part of the market analysis and research effort, this CID was coordinated with the following manufacturers

16、of commercial products. At the time of CID preparation and coordination, these manufacturers were known to have commercial products that would meet the requirements of this CID. (NOTE: This information should not be considered as a list of approved manufacturers or be used to restrict procurement to

17、 only the manufacturers shown.) MFRs CAGE MFRs name and address 02113 Coilcraft Inc 1102 Silver Lake Road Cary, Illinois 60013-1658 Phone number (847) 639-2361 Uniform Resource Locator (URL): 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-592

18、35 5 7.5 Part number (P/N) supersession data. This CID supersedes the following manufacturers P/Ns as shown. This information is being provided to assist in reducing proliferation in the government inventory system. TABLE II. P/N supersession data. CID dash number (see table I) AA59235- Vendor comme

19、rcial PIN CAGE 02113 1/ 001 DT1608C-102 002 DT1608C-152 003 DT1608C-222 004 DT1608C-332 005 DT1608C-472 006 DT1608C-682 007 DT1608C-103 008 DT1608C-153 009 DT1608C-223 010 DT1608C-333 011 DT1608C-473 012 DT1608C-683 013 DT1608C-104 014 DT1608C-154 015 DT1608C-224 016 DT1608C-334 017 DT1608C-474 018

20、DT1608C-684 019 DT1608C-105 1/ The manufacturers P/N shall not be used for procurement to the requirements of this CID. At the time of preparation of this CID, the aforementioned commercial products were reviewed and could be replaced by the CID P/N shown. 7.6 Government users. To acquire informatio

21、n on obtaining these inductors from the Government inventory system, contact Defense Supply Center, Columbus, ATTN: DSCC-CPAA, Post Office Box 3990, Columbus, OH 43216-5000, or telephone (614) 692-7741. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - 7FXE Custodians: Navy - EC Preparing Activity: DLA - CC Project 5950-1156 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-