DLA A-A-59122 A-2009 CUPRIC OXIDE TECHNICAL.pdf

《DLA A-A-59122 A-2009 CUPRIC OXIDE TECHNICAL.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-59122 A-2009 CUPRIC OXIDE TECHNICAL.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data that may improve this document should be sent to: STDZNMGTdla.mil or Defense Supply Center Richmond (DSCR), ATTN: DSCR-VEB, 8000 Jefferson Davis Highway, Richmond, VA 23297-5616. Since contact information c

2、an change, you may want to verify the currency of this address information using the ASSIST database at http:/assist.daps.dla.mil. FSC 6810 INCH-POUND A-A-59122A 5 October 2009 SUPERSEDING A-A-59122 29 June 1998 COMMERCIAL ITEM DESCRIPTION CUPRIC OXIDE, TECHNICAL The General Services Administration

3、has authorized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers technical grade cupric oxide for use in ordnance applications. Cupric oxide is typically used as a pyrotechnic component in marine location markers. 2. SALIENT

4、 CHARACTERISTICS 2.1 General. Cupric oxide shall be furnished in powdered form. 2.2 Chemical properties. When tested using the methods and procedures described in ASTM D 280 and in the American Chemical Society (ACS) “Reagent Chemicals: Specifications and Procedures“ (ACS 86-20569), the cupric oxide

5、 produced shall the chemical requirements specified in table I. TABLE I. Chemical requirements. Chemical properties % by weight Limit Test method Assay (CuO)95.0 Minimum ACS (Cupric Oxide, Powdered) Moisture 0.2 Maximum ASTM D 280, Method A Acid insoluble matter 0.5 Maximum ACS (Cupric Oxide, Powder

6、ed) 2.3 Sieve analysis. When sieve analysis is performed in accordance with ASTM B 214, at least 95 percent by weight of any selected cupric oxide test specimen shall pass through Sieve No. 200. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-591

7、22A 2 3. REGULATORY REQUIREMENTS 3.1 Material safety data sheet. Manufacturers shall prepare and submit a material safety data sheet (MSDS) in accordance with FED-STD-313 and meeting the Code of Federal Regulations (CFR) requirements of 29 CFR 1910.1200. 4. PRODUCT CONFORMANCE 4.1 Product conformanc

8、e. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial marketplace. The government reserves the right to require proof o

9、f such conformance. 5. PACKAGING 5.1 Preservation, packing, and marking. Preservation, packing, and marking shall be as specified in the acquisition order (see 6.2(c). 6. NOTES 6.1 Sources of documents. 6.1.1 CFR. The CFR may be obtained from the Superintendent of Documents, P.O. Box 371954, Pittsbu

10、rgh, PA 15250-7954. Electronic copies of CFR documents may be obtained from http:/www.gpoaccess.gov/cfr/. 6.1.2 Federal standards. Copies of federal standards may be obtained from General Services Administration, Federal Supply Service, Specification Section, 470 East LEnfant Plaza SW, Suite 8100, W

11、ashington, DC 20407. Electronic copies of federal standards may be obtained from http:/assist.daps.dla.mil/. 6.1.3 ACS documents. Copies of ACS documents may be obtained from the American Chemical Society, 1155 16th Street NW, Washington, DC 20036. Electronic copies of ACS documents may be obtained

12、from http:/www.acs.org/. 6.1.4 ASTM standards. Copies of ASTM standards may be obtained from ASTM International, 100 Barr Harbor Drive, P.O. Box C700, West Conshohocken, PA 19428-2959. Electronic copies of ASTM standards may be obtained from http:/www.astm.org/. 6.2 Ordering data. The acquisition or

13、der should specify the following information: a. CID document number and revision. b. Quantity required. c. Preservation, packing and marking requirements (see 5.1). Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59122A 3 6.3 National stock numb

14、ers (NSNs). The NSN 6810-01-376-5842 corresponds to this CID. This may not be the only NSN associated with this document. MILITARY INTERESTS: Custodians: Army - AR DLA - GS Preparing Activity: DLA - GS3 (Project 6810-2009-023) NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-