CAN CSA-ISO IEC 14496-5C-2006 Information technology - Coding of audio-visual objects - Part 5 Reference software AMENDMENT 3 Visual new level and tools.pdf

《CAN CSA-ISO IEC 14496-5C-2006 Information technology - Coding of audio-visual objects - Part 5 Reference software AMENDMENT 3 Visual new level and tools.pdf》由会员分享，可在线阅读，更多相关《CAN CSA-ISO IEC 14496-5C-2006 Information technology - Coding of audio-visual objects - Part 5 Reference software AMENDMENT 3 Visual new level and tools.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、 Reference numberISO/IEC 14496-5:2001/Amd.3:2003(E)ISO/IEC 2003INTERNATIONAL STANDARD ISO/IEC14496-5Second edition2001-12-15AMENDMENT 32003-12-01Information technology Coding of audio-visual objects Part 5: Reference software AMENDMENT 3: Visual new level and tools Technologies de linformation Codag

2、e des objets audiovisuels Partie 5: Logiciel de rfrence AMENDEMENT 3: Niveau visuel nouveau et outils Amendment 3:2006 toNational Standard of CanadaCAN/CSA-ISO/IEC 14496-5:06Amendment 3:2003 to Inte rnational Standard ISO/IEC 14496-5:2001 has been adopted withoutmodification (IDT) as Amendment 3:200

3、6 to CAN/CSA-ISO/IEC 14496-5:06. This Amendment was reviewedby the CSA Technical Committee on Information Technology (TCIT) under the jurisdiction of the StrategicSteering Committee on Information Technology and deemed acceptable for use in Canada.December 2006ISO/IEC 14496-5:2001/Amd.3:2003(E) PDF

4、disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, part

5、ies accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative

6、to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO/IEC 20

7、03 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the cou

8、ntry of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org ii ISO/IEC 2003 All rights reservedAmendment 3:2006 toCAN/CSA-ISO/IEC 14496-5:06ISO/IEC 14496-5:2001/Amd.3:2003(E) ISO/IEC 2003 All right

9、s reserved iiiForeword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards

10、through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC,

11、also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to

12、prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibili

13、ty that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying any or all such patent rights. Amendment 3 to ISO/IEC 14496-5:2001 was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommitte

14、e SC 29, Coding of audio, picture, multimedia and hypermedia information. Amendment 3:2006 toCAN/CSA-ISO/IEC 14496-5:06ISO/IEC 14496-5:2001/Amd.3:2003(E) ISO/IEC 2003 All rights reserved 1Information technology Coding of audio-visual objects Part 5: Reference software AMENDMENT 3: Visual new level a

15、nd tools Replace Clause 4 with: “ 4 Visual reference software Location Content video/natural/MoMuSys -1.0-001220_sony Natural video decoder in C video/natural/microsoft -2.3-001213 Natural video decoder in C+ video/snhc/FBA_V2 Face and body animation decoder video/snhc/m3d20010209 3D mesh decoder in

16、tegrated by Samsung video/snhc/Dct DCT-based FAP decodervideo/snhc/Fit FIT decodervideo/snhc/Fit_liu FIT decodervideo/snhc/Ist/codec FAP decoder video/snhc/Mesh2D Dynamic 2D mesh geometry and motion decoding video/snhc/rockwell_epfl_v18 FAP decoder video/snhc/rockwell_vds2 View-dependent texture dec

17、oding with back channel video/natural/microsoftvtc-update Visual Texture encoder in C+ ” Amendment 3:2006 toCAN/CSA-ISO/IEC 14496-5:06ISO/IEC 14496-5:2001/Amd.3:2003(E) 2 ISO/IEC 2003 All rights reservedReplace A.2 with: “ A.2 Visual encoding software Location Content video/natural/MoMuSys -1.0-0012

18、20_sony Natural video encoder in C video/natural/microsoft -2.3-001213 Natural video encoder in C+ video/snhc/FBA_V2 Face and body animation encoder by EPFL video/snhc/m3d20010209 3D mesh encoder integrated by Samsung video/snhc/DCT DCT-based FAP encoder video/snhc/FIT FIT encodervideo/snhc/fit_liu

19、FIT encodervideo/snhc/IST/codec FAP encoder video/snhc/Mesh2D Dynamic 2D mesh geometry and motion encoding video/snhc/rockwell_epfl_v18 FAP encoder video/snhc/rockwell_vds2 View-dependent texture encoding with back channel video/natural/microsoftvtc-update Visual Texture encoder in C+ ” Amendment 3:

20、2006 toCAN/CSA-ISO/IEC 14496-5:06ISO/IEC 14496-5:2001/Amd.3:2003(E) ICS 35.040 ISO/IEC 2003 All rights reserved Copyright Notice This Amendment to the International Standard contains information copyright protected by the International Organization for Standardization (ISO) and the International Ele

21、ctrotechnical Commission (IEC). Except as permitted under the laws of Canada, no extract of this Amendment to the International Standard may be reproduced, stored in any retrieval system, or transmitted in any form or by any means, electronic, photocopying, recording, or otherwise, without prior per

22、mission from the Stan dards Council of Canada (SCC). Requests for permission to reproduce this Amendment to the International Standard or parts thereof should be addressed to Manager, Technical Document Centre Standards Council of Canada 270 Albert Street, Suite 200 Ottawa, Ontario K1P 6N7 The Canad

23、ian adoption of this Amendment to the International Standard contains information copyright protected by the Canadian Standards Association. All rights reserved. No part of this adopted Amendment may be reproduced in any form whatsoever without the prior permission of the publisher. ISO/IEC material

24、 is reprinted with permission. Requests for permission to reproduce this adopted Amendment or parts thereof should be addressed to Director, Information Products Canadian Standards Association 5060 Spectrum Way, Suite 100 Mississauga, Ontario L4W 5N6 Copyright violators will be prosecuted to the full extent of the law. PRINTEDIN CANADAIMPRIMEAU CANADA