ITU-R BT 1737-2005 Use of the ITU-T Recommendation H 264 (MPEG-4 AVC) video source-coding method to transport high definition TV programme material《使用ITU-T建议 H 264(MPEG-4 AVC)视频安全-.pdf

《ITU-R BT 1737-2005 Use of the ITU-T Recommendation H 264 (MPEG-4 AVC) video source-coding method to transport high definition TV programme material《使用ITU-T建议 H 264(MPEG-4 AVC)视频安全-.pdf》由会员分享，可在线阅读，更多相关《ITU-R BT 1737-2005 Use of the ITU-T Recommendation H 264 (MPEG-4 AVC) video source-coding method to transport high definition TV programme material《使用ITU-T建议 H 264(MPEG-4 AVC)视频安全-.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、 Rec. ITU-R BT.1737 1 RECOMMENDATION ITU-R BT.1737 Use of the ITU-T Recommendation H.264 (MPEG-4/AVC) video source-coding method to transport high definition TV programme material (Question ITU-R 12/6) (2005) Scope This Recommendation specifies the use of the video source-coding method as per ITU-T

2、Recommendation H.264 (ISO/IEC standard 14496-10), also known as MPEG-4/AVC, for the transport of high definition TV (HDTV) programme material for a variety of broadcasting applications. The ITU Radiocommunication Assembly, considering a) that there are applications where it is desired to transport H

3、DTV programme material in a virtually transparent fashion, i.e. introducing minimal visible artefacts, using a reduced bit rate; b) that Recommendation ITU-R BT.709 Part 2 specifies the parameters for a family of HDTV video systems based on the use of a common image format of 1 080 active lines (int

4、erlaced and progressive) and 1 920 pixels per active line; c) that ITU-T Recommendation H.2641specifies the algorithms for the advanced bit rate reduction coding method; d) that the ITU-T Recommendation H.264 specifications are applicable to a variety of video systems, and they are increasingly used

5、 for various applications, recommends 1 that when it is necessary to transport HDTV programme material in a virtually transparent fashion using a reduced bit rate, the 1 080 1 920 HDTV signal of Recommendation ITU-R BT.709 Part 2 (interlaced or progressive) should be source-coded in ITU-T Recommenda

6、tion H.264, down to the bit rate available in the channel, with the parameters of levels 4 and 4.2 (the informative Appendix 1 provides an indication of the source-coding parameters and minimal tools for various members of the image systems in Recommendation ITU-R BT.709 Part 2; it also provides an

7、indication of the bit rate for transport of the programme material so coded); 2 that, if the available bit rate is particularly low, the HDTV signal may be horizontally downsampled to 1 440 samples per active line prior to source coding. NOTE 1 Recommendation ITU-T H.264 is available in electronic f

8、orm at the following address: http:/www.itu.int/md/R03-SG06-C-0225/en. 1ISO/IEC Standard 14496-10, commonly called MPEG-4/AVC. 2 Rec. ITU-R BT.1737 Annex 1 Example parameters and minimal tools to source-code various members of the image systems in Recommendation ITU-R BT.709 using ITU-T Recommendati

9、on H.264 This Annex shows example parameters and tools of the ITU-T Recommendation H.264 source-coding method that would be used to compress various members of the image systems specified in Recommendation ITU-R BT.709, Part 2. It also provides an indication of the bit rates for the transport of tho

10、se signals when so source coded. TABLE 1 Example parameters of ITU-T Recommendation H.264 source-coding for HDTV Rec. ITU-R BT.709 family member Level Profile Application Bit rate (Mbit/s) 4 High 4:2:2 Contribution 20-30(1)4 High 4:2:2 Distribution 16-20 4 High 10 SNG 10-15(1)1 920 1 080 60/50i 1 92

11、0 1 080 24/25/30p4 High Emission 8-12 4.2 High 4:2:2 Contribution 30-40(1)4.2 High 4:2:2 Distribution 25-30(1)4.2 High 10 SNG TBD 1 920 1 080 60/50p 4.2 High Emission TBD (1)Bit rate indicated is tentative. TABLE 2 Profiles and suggested coding tools Coding tools High High 10 High 4:2:2 High 4:4:4 M

12、ain profile tools X X X X 4:2:0 chroma format X X X X 8-bit sample bit depth X X X X 8 8 vs. 4 4 transform adaptivity X X X X Quantization scaling matrices X X X X Separate Cband CrQP control X X X X Monochrome video format X X X X 9- and 10-bit sample bit depth X X X 4:2:2 chroma format X X 11- and

13、 12-bit sample bit depth X 4:4:4 chroma format X Residual colour transform TBD Predictive lossless coding TBD Rec. ITU-R BT.1737 3 Annex 2 Sullivan 2004 ITU-T Recommendation H.264/MPEG-4 (Part 10) Advanced Video Coding (commonly referred to as H.264/AVC) is the newest entry in the series of internat

14、ional video coding standards. It is currently the most powerful and state-of-the-art standard, and was developed by a Joint Video Team (JVT) consisting of experts from ITU-Ts Video Coding Experts Group (VCEG) and ISO/IECs Moving Picture Experts Group (MPEG). As has been the case with past standards,

15、 its design provides the most current balance between coding efficiency, implementation complexity and cost, based on the current state of VLSI design technology (CPUs, DSPs, ASICs, FPGAs, etc.). In the process, a standard was created that improved coding efficiency by a factor of about two minimum

16、(on average) over MPEG-2 while keeping the cost within an acceptable range. In July 2004, a new amendment was added to this standard, called the Fidelity Range Extensions (FRExt, Amendment 1), which demonstrates even higher coding efficiency against MPEG-2, potentially attaining as much as 3:1 for s

17、ome key applications. While having a broad range of applications, the initial H.264/AVC standard (as it was completed in May 2003), was primarily focused on “entertainment-quality” video, based on 8-bits/sample, and 4:2:0 chroma sampling. Given its time constraints, it did not include support for us

18、e in the most demanding professional environments, and the design had not been focused on the highest video resolutions. For applications such as programme contribution, programme distribution, and studio editing and post-processing, it may be necessary to: use more than 8 bits per sample of source

19、video accuracy; use a higher resolution for colour representation than is typical in consumer applications (i.e. to use 4:2:2 or 4:4:4 sampling as opposed to 4:2:0 chroma sampling format); perform source editing functions such as alpha blending (a process for blending of multiple video scenes, best

20、known for use in weather reporting where it is used to key video of a newscaster over video of a map or weather-radar scene); use very high bit rates; use very high resolution; achieve very high fidelity even representing some parts of the video losslessly; avoid colour-space transformation rounding

21、 error; use red, green and blue (RGB) colour representation. The FRExt project produced a suite of four new profiles collectively called the high profiles: 1) the high profile (HP), supporting 8-bit video with 4:2:0 sampling, addressing high-end consumer use and other applications using high-resolut

22、ion video without a need for extended chroma formats or extended sample accuracy; 2) the High 10 Profile (Hi10P), supporting 4:2:0 video with up to 10 bits of representation accuracy per sample; 3) the High 4:2:2 Profile (H422P), supporting up to 4:2:2 chroma sampling and up to 10 bits per sample, a

23、nd 4) the High 4:4:4 Profile (H444P), supporting up to 4:4:4 chroma sampling, up to 12 bits per sample, and additionally supporting efficient lossless coding and an integer residual colour transform for coding RGB video while avoiding colour-space transformation errors. 4 Rec. ITU-R BT.1737 As FRExt

24、 is still rather new, and as some of the benefits of FRExt are perceptual rather than objective, it is somewhat more difficult to measure its capability. One relevant data point is the result of a subjective quality evaluation done by the Blu-ray Disc Association (BDA). The summary results are repro

25、duced in Fig. 1 below from the test report referenced in Wedi and Kashiwagi, 2004. This test, conducted on a 24 frame/s film program with 1 920 1 080 progressive-scanning, shows the following nominal results (which should not be considered rigorously statistically proven): The High Profile of FRExt

26、produced nominally better video quality than MPEG-2 when using only one third as many bits (8 Mbit/s versus 24 Mbit/s). The High Profile of FRExt produced nominally transparent (i.e. difficult to distinguish from the original video without compression) video quality at only 16 Mbit/s. The quality ba

27、r (3.0), considered adequate for use on high-definition packaged media in this organization, was significantly surpassed using only 8 Mbit/s. Again, there were sub-optimalities in the H.264/AVC coding method used in these tests. Thus, the bit rate can likely be reduced significantly below 8 Mbit/s w

28、hile remaining above the 3.0 quality bar establishing a quality sufficient to call it “acceptable HD” in that demanding application. FIGURE 1 Comparison of MPEG-2 to H.264 The result of an example objective (PSNR) comparison test performed by FastVDO2is shown in Fig. 2. These objective results confi

29、rm the strong performance of the high profile. (Again, sub-optimal uses of B frames make the plotted performance conservative for FRExt.) 2FastVDO is a company specializing in technology for media communications and infrastructure software. It is located in Columbia, MD, USA. Rec. ITU-R BT.1737 5 FI

30、GURE 2 PSNR comparison References SULLIVAN, G.J., TOPIWALA, P. and LUTHRA, A. August, 2004 The H.264/AVC Advanced Video Coding Standard: Overview and Introduction to the Fidelity Range Extensions. Presented at the SPIE Conference on Applications of Digital Image Processing XXVII, Special Session on Advances in the New Emerging Standard: H.264/AVC. WEDI, T. and KASHIWAGI, Y. July 2004 Subjective quality evaluation of H.264/AVC FRExt for HD movie content. Joint Video Team document JVT-L033.