INTERN CEMS DT-INDEX-2008 Index of DT Test Methods《DT试验方法的索引》.pdf

《INTERN CEMS DT-INDEX-2008 Index of DT Test Methods《DT试验方法的索引》.pdf》由会员分享，可在线阅读，更多相关《INTERN CEMS DT-INDEX-2008 Index of DT Test Methods《DT试验方法的索引》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、This document is restricted and may not be sent outside Navistar, Inc. or reproduced without permission from Corporate Technical Standards. NAVISTAR, INC. CEMS (CORPORATE ENGINEERING MATERIAL SPECIFICATION)NUMBER: CEMS-DT-Index TITLE: Index of DT Test Methods CURRENT ISSUE DATE: June 2008 WRITTEN/RE

2、VIEWED BY: Materials Engineering APPROVED BY: Materials Engineering SUPERSEDES ISSUE OF: October 2007 PRINTED COPIES OF THIS DOCUMENT MUST BE VERIFIED FOR CURRENT REVISION This specification may involve hazardous materials, equipment, and procedures. This specification does not purport to address al

3、l of the safety issues associated with its use. The user is responsible to consult appropriate safety and health practices and to determine the applicability of regulatory limits prior to use. Change Notice: Replaced “International Truck and Engine Corporation” with “Navistar, Inc.” per corporate di

4、rective; Revised DT-12. Index of DT Test Methods Spec Number TITLE DATE AuthorCEMS-DT-1 Low Temperature Brittleness of Elastomers October 2001 Materials EngineeringCEMS-DT-2 Flame Resistance Test October 2001 Materials EngineeringCEMS-DT-3 Methods of Determining Glass and PTFE in Thermoplastic Ureth

5、ane October 2001 Materials EngineeringCEMS-DT-4 Impact Test For Plastics October 2007 Materials EngineeringCEMS-DT-6 Fluid Immersion Properties of O-Rings October 2001 Materials EngineeringCEMS-DT-7 Method for Determining Hardness of Seal Materials October 2001 Materials EngineeringCEMS-DT-8 Glass C

6、ontent of Reinforced Plastics December 2004 Materials EngineeringCEMS-DT-9 Cold Leak Test of Hose Assemblies October 2001 Materials EngineeringCEMS-DT-10 Rubbing Wear Test for Interior Components October 2001 Materials EngineeringCEMS-DT-11 Heat Stability of Thermoplastic Trim Materials October 2001

7、 Materials EngineeringCEMS-DT-12 Colorfastness to Cleaning and Chemicals June 2008 Materials EngineeringCEMS-DT-14 Surface Waviness Definition via Loria Analyzer April 2001 Materials EngineeringOBSOLETE DT Test Methods Spec Number TITLE Replaced by:CEMS-DT-5 Flammability of Materials FMVSS 302; SAE

8、J369 CEMS-DT-13 Acoustic Decoupler, Bulk Stiffness No replacement. Suppliers are required to assume all patent liability. 2008 by Navistar, Inc. JUNE 2008 Page 1 of 1 Copyright Navistar International Corporation Provided by IHS under license with INTERNNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-