FORD WSS-M1H1066-A-2011 FABRIC HEXAGON WARP KNIT LAMINATED ROLLER EMBOSSED TO BE USED WITH FORD WSS-M99P1111-A 《六角形经纱编织的层压滚筒轧花织物 与福特WSS-M99P1111-A 一起使用》.pdf

《FORD WSS-M1H1066-A-2011 FABRIC HEXAGON WARP KNIT LAMINATED ROLLER EMBOSSED TO BE USED WITH FORD WSS-M99P1111-A 《六角形经纱编织的层压滚筒轧花织物 与福特WSS-M99P1111-A 一起使用》.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M1H1066-A-2011 FABRIC HEXAGON WARP KNIT LAMINATED ROLLER EMBOSSED TO BE USED WITH FORD WSS-M99P1111-A 《六角形经纱编织的层压滚筒轧花织物 与福特WSS-M99P1111-A 一起使用》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions 2011 06 17 Activated Mark Montgomery, FoEPrinted copies are uncontrolled Copyright 2011, Ford Global Technologies, LLC Page 1 of 2 FABRIC, HEXAGON , WARP KNIT , WSS-M1H1066-A LAMINATED, ROLLER EMBOSSED 1. SCOPE The material defined by this sp

2、ecification is a flat warp knit polyester fabric, laminated with foam and scrim, with a roller embossed pattern called HEXAGON. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for B232 2012MY Fabric developed using a Tri-Laminate construction wi

3、th no back coating. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable for commercial vehicle application. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform t

4、o the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Wales 110 Wales /10 cm Courses 240 Courses /10 cm 3.2.2 Fabric Weight, +/- 10% tolerance (FLTM BN 106-01) Fabric Face 265 g/m 3.3 COMPOSITION (A

5、STM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Face 110 dtex f36 (Polyester, semi-dull, FT texturized, round section) ENGINEERING MATERIAL SPECIFICATION WSS-M1H1066-A Printed copies are uncontrolled Copyright 2011, Ford Global Technologies, LLC Page 2 of 2 Middle 110 dtex f36 (

6、Polyester, semi-dull, FT texturized, round section Back 110 dtex f36 (Polyester, semi-dull, FT texturized, round section 3.5 METHOD OF DYEING piece dyed 3.6 FINISHING OPERATION - preset - Dye - Heatset - flame lamination - roller emboss As approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.