FORD WSD-M3P35-A3-2004 PHOSPHATE COATING ZINC IRON OILED TO BE USED WITH FORD WSS-M99P1111-A 《涂油的锌铁磷酸盐涂层 与标准FORD WSS-M99P1111-A一起使用 列于标准WSD-M3P35-A1上》.pdf

《FORD WSD-M3P35-A3-2004 PHOSPHATE COATING ZINC IRON OILED TO BE USED WITH FORD WSS-M99P1111-A 《涂油的锌铁磷酸盐涂层 与标准FORD WSS-M99P1111-A一起使用 列于标准WSD-M3P35-A1上》.pdf》由会员分享，可在线阅读，更多相关《FORD WSD-M3P35-A3-2004 PHOSPHATE COATING ZINC IRON OILED TO BE USED WITH FORD WSS-M99P1111-A 《涂油的锌铁磷酸盐涂层 与标准FORD WSS-M99P1111-A一起使用 列于标准WSD-M3P35-A1上》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2004 05 27 Revised 3.4 note added; A1 through A4 active M. Ward 2004 01 28 Revised Made WSD-M3P35-A1/A2 N-Status; see Material Engineer for replacement B. Burnside 1992 01 30 C10189636 Released Printed copies are uncontrolled Copyright 2004, F

2、ord Global Technologies, LLC Page 1 of 1 PHOSPHATE COATING, ZINC IRON, AS COATED WSD-M3P35-A1 PHOSPHATE COATING, MANGANESE IRON, AS COATED WSD-M3P35-A2 PHOSPHATE COATING, ZINC IRON, OILED WSD-M3P35-A3 PHOSPHATE COATING, MANGANESE IRON, OILED WSD-M3P35-A4 1. SCOPE These specifications define the requ

3、irements of a heavyweight phosphate coating applied to iron or steel parts. 2. APPLICATION The phosphate coat is intended to form a base for subsequent bonding for adhesion or oil for corrosion resistance applications. As phosphated (i.e. no subsequent treatment) is generally required for rubber bon

4、ding applications. Moderate corrosion resistance, particularly on components not exposed to weathering, is obtained when finished with oil. 3. GENERAL REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requireme

5、nts For Production Materials (WSS-M99P1111-A). 3.2 COATING WEIGHT 10 - 20 g/m2(FLTM AQ 101-03)Lower coating weights may be acceptable in certain bonding applications and will be part of the Control Plan. 3.3 ADHESION - SCRATCH TEST There shall be no chipping away of the coating upon scratching with

6、a knife blade held at 90 to the surface. 3.4 SALT SPRAY RESISTANCE (ASTM B 117) The parts shall not exhibit any corrosion after salt spray testing as follows: WSD-M3P35-A3 Oiled 24 h WSD-M3P35-A4 Oiled 24 h Note: Oil used shall conform to appropriate health and safety requirements. Note: Chromate rinse treatments to enhance corrosion shall not be used.