FORD M2C132-A-2009 OIL LUBRICATING ALL PURPOSE EXTREME PRESSURE《通用极压润滑油》.pdf

《FORD M2C132-A-2009 OIL LUBRICATING ALL PURPOSE EXTREME PRESSURE《通用极压润滑油》.pdf》由会员分享，可在线阅读，更多相关《FORD M2C132-A-2009 OIL LUBRICATING ALL PURPOSE EXTREME PRESSURE《通用极压润滑油》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 NON-PRODUCTION MATERIAL SPECIFICATION Material Name Specification Number Date Action Changes 2009 04 14 N-STATUS No Replacement Named L. Sinclair, FNA 1991 12 01 Page 1 of 2 OIL, LUBRICATING, ALL PURPOSE, EXTREME PRESSURE M2C132-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE: The material defined by this

2、 standard is nonleaded, extreme pressure, mist, way and gear lubricant of mineral oil base, with controlled seal conditioning characteristics, and containing a fog depressant. 2. APPLICATION: This material is used as a general purpose lubricating oil for use in gear heads, reduction drive units, lig

3、ht and heavy ways, centralized lubrication systems, and oil mist applications. 3. REQUIREMENTS: 3.1 VISCOSITY: At 40 C (ASTM D 445) 97-119 cSt 3.2 FLASH POINT: (ASTM D 92) 165 C min 3.3 FIRE POINT: (ASTM D 92) 188 C min 3.4 POUR POINT: (ASTM D 97) -17.8 C max 3.5 FALEX E.P. TEST: (FLTM BJ 1-1) 1500

4、lbs min 3.6 TIMKEN E.P. TEST: (FLTM BJ 1-2) 35 lbs min 3.7 RESISTANCE TO FOAMING: No Surface Foam (ASTM D 892 Alternate at 23.9 C after 5 minutes standing) 3.8 RUST PREVENTIVE CHARACTERISTICS: No Rust (ASTM D 665, Method A) 3.9 COPPER STRIP CORROSION: (ASTM D 130) 2 b max NON-PRODUCTION MATERIAL SPE

5、CIFICATION M2C132-A Page 2 of 2 3.10 ANTISTICK SLIP: 0.85 max (Cincinnati Milling (Certification) Machine Co. Stick-Slip Test) 3.11 MISTABILITY: A Rating - Less than 10% (Norgren Standard Test Stray Fog (Certification) Procedure No.8 low capacity unheated air or oil) 3.12 RECOVERED SAPONIFIABLES: 2.

6、5 - 5.0% 3.13 CHANGE IN SEAL PROPERTIES: 1% - 8% Volume Change (ASTM D 471, Goshen GRC 27-20 “0“ Rings, Compound 1457, 70 hours at 82 C) 4. STANDARD PARAGRAPHS: The following standard paragraphs as defined in Manufacturing Standard MCX, are herewith made a part of this standard: A8, C1, P1, P2, P3, R1, R2.