FORD ESK-M99J326-A-2005 MARKING INK TO BE USED WITH FORD WSS-M99P1111-A 《标记墨水 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD ESK-M99J326-A-2005 MARKING INK TO BE USED WITH FORD WSS-M99P1111-A 《标记墨水 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD ESK-M99J326-A-2005 MARKING INK TO BE USED WITH FORD WSS-M99P1111-A 《标记墨水 与标准FORD WSS-M99P1111-A一起使用 》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2005 08 30 Revised Inserted 3.0; Revised 3.6, Deleted 3.7 and 4 1994 12 20 Revised & Retyped Was 3 pages 1984 11 15 Released SM/EQ 5495 TP Printed copies are uncontrolled Copyright 2005, Ford Global Technologies, LLC Page 1 of 1 MARKING INK ES

2、K-M99J326-A 1. SCOPE The material defined by this specification is a fast drying marking ink. 2. APPLICATION This specification was originally released for material which is used as a paint marker for identification of steel parts. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS M

3、aterial suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1 COLOR As indicated on drawing. 3.2 ADHESION Adequate adhesion to degreased steel. 3.3 FLASH POINT The flash point shall conform to the safety regulations applicable

4、to the plant and/or country where the material shall be used. 3.4 HIDING POWER One application by marking ink pen to degreased steel shall adequately hide the substrate. 3.5 DRYING TIME Tackfree: After maximum 1 minute at room temperature. 3.6 SUBSTANCE CONTROL Legal, health, safety and environmental constraints may apply to the materials which are submitted for approval to this specification. Refer to Engineering Material Specification WSS-M99P9999-A1.