ETSI ETS 300 154-1994 Terminal Equipment (TE) Terminal Characteristics for the Telematic File Transfer within the Teletex Service《终端设备(TE) 电传业务中的远程文件传输的终端特性 ITU-T建议T 571 修正本》.pdf

《ETSI ETS 300 154-1994 Terminal Equipment (TE) Terminal Characteristics for the Telematic File Transfer within the Teletex Service《终端设备(TE) 电传业务中的远程文件传输的终端特性 ITU-T建议T 571 修正本》.pdf》由会员分享，可在线阅读，更多相关《ETSI ETS 300 154-1994 Terminal Equipment (TE) Terminal Characteristics for the Telematic File Transfer within the Teletex Service《终端设备(TE) 电传业务中的远程文件传输的终端特性 ITU-T建议T 571 修正本》.pdf（4页珍藏版）》请在麦多课文档分享上搜索。

1、ETS 300 154 February 1994 Source: ETSI TC-TE Reference: TfTE 07-09 UDC: 621.39 Key words: Terminal Equipment, teletex, facsimile Group 4, telematic file transfer Terminal Equipment (TE); Terminal characteristics for the telematic file transfer within the teletex service ITU-T Recommendation T.571 (m

2、odified11 ETSI European Telecommunications Standards Institute ETSI Secretariat Postal address: 06921 Sophia Antipolis Cedex - FRANCE Office address: Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE Tel.: + 33 92 94 42 O0 - Fax: + 33 93 65 47 16 European Telecommunications Standards InstitL

3、:Q 1994. All rights reserved. No part may be reproduced except as authorised by written permission. The copyright and the foregoing restriction on reproduction extend to all media in which the information may be embodied. 3404583 O101084 33T Page 2 ETS 300 154:1994 Foreword This European Telecommuni

4、cation Standard (ETS) has been produced by the Terminal Equipment (TE) Technical Committee of the European Telecommunications Standards Institute (ETSI). ITU-T Recommendation T.571 11 I (“Terminal characteristics for the telematic file transfer within the Teletex service“) indicates the telematic fi

5、le transfer for facsimile Group A as for further study. Within the ETSI environment, the use of this ETS also applies to the facsimile Group 4 service, since the telematic protocol used for the telematic file transfer is identical for Teletex and the facsimile Group 4 service. Since the telematic fi

6、le transfer is used in the scope of ITU-T Recommendation T.571 ll, all ETSs relevant to the telematic services, Teletex and facsimile Group 4, may be considered in conjunction with this ETS. These include: ETS 300 O1 5 “Terminal Equipment (TE); Basic and recommended additional requirements for termi

7、nal equipment supporting Teletex application“. ETS 300 017 ETS 300 081 “Terminal Equipment (TE); Test procedures for Teletex“. “Integrated Services Digital Network (ISDN); Teletex end-to-end protocol over the ISDN“. ETS 300 087 “Integrated Services Digital Network (ISDN); Facsimile group 4 class 1 e

8、quipment on the ISDN, Functional specification of the equipment“. ETS 300 112 “Integrated Services Digital Network (ISDN); Facsimile group 4 class 1 equipment on the ISDN, End-to-end protocols“. ETS 300 155 “Integrated Services Digital Network (ISDN); Facsimile group 4 class 1 equipment on the ISDN,

9、 End-to-end protocol tests (Interconnection capability testing)“. ETS 300 280 “Terminal Equipment (TE); Facsimile group 4 class 1 equipment on the Integrated Services Digital Network (ISDN), Terminal testing“. ETR 052 “Terminal Equipment (TE); Service intercommunication requirements for Teletex term

10、inal equipment“. Endorsement Notice ITU-T Recommendation T.571 111 defines the general rules required for the implementation of the telematic file transfer for Teletex or facsimile Group 4 application. The text of ITU-T Recommendation T.571 (1993) l is proposed, by ETSI as an ETS with the agreed com

11、mon modifications as indicated by a vertical line in the left margin of the text. 3404583 OLOL085 2b = I Normative references Page 3 ETS 300 154: 1994 This ETS incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate plac

12、es in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this ETS only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies

13、. ITU-T Recommendation T.571 (1 993): “Terminal characteristics for the telematic file transfer within the teletex service“. Common modifications 1) Delete the scope in ITU-T Recommendation T.571 111 and insert the following text as the scope for this ETS: I “1 Scope This ETS contains the technical

14、description for implementing the functionalities necessary for the telematic file transfer. The ETS is based on ITU-T Recommendation T.571 Ill. The description of the service requirements can be found in CCITT Recommendation F.551 I81. The objective is to allow the transmission of data files using t

15、he telematic file transfer possibilities with or without additional information concerning the file to be transmitted“. 2) Add the following normative reference to Clause 2 (Normative references): CCllT Recommendation F. 184 (1 992): “Operational provisions for international facsimile service betwee

16、n subscriber stations with group 4 machines (telefax 4)“.“ 3) Replace subclause 3.1 (Basic Transfer Mode) with the following text: I “3.1 Basic Transfer Mode It provides the user of a telematic equipment (Teletex or facsimile Group 4 apparatus) with a means to exchange files of any kind (binary file

17、s, word-processor native format documents, bitmaps, .I without additional information.“ 4) Amend the second, and last, sentence of subclause 3.2 (Document Transfer Mode) to read: I “In the Teletex and Group 4 facsimile environment the DTM is merged to the BTM feature.“ 5) Amend bullet points a) and

18、b) of subclause 5.2 (Protocol aspects) to read as follows: “a) The telematic file transfer for Teletex and Group 4 facsimile equipments is based on the 1 CCITT Recommendation T.62 session. b) Teletex or Group 4 facsimile equipments may negotiate one or more of the features mentioned above. The mecha

19、nism used is the same as the one used for the private mode negotiation (.e. CDCL Command Document Capability List1 or RDCLP Response Document Capability List Positivel).“ Amend the first sentence of subclause 9.1.1 (Parameters used in CDCLmDCLP) to read: 6) “The parameters described below (figure 1) allow the negotiation of tL capabliitieq bztween Teletex I and/or facsimile Group 4 equipments.“ 3404583 OLOLOBb LO2 = February 1994 Page 4 ETS 300 154: 1994 First Edition Document history