ETSI ES 202 912-4-2003 Access and Terminals (AT) Short Message Service (SMS) for PSTN ISDN Test Suites for SMS User Based Solution Part 4 Protocol Implementation Conformance Statem.pdf

《ETSI ES 202 912-4-2003 Access and Terminals (AT) Short Message Service (SMS) for PSTN ISDN Test Suites for SMS User Based Solution Part 4 Protocol Implementation Conformance Statem.pdf》由会员分享，可在线阅读，更多相关《ETSI ES 202 912-4-2003 Access and Terminals (AT) Short Message Service (SMS) for PSTN ISDN Test Suites for SMS User Based Solution Part 4 Protocol Implementation Conformance Statem.pdf（24页珍藏版）》请在麦多课文档分享上搜索。

1、- c PLEASE NOTE This document is normally accompanied by a disk/dish wnen purchased in hardcopy. The dislddisks contain information which would be of no value as a hardcopy document. If you require a copy of the diskldisb, please use the contact information below for your request. When submitting yo

2、ur request, please have the following irzfonnation vuiizble: Your company name/account number Originating orsanisacion Document number USMCanada Enformation Handling Services E-mail Te!: 800-U$-3352 Outside USAiCanada Except the United I(ingdom) Information Handling Services E-mai Te!: i 1-303-790

3、-0600 Technic3 Tz!: (O Fax: (O United Kingdom Indexes Ltd 344) 404409, Custoinet Support 34.1) 40442 I, Ccistoiner Suppori In formation Handing Senices and Teclinicai Indexer - Cortitiziad to Service Excellence ETSI ES 202 912-6 1.1.1 (2003-02) ETSI Standard Access and Terminals (AT); Short Message

4、Service (SMS) for PSTNIISDN; Test Suites for SMS User Based Solution; Part 6: Abstract Test Suite (ATS) user side for Data Link Layer (DLL) Protocol 2 2 ETSI ES 202 912-6 VI .I .I (2003-02) Reference DESIAT-030014-06 Keywords SMS, ISDN, PSTN, PIXIT ETSI 650 Route des Lucioles F-O6921 Sophia Antipoli

5、s Cedex - FRANCE Tel.: +33 4 92 94 42 O0 Fax: +33 4 93 65 47 16 Siret No 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-prfecture de Grasse (06) No 7803/88 Important notice Individual copies of the present document can be downloaded from: http:lwmv.etsi .arq The presen

6、t document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers o

7、f the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at ha p:/pa rta I. etsi I a rglt

8、bistat uslstatus .as p If you find errors in the present document, send your comment to: Cori vriaht Notifica tion No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. O European Telecommunications Stan

9、dards Institute 2003. All rights reserved. DECTTM, PLUGTESTSTMand UMTSTMare Trade Marks of ETSI registered for the benefit of its Members. TIPHONTM and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the

10、 benefit of its Members and of the 3GPP Organizational Partners. ETSI 3 ETSI ES 202 912-6 VI .I .I (2003-02) Contents Intellectual Property Rights . .5 Foreword . 5 Introduction . .5 1 2 3 3.1 3.2 4 4.1 4.2 5 6 6.1 6.2 6.3 6.4 6.5 6.6 Scope 6 References . .7 Definitions and abbreviations. . .8 Defin

11、itions . . 8 Abbreviations . 8 Test method and Testing Architecture .8 Test method . . 8 Test configuration . 8 Basic considerations on the TTCN development. . .9 ATS information 9 Naming conventions . 9 Restrictions and requirements not being tested . . 10 Grouping of test purposes . 10 Abstract Se

12、rvice Primitives . . 10 Information on physical layer information transfer and message encoding . 10 Use of timers, restrictions and interdependencies of timeout values 11 Annex A (normative): Abstract Test Suite (ATS) . 12 A. 1 Versions of specifications 12 A.2 ATS 12 . 12 A.2.2 A.2.1 The TTCN Grap

13、hical form (TTCN.GR) . . 12 Annex B (normative): Partial PIXIT proforma 13 B. 1 Introduction . .13 B .2 PIXIT items . .13 Additional information to the PIXIT . 16 Identification Summary. .16 C.3 Test Laboratory 17 The TTCN Machine Processable form (TTCN.MP) . Annex C (informative): C. 1 C.2 Abstract

14、 Test Suite Summary . 16 C.3.1 Test Laboratory Identification . 17 C.3.2 Accreditation status of the test service 17 C.3.3 Manager of Test Laboratory . 17 C.3.4 Contact person of Test Laboratory 18 C.3.5 Means of Testing. . 18 C.3.6 Instructions for Completion. . 18 C.4 Client 19 C.4.1 Client Identi

15、fication . . 19 C.4.2 Client Test Manager . 19 C.4.3 Client Contact person . 19 C.4.4 Test Facilities Required . . 20 C.5 System Under Test . 20 C.5.1 SUT Information . . 20 ETSI 4 ETSI ES 202 912-6 VI .I .I (2003-02) C.5.2 Limitations of the SUT . . . 20 C.5.3 Environmental Condition . . 21 C.6 Anc

16、illary Protocols .2 1 21 C.6.1 Ancillary Protocols 1 (Physical Layer) . . 21 C.6.2 Ancillary Protocols 2 (Transfer Layer) . . Annex D (informative): Bibliography . 22 History .23 . ETSI 5 ETSI ES 202 912-6 VI .I .I (2003-02) Intellectual Property Rights IPRs essential or potentially essential to the

17、 present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR O00 314: “Intellectual Property Rights (7PRs); Essential, orpotentially Essential, IPRs notlJied to ETSI i

18、n respect ofETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (5). All published ETSI deliverables shall include information which directs the reader to the above source of information. Foreword This ETSI Standard (ES) has been produce

19、d by ETSI Technical Committee Access and Terminals (AT). The present document is part 6 of a multi-part deliverable. Full details of the entire series can be found in part 1 9. I n t rod uct ion The present document is part 6 of a multi-part conformance test specification for SM-TE. The present docu

20、ment contains a TTCN design frame work and the detailed test specifications in TTCN for SM-TE at the userhetwork interface. The reader of the present document should be aware of the fact that much of the ATS information is contained in ES 202 912-5 5 and is therefore only referred to here, indicatin

21、g the relevant clauses in ES 202 912-5 5. ETSI 6 ETSI ES 202 912-6 VI .I .I (2003-02) 1 Scope The present document specifies the protocol conformance testing in TTCN for the Data Link layer in a Terminal Equipment implementing the Short Message Service (SMS) for PSTNASDN, UBSProtocol2, according to

22、ES 201 912 i at the userhetwork interface. Basic ISDN or PSTN call procedures apply in order to establish a circuit-switched band connection between such Terminal Equipment and an SM-SC. Tests for these procedures are outside the scope of the present document. UBS1 terminals send and receive Data Li

23、nk messages in the voice-band connection using the FSK signalling as defined in EN 300 659-2 2 and ES 200 778-2 3. Tests for the Physical Layer of the FSK signalling are also outside the scope of the present document. Terminal Equipment implementing the Short Message Service (SMS) for PSTNASDN accor

24、ding to UBS Protocol 2 are required to implement the Transfer Layer according to ES 20 1 9 12 i. Using the Remote Single Layer Embedded Test Method (see ISO/IEC 9646-2 7) for the UBS Protocol 2 Data Link layer , Transfer Layer messages appear here only as octet string parameters of Data Link layer m

25、essages. Tests for the Transfer Layer are not within the scope of the present document. The Abstract Test Suite designed in the present document is based on the test cases specified in tabular form combined with prose in ES 202 912-5 5. The following information can be found in this part, directly o

26、r by reference (mostly to ES 202 912-5 5): - The overall test suite structure. - The testing architecture. - The test methods and PCO definitions. - The test configuration. - TTCN styles and conventions. - - - - The partial PIXIT proforma, - The design principles, assumptions, and used interfaces to

27、 the TTCN tester (e.g. ASPS). Information about the assumed services of the Physical Layer. Interrelationships and dependencies between timeout values. The TTCN.MP and TTCN.GR forms for the mentioned protocols tests. While ISO/IEC 9646-1 6 and ISO/IEC 9646-2 7 have been used as the basis for the tes

28、t specification methodology, the ATS contained in the present document has been specified using TTCN-2+ (TR 101 666 SI). Two forms of the ATS are provided (see annex A): - - The TTCN Graphical form (TTCN.GR). The TTCN Machine Processable form (TTCN.MP). ETSI 7 ETSI ES 202 912-6 VI .I .I (2003-02) 2

29、Re fe re nces The following documents contain provisions which, through reference in this text, constitute provisions of the present document. References are either specific (identified by date of publication andor edition number or version number) or non-specific. For a specific reference, subseque

30、nt revisions do not apply For a non-specific reference, the latest version applies. Referenced documents which are not found to be publicly available in the expected location might be found at p. il ETSI ES 201 912 (Vl.l.1): “Access and Terminals (AT); Short Message Service (SMS) for PSTNASDN; Short

31、 Message Communication between a fixed network Short Message Terminal Equipment and a Short Message Service Centre“. ETSI EN 300 659-2 (V1.3.1): “Access and Terminals (AT); Analogue access to the Public Switched Telephone Network (PSTN); Subscriber line protocol over the local loop for display (and

32、related) services; Part 2: Off-hook data transmission“. ETSI ES 200 778-2 (V1.2.2): “Access and Terminals (AT); Analogue access to the Public Switched Telephone Network (PSTN); Protocol over the local loop for display and related services; Terminal equipment requirements; Part 2: Off-hook data trans

33、mission“. ETSI ES 202 912-4 (Vl.l.1): “Access and Terminals (AT); Short Message Service (SMS) for PSTNASDN Test Suites for SMS User Based Solution; Part 4: Protocol Implementation Conformance Statement (PICS) proforma specification user side for Data Link Layer Protocol 2“ ETSI ES 202 912-5 (Vl.l.1)

34、: “Access and Terminals (AT); Short Message Service (SMS) for PSTNASDN Test Suites for SMS User Based Solution; Part 5: Test Suite Structure and Test Purposes (TSS The Tree and Tabular Combined Notation (TTCN) (Ed. 2+)“. ETSI ES 202 912-1 (Vl.l.1): “Access and Terminals (AT); Short Message Service (

35、SMS) for PSTNASDN; Test Suites for SMS User Based Solution; Part 1 : Protocol Implementation Conformance Statement (PICS) proforma specification user side for Data Link Layer (DLL) Protocol 1“. ISO/IEC 9646-3 : “Information technology - Open Systems Interconnection - Conformance testing methodology

36、and framework - Part 3: The Tree and Tabular Combined Notation (TTCN)“. ETSI 8 ETSI ES 202 912-6 VI .I .I (2003-02) 3 Definitions and abbreviations 3.1 De fi nit ions For the purposes of the present document, the terms and definitions given in ES 202 912-5 5 apply. 3.2 Abbreviations For the purposes

37、 of the present document, the following abbreviations apply: ASP ATS CLI DLL FSK ISDN IS0 IUT PDU PICS PICS PIXIT PSTN SM SME SMS SM-SC SM-TE SUT TL TP TS TSS TSS Analogue access to the Public Switched Telephone Network (PSTN); Subscriber line protocol over the local loop for display (and related) s

38、ervices; Part 1 : On-hook data transmission“. ETSI EN 300 659-3 (V1.3.1): “Access and Terminals (AT); Analogue access to the Public Switched Telephone Network (PSTN); Subscriber line protocol over the local loop for display (and related) services; Part 3: Data link message and parameter codings“. ET

39、SI ES 200 778-1 (V1.2.2): “Access and Terminals (AT); Analogue access to the Public Switched Telephone Network (PSTN); Protocol over the local loop for display and related services; Terminal equipment requirements; Part 1 : On-hook data transmission“. ISO/IEC 9646-7: “Information technology - Open Systems Interconnection - Conformance testing methodology and framework - Part 7: Implementation Conformance Statements“. ETSI 23 ETSI ES 202 912-6 VI .I .I (2003-02) History ETSI