ETSI ES 202 060-1-2003 Short Message Service (SMS) for fixed networks Network Based Solution (NBS) Part 1 Overview《固定网络的短消息业务(SMS) 基于网络的解决方案(NBS) 第1部分 概述(版本1 1 1)》.pdf

《ETSI ES 202 060-1-2003 Short Message Service (SMS) for fixed networks Network Based Solution (NBS) Part 1 Overview《固定网络的短消息业务(SMS) 基于网络的解决方案(NBS) 第1部分 概述(版本1 1 1)》.pdf》由会员分享，可在线阅读，更多相关《ETSI ES 202 060-1-2003 Short Message Service (SMS) for fixed networks Network Based Solution (NBS) Part 1 Overview《固定网络的短消息业务(SMS) 基于网络的解决方案(NBS) 第1部分 概述(版本1 1 1)》.pdf（9页珍藏版）》请在麦多课文档分享上搜索。

1、 ETSI ES 202 060-1 V1.1.1 (2003-07)ETSI Standard Short Message Service (SMS) for fixed networks;Network Based Solution (NBS);Part 1: OverviewETSI ETSI ES 202 060-1 V1.1.1 (2003-07) 2 Reference DES/SPAN-130311-1 Keywords SMS, generic ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE

2、 Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be m

3、ade available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version k

4、ept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If yo

5、u find errors in the present document, send your comment to: editoretsi.org Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 20

6、03. All rights reserved. DECTTM, PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTMand the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its M

7、embers and of the 3GPP Organizational Partners. ETSI ETSI ES 202 060-1 V1.1.1 (2003-07) 3 Contents Intellectual Property Rights4 Foreword.4 Introduction 4 1 Scope 6 2 References 6 3 Abbreviations .6 4 Overview of the multi-part technical specification 7 4.1 Part 1: Overview.7 4.2 Part 2: Architectur

8、e and functional entities 7 4.3 Part 3: Integrated Services Digital Network (ISDN) access Protocol 7 4.4 Part 4: Interworking between Signalling System No.7 (SS7) and Digital Subscriber Signalling System No. one (DSS1) 8 4.5 Part 5: Network Access Protocol8 History 9 ETSI ETSI ES 202 060-1 V1.1.1 (2

9、003-07) 4 Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectua

10、l Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigatio

11、n, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This ETSI Standard (ES) has

12、been produced by ETSI Technical Committee Services and Protocols for Advanced Networks (SPAN). The present document is part 1 of a multi-part deliverable covering the Short Message Service (SMS) for fixed networks; Network Based Solution (NBS), as identified below: Part 1: “Overview“; Part 2: “Archi

13、tecture and functional entities“; Part 3: “Integrated Services Digital Network (ISDN) access protocol“; Part 4: “Interworking between Signalling System No.7 (SS7) and Digital Subscriber Signalling System No. one (DSS1)“; Part 5: “Network access protocol“. NOTE: The choice of a multi-part format for

14、the present document is to facilitate maintenance and future enhancements. Introduction The Short Message Service (SMS) is a service applicable at the coincident S and T reference point and T reference point, to provide the served user the ability to send and receive Short Messages. The Short Messag

15、es are exchanged between the sending and receiving user via a Short Message Service Centre (SM-SC) as shown in figure 1. User A User B SM-SC NOTE: Doted lines are indicated to reflect the Short Message transfer from User A to User B Figure 1: Short Message Service principle The Short Message Service

16、 (SMS) provides a means for sending a message of a limited size from and to a Short Message Terminal Equipment (SM-TE). ETSI ETSI ES 202 060-1 V1.1.1 (2003-07) 5 The SMS can be realized in two ways, either as a User Based Solution (UBS) or as a Network Based Solution (NBS). NOTE 1: The User Based So

17、lution (UBS) is provided as part of a function within the end-user equipment, which does not require any specific short message transfer function inside the public network. Only the basic call procedures within the public network and the Calling Line Identity (CLI) supplementary service are used. Tw

18、o UBS protocols (UBS1 and UBS2) are available and described in ES 201 912 4. Protocol 1 (UBS1): this protocol is fully compliant with the GSM SMS service and the DSS1 SM payload. Protocol 2 (UBS2): this protocol is specifically focused on the residential fixed network environment. NOTE 2: The Networ

19、k Based Solution (NBS) is provided as part of a function within the public network and does not require a voice-band communication path between the SM-TE and SM-SC. For compatibility with UBS and the NBS protocol solution, UBS1 or UBS2 transfer layer is encapsulated within the NBS network protocol m

20、essages. ETSI ETSI ES 202 060-1 V1.1.1 (2003-07) 6 1 Scope The present document specifies a set of protocols and associated element functional requirements needed for supporting SMS NBS. The SMS UBS is specified in ES 201 912 4 and not implicitly part of the present document. The present document is

21、 part 1 of the above mentioned series of ETSI deliverables and specifies general aspects of SMS based on ES 201 986 3. 2 References The following documents contain provisions which, through reference in this text, constitute provisions of the present document. References are either specific (identif

22、ied by date of publication and/or edition number or version number) or non-specific. For a specific reference, subsequent revisions do not apply. For a non-specific reference, the latest version applies. Referenced documents which are not found to be publicly available in the expected location might

23、 be found at http:/docbox.etsi.org/Reference. 1 ITU-T Recommendation I.411: “ISDN user-network interfaces - Reference configurations“. 2 ITU-T Recommendation I.130: “Method for the characterization of telecommunication services supported by an ISDN and network capabilities of an ISDN“. 3 ETSI ES 201

24、 986: “Services and Protocols for Advanced Networks (SPAN); Short Message Service (SMS) for PSTN/ISDN; Service description“. 4 ETSI ES 201 912: “Access and Terminals (AT); Short Message Service (SMS) for PSTN/ISDN; Short Message Communication between a fixed network Short Message Terminal Equipment

25、and a Short Message Service Centre“. 3 Abbreviations For the purposes of the present document, the following abbreviations apply: CLI Calling Line Identity DSS1 Digital Signalling System No. One FA Functional Architecture GSM Global System for Mobile communication ISDN Integrated Services Digital Ne

26、twork NBS Network Based Solution NE-SC Network Element Service Centre NNI Network Network Interface SMS Short Message Service SM-SC Short Message Service Centre SM-TE Short Message Terminal Equipment SS7 Signalling System No. Seven TC Transaction Capabilities UBS User Based Solution UBS1 User Based

27、Solution, protocol 1 UBS2 User Based Solution, protocol 2 UNI User Network Interface ETSI ETSI ES 202 060-1 V1.1.1 (2003-07) 7 4 Overview of the multi-part technical specification 4.1 Part 1: Overview The present document lists the scope of other parts of ES 202 060 which describe Short Message Serv

28、ice. The present document shall be used as a kind of directory document. NOTE: Whenever a new part will be created, the present document shall be updated accordingly to reflect permanently the status of the set of deliverables. 4.2 Part 2: Architecture and functional entities Part 2 specifies the Fu

29、nctional Architecture (FA) of the Short Message Service (SMS) for the pan-European Integrated Services Digital Network (ISDN) as provided by European public telecommunication operators at the T reference point or coincident S and T reference point (as defined in ITU-T Recommendation I.411 1) by mean

30、s of the Digital Subscriber Signalling System No. One (DSS1) protocol. The Functional Architecture (FA) as defined in stage two is needed to support a telecommunication service (see ITU-T Recommendation I.130 2). Part 2 does not specify the additional functional entities or architecture where the se

31、rvice is provided to the user via a telecommunication network that is not an ISDN but it does include interworking requirements of other networks with the public ISDN. Charging principles are outside the scope of part 2. Further clauses of part 2 specify the method of testing required to identify co

32、nformance to part 2. Part 2 is applicable to equipment supporting the Short Message Service, to be attached at either side of a T reference point or coincident S and T reference point when used as an access to the public ISDN. 4.3 Part 3: Integrated Services Digital Network (ISDN) access Protocol Pa

33、rt 3 specifies the stage three of the Short Message Service (SMS) for the pan-European Integrated Services Digital Network (ISDN) as provided by European public telecommunications operators at the T reference point or coincident S and T reference point (as defined in ITU-T Recommendation I.411 1) by

34、 means of the Digital Subscriber Signalling System No. One (DSS1) protocol. Stage three identifies the protocol procedures and switching functions needed to support a telecommunication service (see ITU-T Recommendation I.130 2). In addition, part 3 specifies the protocol requirements at the T refere

35、nce point where the service is provided to the user via an intermediate private ISDN. Part 3 does not specify the additional protocol requirements where the service is provided to the user via a telecommunication network that is not an ISDN but it does include interworking requirements of other netw

36、orks with the public ISDN. The SMS is provided independently of a call. Charging principles are outside the scope of part 3. The SM service enables the originating SMS user to send Short Messages (SMs) to the receiving SMS user via a Short Message Service Centre, belonging to the network of the SMS

37、originating user (served user) or separated from the network of the SM originating user. NOTE: The SM service is typically used between a Short Message service provider and a user (receiving user) of the Short Message service provided. Further clauses of part 3 specify the method of testing required

38、 to identify conformance to part 3. Part 3 is applicable to equipment supporting the SMS, to be attached at either side of a T reference point or coincident S and T reference point when used as an access to the public ISDN. ETSI ETSI ES 202 060-1 V1.1.1 (2003-07) 8 4.4 Part 4: Interworking between S

39、ignalling System No.7 (SS7) and Digital Subscriber Signalling System No. one (DSS1) Within this interworking specification, only those functions are described, which are relevant for the specific interworking for SMS. The standard UNI and NNI interworking procedures are not repeated here. 4.5 Part 5

40、: Network Access Protocol Part 5 specifies the stage three of the Short Message Service (SMS) for the pan-European Integrated Services Digital Network (ISDN) as provided by the European public telecommunication operators by means of the Signalling System No.7 Transaction Capabilities (TC) applicatio

41、n protocol. The stage three identifies the protocol procedures and switching functions needed to support a telecommunication service (see ITU-T Recommendation I.130 2). The SMS is provided independently of a call. Charging principles are outside the scope of part 5. Testing and maintenance requireme

42、nts are outside the scope of part 5. The SMS enables the originating SMS user to send Short Messages (SMs) to the receiving SMS user via a Short Message Service Centre (SM-SC), belonging to the network of the SMS originating user or separated from the network of the SMS originating user. NOTE: The S

43、MS is typically used between a Short Message service provider and a user of the Short Message service provided. The SM-SC can be connected to the network by SS7 or behind a NE-SC with DSS1 or other protocols. ETSI ETSI ES 202 060-1 V1.1.1 (2003-07) 9 History Document history V1.1.1 May 2003 Membership Approval Procedure MV 20030718: 2003-05-20 to 2003-07-18 V1.1.1 July 2003 Publication