ETSI EN 300 718-2-2001 Electromagnetic Compatability and Radio Spectrum Matters (ERM) Avalanche Beacons Transmitter-Receiver Systems Part 2 Harmonized EN Covering Essential Require.pdf

《ETSI EN 300 718-2-2001 Electromagnetic Compatability and Radio Spectrum Matters (ERM) Avalanche Beacons Transmitter-Receiver Systems Part 2 Harmonized EN Covering Essential Require.pdf》由会员分享，可在线阅读，更多相关《ETSI EN 300 718-2-2001 Electromagnetic Compatability and Radio Spectrum Matters (ERM) Avalanche Beacons Transmitter-Receiver Systems Part 2 Harmonized EN Covering Essential Require.pdf（13页珍藏版）》请在麦多课文档分享上搜索。

1、ETSI EN 300 718-2 1.1.1 (2001-05) Candidate Harmonized European Standard (Telecommunications series) Electromagnetic com pati bi I ity and Radio spectrum Matters (ERM); Avalanche Beacons; Transmitter-receiver systems; Part 2: Harmonized EN covering essential requirements of article 3.2 of the R Esse

2、ntial, orpotentially Essential, IPRs notjed to ETSI in respect OfETSIstandards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (-). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarante

3、e can be given as to the existence of other IPRs not referenced in ETSI SR O00 3 14 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Candidate Harmonized European Standard (Telecommunications series) has been produced by ET

4、SI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (EM). The present document is part 2 of a multi-part deliverable covering the Avalanche Beacons; Transmitter-receiver systems, as identified below: Part 1 : “Technical characteristics and test methods“; Part 2: Part 3: “

5、Harmonized EN covering essential requirements of article 3.2 of the R “Harmonized EN covering essential requirements of article 3.3e of the R it provides scope for standards to be added: - - without requiring alteration of standards that are already published. it clarifies, simplifies and promotes t

6、he usage of Harmonized Standards as the relevant means of conformity assessment. - under article 3.2 when new frequency bands are agreed or; under article 3.3 should the Commission take the necessary decisions; - ETSI 7 ETSI EN 300 718-2 V1.l.l (2001-05) 1 Scope The present document applies to requi

7、rements for avalanche beacons. Avalanche beacons are portable radio systems used for locating avalanche victims, for the purpose of direct rescue, i.e. for rescue by comrades not buried by the avalanche. The present document is applicable for avalanche beacons operating at a fiequency of 457 kHz. Th

8、e present document is intended to cover the provisions of Directive 1999/5/EC (R Avalanche Beacons; Transmitter-receiver systems; Part 1 : Technical characteristics and test methods“. Pl 31 ETSI ETR 028 (Edition 2, 1994): “Radio Equipment and Systems (RES); Uncertainties in the measurement of mobile

9、 radio equipment characteristics“. ITU Radio Regulations (1 998), Appendix S 1: “Classification of emissions and necessary bandwidths“. 41 51 ETSI EN 300 7 18-3 (Vi. 1.1,200 1): “Electromagnetic compatibility and Radio spectrum Matters (EM); Avalanche Beacons; Transmitter-receiver systems; Part 3 :

10、Harmonized EN covering essential requirements of article 3.3e of the R the value of the measurement uncertainty for the measurement of each parameter shall be included in the test report; - - the recorded value of the measurement uncertainty shall be, for each measurement, equal to or lower than the

11、 figures in table 1. For the test methods, according to the present document, the measurement uncertainty figures shall be calculated in accordance with ETR 028 3 and shall correspond to an expansion factor (coverage factor) k = 1,96 of k = 2 (which provide confidence levels of respectively 95 % and

12、 95,45 % in the case where the distributions characterizing the actual measurement uncertainties are normal (Gaussian). Table 1 is based on such expansion factors. ETSI 12 ETSI EN 300 718-2 V1.l.l (2001-05) Annex A (normative): The EN Requirements Table (EN-RT) Notwithstanding the provisions of the

13、copyright clause related to the text of the present document, ETSI grants that users of the present document may freely reproduce the EN-RT proforma in this annex so that it can be used for its intended purposes and may fwther publish the completed EN-RT. The EN Requirements Table (EN-RT) serves a n

14、umber of purposes, as follows: - - it provides a tabular summary of all the requirements; it shows the status of each EN-R, whether it is essential to implement in all circumstances (Mandatory), or whether the requirement is dependent on the supplier having chosen to support a particular optional se

15、rvice or functionality (Optional). In particular it enables the EN- when completed in respect of a particular equipment it provides a means to undertake the static assessment of conformity with the EN. - The EN-RT is placed in an annex of the EN in order that it may be photocopied and used as a prof

16、orma. Table A.l: EN Requirements Table (EN-RT) Key to columns: No Reference EN-R Status M O 0.n Comments table entry number; clause reference number of conformance requirement within the present document; title of conformance requirement within the present document; status of the entry as follows: M

17、andatory: shall be implemented under all circumstances; Optional, may be provided, but if provided shall be implemented in accordance with the requirements; this status is used for mutually exclusive or selectable options among a set. The integer “n“ shall refer to a unique group of options within t

18、he EN-RT. A footnote to the EN-RT shall explicitly state what the requirement is for each numbered group. For example, “It is mandatory to support at least one of these options“, or, “It is mandatory to support exactly one of these options“. to be completed as required. ETSI 13 V1.l.l V1.l.l ETSI EN 300 718-2 V1.l.l (2001-05) January 2001 One-step Approval Procedure OAP 20010518: 2001-01-17 to 2001-05-18 May2001 Publication History ETSI