DLA MIL-DTL-17376 3 B-2012 CAPS AND FLANGES COMPRESSED-GAS CYLINDER FLANGES HIGH PRESSURE.pdf

《DLA MIL-DTL-17376 3 B-2012 CAPS AND FLANGES COMPRESSED-GAS CYLINDER FLANGES HIGH PRESSURE.pdf》由会员分享，可在线阅读，更多相关《DLA MIL-DTL-17376 3 B-2012 CAPS AND FLANGES COMPRESSED-GAS CYLINDER FLANGES HIGH PRESSURE.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 AMSC N/A FSC 8120 INCH-POUND MIL-DTL-17376/3B 8 MAY 2012 SUPERSEDING MIL-C-17376/3A 22 MARCH 2007 DETAIL SPECIFICATION SHEET CAPS AND FLANGES COMPRESSED-GAS CYLINDER: FLANGES, HIGH PRESSURE Reactivated after 22 March 2007 and may be used for new and existing designs and acquisitions. This detail sp

2、ecification sheet is approved for use by all departments and agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this detail specification sheet and MIL-DTL-17376. INTENDED USE: 1. The flanges covered by this specification sheet are int

3、ended to provide anchorage on the shoulders of high pressure cylinders for cylinder caps to provide protection for the cylinder valve against damage in storage, handling, and shipping. REQUIREMENTS: 1. Flange: The compressed-gas cylinder high pressure flange shall be as specified herein and in accor

4、dance with figure 1. Figure 1 is a representative neck ring and may be varied provided dimensions of threaded portions are as shown and the dimensions fit the configuration of the cylinder. 2. Material. The steel used shall have a carbon content not greater than 0.25 percent or shall be composition

5、G41000 of SAE J402, “(R) New Steel Designation System for Wrought or Rolled Steel”. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-17376/3B 2 NOTES: 1. Part or identification number (PIN) to be used for high pressure flanges acquired to this

6、 detail specification is created as follows: 1 3011/16“ MIN.3-1/8“-11 UNS-15/32“2-25/32“ DIA. MAX.3-16“ASize Part number Dimension A 1 C17376/3-1 3-1/8-11 UNS-1 NOTE: 1. All dimensions are in inches. FIGURE 1. Flange. M 17376/3 X Size: 1 = C17376/3-1 (3-1/8 UNS-1) high pressure flange Specification

7、sheet number M prefix General specification number Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-17376/3B 3 Custodians: Preparing Activity: Army - CR4 Navy - YD Air Force 68 DLA-GS DLA - GS7 (Project 8120-2012-002) Review Activities: Army -

8、 MD Navy - MC NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-