DLA DSCC-DWG-85048 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE SEVENTEEN SIZE 20 SIGNAL CONTACTS WITH FOUR SIZE 8 CONTACT CAVITIES《4型8信号谐振器 有17个20号信号连接微型插入式电气连接器》.pdf

《DLA DSCC-DWG-85048 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE SEVENTEEN SIZE 20 SIGNAL CONTACTS WITH FOUR SIZE 8 CONTACT CAVITIES《4型8信号谐振器 有17个20号信号连接微型插入式电气连接器》.pdf》由会员分享，可在线阅读，更多相关《DLA DSCC-DWG-85048 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE SEVENTEEN SIZE 20 SIGNAL CONTACTS WITH FOUR SIZE 8 CONTACT CAVITIES《4型8信号谐振器 有17个20号信号连接微型插入式电气连接器》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、REVISIONS LTR DESCRIPTION DATE APPROVED B Part number update. Added vendor CAGEs 60563 and 28198; deleted vendor CAGEs 25330 and 71785. 90-07-31 R Marbais C Change “part number” to “Part or Identifying Number (PIN)”. Vendor CAGE 60563, PINs, delete and substitute new PINs. Editor changes throughout.

2、 01-01-22 Robert M. Heber D Add Vendor CAGE SW884, delete MIL-STD-1344 test methods, add EIA-364 test procedures 06-01-20 Richard L. Taylor Prepared in accordance with ASME-Y14.100 REV PAGE REV D C C D D REV STATUS OF PAGES PAGE 1 2 3 4 5 PREPARED BY PMIC G Dennis L. Kelly DEFENSE SUPPLY CENTER, COL

3、UMBUS COLUMBUS, OHIO 43218-3990 CHECKED BY TITLE L. V. Olszewski APPROVED BY Richard Marbais CONNECTOR, ELECTRICAL, INSERT ARRANGEMENT, MINIATURE, SEVENTEEN SIZE 20 SIGNAL CONTACTS, WITH FOUR SIZE 8 CONTACT CAVITIES SIZE CAGE CODE 037Z3 DWG. NO.85048 Original date of drawing 8 May 1986 A REV D PAGE

4、1 OF 5 AMSC N/A 5935-E767-000Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Engaging face (pin) Inches mm Inches mm .055 .056 .109 .112 .163 .218 1.40 1.42 2.77 2.84 4.14 5.54 .272 .326 .381 .435 .618 .893 6.91 8.28 9.68 11.05 15.70 22.68 NOTES: 1.

5、Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerance for three place decimals is .005 inch (0.13 mm). 4. All dimensions are true position (TP). 5. Contact holes in insert shall be located on TP within a .005 inch (0.13 mm) d

6、iameter circle. 6. Markings are shown for the pin insert front. Socket inserts are the opposite. 7. Reference documents shall be of the issue in effect on date of invitations for bid. SIZE CAGE CODE DWG NO. 037Z3 85048 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REVD PAGE2 FIGURE 1. In

7、sert arrangement, seventeen size 20 signal contacts, with four size 8 contact cavities. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ENGINEERING DATA: Voltage rating: 500 volts rms at sea level. Operating temperature: -55C to +125C. REQUIREMENTS:

8、Requirements of drawing 85039 and MIL-DTL-24308 are applicable. Dimensions and configurations: See figure 1. Signal contact specifications: Style A: (crimp removable signal contacts) Socket: M39029/63-368. Pin: M39029/64-369. Style B: (solder fixed signal contacts) Socket: MIL-DTL-24308 Appendix B,

9、figure B-1. Pin: MIL-DTL-24308 Appendix B, figure B-2. Shell size: Four. Shell specifications: Style A: Socket: MIL-DTL-24308/2, figure 1. Pin: MIL-DTL-24308/4, figure 1. Style B: Socket: MIL-DTL-24308/1, figure 1. Pin: MIL-DTL-24308/3, figure 1. Tools: Connectors with crimp removable signal contact

10、s shall be designed for contact insertion and removal with the applicable military tools as follows: Contact size Tool PIN 20 M81969/39-01 with plastic tip M81969/1-02 with metal tip Mating and unmating forces (with signal contacts only installed): See table I. TABLE I. Mating and unmating forces. M

11、ating force (pounds) Unmating force (pounds) Contact type Minimum Maximum Minimum Maximum Signal 0.655 19.00 0.655 11.00 SIZE CAGE CODE DWG NO. 037Z3 85048 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE3 Provided by IHSNot for ResaleNo reproduction or networking permitted withou

12、t license from IHS-,-,-Contact resistance: See table II. TABLE II. Contact resistance (millivolts maximum). 1/ Contact classes G, D, M, N Contact Size AWG wire Size Test current (amperes) After salt Spray All others 20 24 20 3.0 7.5 55 65 45 55 1/ Not applicable to crimp or shielded contacts. Dielec

13、tric withstanding voltage: See table III. TABLE III. Dielectric withstanding voltage. Altitude Humidity condition All other conditions Sea level 600 1,000 70,000 - 325 Vibration: Test procedure EIA364-28, test condition IV. Temperature cycling: Test procedure EIA364-32, condition 1, 5 cycles, except

14、 temperature shall be -55C to +125C. Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed on the requirements drawing have agreed to this drawing and a certificate of compliance has been submitted to DSCC-VAI. Vendor similar PIN

15、1/ DSCC drawing PIN 2/ 3/ 4/ 5/ CAGE 71468 CAGE 60563 CAGE 28198 CAGE SW884 6/ 85048GBEP 6/ 85048GBES 85048GBEPT 85048GBEST 85048GBEPR 85048GBESR DCMMY21WA4PA101 DCMMY21WA4SA101 DCMM21WA4PA101 DCMM21WA4SA101 P214PSA2D P214RSA2D P214PSA2 P214RSA2 CBM21WA4M02F00C-0 CBM21WA4F02F00C-0 CBM21WA4M02000C-0

16、CBM21WA4F02000C-0 PCMMHW21WA4P PCMMHW21WA4S PCMMHW21W4P PCMMHW21W4S 1/ Caution. Do not use this number for item acquisition. Items acquired to this number may not satisfy the performance requirements of this drawing. 2/ Connectors supplied to this drawing shall include a full compliment of signal co

17、ntacts. 3/ Size 8 contacts should be ordered separately. 4/ Size 8 contacts are snap-in and removable. 5 For size 8 contacts, see DSCC drawings 89046 through 89061. 6/ Pins 85048GBEP and 85048GBES are cancelled and superseded by 85048GBEPT and 85048GBEST respectively .SIZE CAGE CODE DWG NO. 037Z3 85

18、048 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Vender CAGE Vendor name number and address 28198 Positronics Industries, Incorporated 423 North Campbell Springfield, MO 65801-82

19、47 60563 The Phoenix Company 555 Pond Drive Wood Dale, IL 60191-1192 71468 ITT Cannon P.O. Box 929 666 East Dyer Road Santa Ana, CA 92702-0929 SW884 The Phoenix Company of Chicago, Mexico Carretera Internacional K M 1969 Guadalajara Nogales KM 2 Empalme, Mexico 85340 SIZE CAGE CODE DWG NO. 037Z3 85048 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-