CSA P 5-2009 Test method for measuring per-cycle energy consumption energy factor and low power mode energy consumption of residential gas clothes dryers (Third Edition).pdf

《CSA P 5-2009 Test method for measuring per-cycle energy consumption energy factor and low power mode energy consumption of residential gas clothes dryers (Third Edition).pdf》由会员分享，可在线阅读，更多相关《CSA P 5-2009 Test method for measuring per-cycle energy consumption energy factor and low power mode energy consumption of residential gas clothes dryers (Third Edition).pdf（30页珍藏版）》请在麦多课文档分享上搜索。

1、P.5-09Test method for measuring per-cycle energy consumption, energy factor, and low power mode energy consumption of residential gas clothes dryersLegal Notice for StandardsCanadian Standards Association (CSA) standards are developed through a consensus standards development process approved by the

2、 Standards Council of Canada. This process brings together volunteers representing varied viewpoints and interests to achieve consensus and develop a standard. Although CSA administers the process and establishes rules to promote fairness in achieving consensus, it does not independently test, evalu

3、ate, or verify the content of standards.Disclaimer and exclusion of liabilityThis document is provided without any representations, warranties, or conditions of any kind, express or implied, including, without limitation, implied warranties or conditions concerning this documents fitness for a parti

4、cular purpose or use, its merchantability, or its non-infringement of any third partys intellectual property rights. CSA does not warrant the accuracy, completeness, or currency of any of the information published in this document. CSA makes no representations or warranties regarding this documents

5、compliance with any applicable statute, rule, or regulation. IN NO EVENT SHALL CSA, ITS VOLUNTEERS, MEMBERS, SUBSIDIARIES, OR AFFILIATED COMPANIES, OR THEIR EMPLOYEES, DIRECTORS, OR OFFICERS, BE LIABLE FOR ANY DIRECT, INDIRECT, OR INCIDENTAL DAMAGES, INJURY, LOSS, COSTS, OR EXPENSES, HOWSOEVER CAUSE

6、D, INCLUDING BUT NOT LIMITED TO SPECIAL OR CONSEQUENTIAL DAMAGES, LOST REVENUE, BUSINESS INTERRUPTION, LOST OR DAMAGED DATA, OR ANY OTHER COMMERCIAL OR ECONOMIC LOSS, WHETHER BASED IN CONTRACT, TORT (INCLUDING NEGLIGENCE), OR ANY OTHER THEORY OF LIABILITY, ARISING OUT OF OR RESULTING FROM ACCESS TO

7、OR POSSESSION OR USE OF THIS DOCUMENT, EVEN IF CSA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, INJURY, LOSS, COSTS, OR EXPENSES.In publishing and making this document available, CSA is not undertaking to render professional or other services for or on behalf of any person or entity or to pe

8、rform any duty owed by any person or entity to another person or entity. The information in this document is directed to those who have the appropriate degree of experience to use and apply its contents, and CSA accepts no responsibility whatsoever arising in any way from any and all use of or relia

9、nce on the information contained in this document. CSA is a private not-for-profit company that publishes voluntary standards and related documents. CSA has no power, nor does it undertake, to enforce compliance with the contents of the standards or other documents it publishes. Intellectual propert

10、y rights and ownershipAs between CSA and the users of this document (whether it be in printed or electronic form), CSA is the owner, or the authorized licensee, of all works contained herein that are protected by copyright, all trade-marks (except as otherwise noted to the contrary), and all inventi

11、ons and trade secrets that may be contained in this document, whether or not such inventions and trade secrets are protected by patents and applications for patents. Without limitation, the unauthorized use, modification, copying, or disclosure of this document may violate laws that protect CSAs and

12、/or others intellectual property and may give rise to a right in CSA and/or others to seek legal redress for such use, modification, copying, or disclosure. To the extent permitted by licence or by law, CSA reserves all intellectual property rights in this document.Patent rightsAttention is drawn to

13、 the possibility that some of the elements of this standard may be the subject of patent rights. CSA shall not be held responsible for identifying any or all such patent rights. Users of this standard are expressly advised that determination of the validity of any such patent rights is entirely thei

14、r own responsibility.Authorized use of this documentThis document is being provided by CSA for informational and non-commercial use only. The user of this document is authorized to do only the following:If this document is in electronic form:.load this document onto a computer for the sole purpose o

15、f reviewing it;.search and browse this document; and.print this document if it is in PDF format. Limited copies of this document in print or paper form may be distributed only to persons who are authorized by CSA to have such copies, and only if this Legal Notice appears on each such copy.In additio

16、n, users may not and may not permit others to.alter this document in any way or remove this Legal Notice from the attached standard;.sell this document without authorization from CSA; or.make an electronic copy of this document.If you do not agree with any of the terms and conditions contained in th

17、is Legal Notice, you may not load or use this document or make any copies of the contents hereof, and if you do make such copies, you are required to destroy them immediately. Use of this document constitutes your acceptance of the terms and conditions of this Legal Notice.Standards Update ServiceP.

18、5-09February 2009Title: Test method for measuring per-cycle energy consumption, energy factor, and low power mode energy consumption of residential gas clothes dryersPagination: 22 pages (viii preliminary and 14 text), each dated February 2009To register for e-mail notification about any updates to

19、this publicationgo to shop.csa.caclick on CSA Update ServiceThe List ID that you will need to register for updates to this publication is 2020510.If you require assistance, please e-mail techsupportcsagroup.org or call 416-747-2233.Visit CSA Groups policy on privacy at csagroup.org/legal to find out

20、 how we protect your personal information.Blank pagePublished in February 2009 by Canadian Standards AssociationA not-for-profit private sector organization5060 Spectrum Way, Suite 100, Mississauga, Ontario, Canada L4W 5N61-800-463-6727 416-747-4044Visit our Online Store at www.ShopCSA.caP.5-09Test

21、method for measuring per-cycle energy consumption, energy factor, and low power mode energy consumption of residential gas clothes dryersCSA Standard100%ISBN 978-1-55491-083-0Technical Editor: Laura Contasti Canadian Standards Association 2009All rights reserved. No part of this publication may be r

22、eproduced in any form whatsoever without the prior permission of the publisher.To purchase CSA Standards and related publications, visit CSAs Online Store at www.ShopCSA.ca or call toll-free 1-800-463-6727 or 416-747-4044.The Canadian Standards Association (CSA) prints its publications on Rolland En

23、viro100, which contains 100% recycled post-consumer fibre, is EcoLogo and Processed Chlorine Free certified, and was manufactured using biogas energy.February 2009 iiiContents Canadian Standards AssociationTest method for measuring per-cycle energyconsumption, energy factor, and low power modeenergy

24、 consumption of residential gas clothes dryersTechnical Committee on Gas Appliances and Related Accessories vSubcommittee on Energy Efficiency of Gas Clothes Dryers viiPreface viii1Scope 12 References 23 Definitions and nomenclature 23.1 Definitions 23.2 Nomenclature 34 Test conditions 44.1 Installa

25、tion 44.2 Ambient temperature and humidity 44.3 Energy supply 44.3.1 Electrical supply 44.3.2 Gas supply 44.4 Instrumentation 44.4.1 General 44.4.2 Weighing scales 54.4.3 Electrical measurements 54.4.4 Time 54.4.5 Gas meter 54.4.6 Relative humidity 54.4.7 Water hardness 54.4.8 Temperature 54.4.9 Sta

26、ndard continuous flow calorimeter 64.5 Test cloths 64.5.1 Test cloth 64.5.2 Stuffer cloths 64.5.3 Test cloth preconditioning 64.6 Power supply 64.7 Drying chamber capacity 74.8 Composition, preparation, and use of test loads 74.8.1 Compact size dryer load 74.8.2 Standard size dryer load 74.9 Prepara

27、tion of test sample 84.9.1 Installation 84.9.2 Lint trap 84.9.3 Control 84.10 Clothes dryer preconditioning 85 Test procedures and measurements 85.1 General 85.2 Method of dryer loading 85.3 Test cycle 85.4 Data recording 85.5 Credit for automatic termination 9P.5-09 Canadian Standards Associationiv

28、 February 20096Calculations 96.1 Per-cycle electrical energy consumption 96.2 Per-cycle gas energy consumption 96.3 Total per-cycle energy consumption 96.4 Energy factor 107 Electrical power consumption for low power mode 107.1 General 107.2 Energy measurement method 107.2.1 Sampling method 107.2.2

29、Average reading method 117.2.3 Direct meter reading method 11AnnexesA (normative) Minimum energy factor 13B (informative) Standard test detergent 14Figures1 AHAM exhaust simulator 12 Canadian Standards AssociationTest method for measuring per-cycle energyconsumption, energy factor, and low power mod

30、eenergy consumption of residential gas clothes dryersFebruary 2009 vTechnical Committee on Gas Appliances and Related AccessoriesZ.J. Fraczkowski Technical Standards (b) provide an explanation of circumstances surrounding the actual field condition; and(c) be phrased where possible to permit a speci

31、fic “yes” or “no” answer.Committee interpretations are processed in accordance with the CSA Directives and guidelines governing standardization and are published in CSAs periodical Info Update, which is available on the CSA Web site at www.csa.ca. Canadian Standards AssociationTest method for measur

32、ing per-cycle energyconsumption, energy factor, and low power modeenergy consumption of residential gas clothes dryersFebruary 2009 1P.5-09Test method for measuring per-cycle energy consumption, energy factor, and low power mode energy consumption of residential gas clothes dryers1Scope1.1This Stand

33、ard specifies the test method to measure per-cycle energy consumption and the calculations required to determine the energy factor of low power residential gas clothes dryers.1.2This Standard applies to compact size and standard size gas clothes dryers for use in residential applications.1.3This Sta

34、ndard does not apply to the construction and performance safety of residential gas clothes dryers.Note: Construction and performance safety are addressed in ANSI Z21.5.1/CSA 7.1.1.4In CSA Standards, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in or

35、der to comply with the Standard; “should” is used to express a recommendation or that which is advised but not required; “may” is used to express an option or that which is permissible within the limits of the Standard; and “can” is used to express possibility or capability. Notes accompanying claus

36、es do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Legends to equations an

37、d figures are considered requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.1.5The values given in SI (metric) units are the standard. The values given in parentheses are for information only.P.5-09 Canadian Standards Association2 Fe

38、bruary 20092 ReferencesThis Standard refers to the following publications, and where such reference is made, it shall be to the edition listed below, including all amendments published thereto.CSA (Canadian Standards Association)CAN/CSA-C361-92 (R2008)Test method for measuring energy consumption and

39、 drum volume of electrically heated household tumble-type clothes dryersANSI Z21.5.1-2006/CSA 7.1-2006Gas clothes dryers Volume 1, Type 1 clothes dryersAHAM (Association of Home Appliance Manufacturers)HLD-1-1992Clothes DryersUS GovernmentUS Code of Federal Regulations, Title 10, Part 430, as amende

40、d from time to time (referenced as 10 CFR)3 Definitions and nomenclature3.1 DefinitionsThe following definitions apply in this Standard:Automatic termination control a dryer control system with(a) a sensor, which monitors either the dryer load temperature or its moisture content; and(b) a controller

41、, which automatically terminates the drying process.Notes: (1) A mark or detent, which indicates a preferred automatic termination control setting, is present if the dryer is to be classified as having an “automatic termination control”.(2) A mark is a visible single control setting on one or more d

42、ryer controls.Bone dry a condition of a test cloth load that has been dried and weighed.Compact (Compact size) a clothes dryer with a drying chamber capacity of less than 125 L (4.4 ft3).Cool down the portion of the clothes drying cycle when the added gas heat is terminated and the clothes continue

43、to tumble and dry within the drum.Cycle the sequence of drying operations of a clothes dryer. Note: A cycle can include variations or combinations of heating, tumbling, and drying functions.Drying chamber capacity the volume of the drying drum, adjusted for the specific door configuration employed.N

44、ote: The dryer chamber capacity takes into account the volume of the door protruding inwards or outwards of the door plane.Energy factor the ratio of weight of bone-dried test load to total per-cycle energy consumption, as measured during the test cycle specified in Clause 4.3.Low power modes Networ

45、k-connected standby mode the mode in which the energy-using product is connected to a main power source and at least one network function is available. Canadian Standards AssociationTest method for measuring per-cycle energyconsumption, energy factor, and low power modeenergy consumption of resident

46、ial gas clothes dryersFebruary 2009 3Off mode the mode in which the energy-using product is connected to a main power source and is not providing any standby mode or active mode function and where the mode persists for an indefinite time.Standby mode the mode in which the energy-using product is con

47、nected to a main power source and offers one or more user-oriented or protective functions that can persist for an indefinite time.Moisture content the ratio of the weight of water contained by the test load to the bone-dry weight of the test load, expressed as a percent.Moisture-sensing control a s

48、ystem that utilizes a moisture-sensing element within the dryer drum that monitors the amount of moisture in the clothes and is capable of automatically terminating the dryer cycle.Non-heat mode tumbling without heating.Standard (Standard size) a clothes dryer with a drying chamber capacity of 125 L

49、 (4.4 ft3) or greater.Temperature-sensing control a system that monitors dryer exhaust air temperature and is capable of automatically terminating the dryer cycle.3.2 NomenclatureThe following apply in this Standard:C = capacity of the drum, L (ft3)d = density of water at test temperature, kg/L (lb/ft3)Ecg= total gas dryer energy consumption per cycle, kWh/cycleEge= gas dryer electrical consumption per cycle, kWh/cycleEgg= gas dryer gas energy consumption per cycle, kJ/cycle (Btu/cycle)Ete= total electrical energy consumed, kWhEtg=