CEPT T R 10-01 E-1992 Relating to the Harmonized Radio Frequency Bands for Wide Band Data Transmission Systems Using Spread Spectrum Technology《有关使用扩频技术的宽带数据传输系统统一无线电频带》.pdf

《CEPT T R 10-01 E-1992 Relating to the Harmonized Radio Frequency Bands for Wide Band Data Transmission Systems Using Spread Spectrum Technology《有关使用扩频技术的宽带数据传输系统统一无线电频带》.pdf》由会员分享，可在线阅读，更多相关《CEPT T R 10-01 E-1992 Relating to the Harmonized Radio Frequency Bands for Wide Band Data Transmission Systems Using Spread Spectrum Technology《有关使用扩频技术的宽带数据传输系统统一无线电频带》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、CEPT T/R*LO-OL*E 92 232b4L4 00L2b85 087 69 TR1O-m Page E 1 Recommendation T/R 10-01 (Oslo 1991) RELATING TO THE HARMONIZED RADIO FREQUENCY BANDS FOR WIDE BAND DATA TRANSMISSION SYSTEMS USING SPREAD SPECTRUM TECHNOLOGY Recommendation proposed by the Working Group T/WG 18 “Frequency Management” (FM) T

2、ext of the Recommendation adopted by the “European Radiocommunications Committee” (ERC) . INTRODUCTION In 199 1 the European Radiocommunications Committee published ERC Report 1 on the harmonization of frequency bands for Radio Local Area Networks (RLANs). Subsequently it was recognized that it woul

3、d be preferable to identify the frequency bands to be used for Wide Band Data Transmission Systems such as RLANs before ETSI started to develop the relevant ETSs. In order to enable the rapid deployment of the market a general requirement was identified for a regulatory regime requiring little or no

4、 frequency coordination for individual systems. One possibility would be to accommodate Wide Band Data Transmission System in ISM frequency bands. The sharing conditions in most ISM frequency bands are not ideal due to the use of these bands for other low power devices as well as for ISM application

5、s. However, the methodologies developed for assessing compatibility between spread spectrum and narrow band systems show that satisfactory and reliable operation for Wide Band Data Transmission Systems is possible in an ISM environment. It is considered that the ISM frequency band 2400-2500 MHz offe

6、rs the best possibility for meeting this requirement which is the lowest ISM band available in Europe offering sufficient bandwidth whilst still providing sufficient in-building penetration to facilitate cost effective and flexible system applications. However, it is recognized that the future ETSI

7、HIPERLAN standard, requiring higher data rates, will necessitate a more predictable sharing environment. Therefore, CEPT is in the process of developing a separate Recommenda- tion for HIPERLANs operating in the 5 GHz range and in the band 17.1-17.3 GHz. The DECT system developed by ETSI also provid

8、es RLAN facilities. O The following Recommendation if therefore agreed by CEPT : “The European Conference of Postal and Telecommunications Administrations, considering that a) CEPT has a long-term objective to harmonize the use of radio frequencies throughout Europe, b) there is an emerging requirem

9、ent for Wide Band Data Transmission Systems using radio, thus offering increased O flexibility, c) ETSI will be developing an appropriate standard for such applications, d) the 2.5 GHz ISM allocation provides the best means of meeting the requirement in terms of spectrum availability, bandwidth and

10、good in-building penetration, e) there is a general requirement for a regulatory regime which enables the rapid deployment of Wide Band Data Transmission Systems with minimal frequency planning, f) some countries outside Europe have already designated frequency spectrum in the 915 MHz and 2450 MHz I

11、SM frequency bands for such systems using spread-spectrum technology, g) the 915 MHz frequency band is designated within CEPT countries for GSM and other mobile radio services in accordance with CEPT Recommendation T/R 75-02 E and is therefore not available for any Wide Band Data Transmission System

12、s within CEPT countries, h) compatibility studies have shown that Wide Band Data Transmission Systems using spread-spectrum technology, due to their low spectral power density and their high immunity against interference, could share with some narrow-band radio systems, Edition of January 20, 1992 C

13、EPT T/R*1O-OL*E 92 m 2326414 00L2bBb TL3 m TIR 10-01 E Page 2 noting that there is also a requirement for RLAN Systems operating in a predictable sharing environment and enabling medium and high capacity data transfer rates with good frequency re-use capability which could be met in frequency bands

14、around 5 GHz and in the band 17.1-17.3 GHz for which ETSI has decided to develop a standard for a “High Performance European Radio LAN (HIPERLAN)” and for which CEPT is intending to develop a Recommendation in 1992, recommends that the band 2400-2500 MHz be used on a non-interference and non-protect

15、ed basis for Wide Band Data Transmission Systems using spread spectrum technology with a minimum aggregate bit rate of 250 kbit/s. The total power in this frequency range shall not exceed - 10 dBW e.i.r.p. For systems using direct sequence spread spectrum technology, the peak e.i.r.p. spectral density shall not exceed -20 dBW/MHz; for systems using frequency hopping spread spectrum technology, the peak e.i.r.p. shall not exceed - 10 dBW measured in a 100 kHz bandwidth.” Edition of January 20, 1992