CAN CSA-ISO IEC 14496-4J-2006 Information technology - Coding of audio-visual objects - Part 4 Conformance testing AMENDMENT 10 Conformance extensions for simple profile levels 4a .pdf

《CAN CSA-ISO IEC 14496-4J-2006 Information technology - Coding of audio-visual objects - Part 4 Conformance testing AMENDMENT 10 Conformance extensions for simple profile levels 4a .pdf》由会员分享，可在线阅读，更多相关《CAN CSA-ISO IEC 14496-4J-2006 Information technology - Coding of audio-visual objects - Part 4 Conformance testing AMENDMENT 10 Conformance extensions for simple profile levels 4a .pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、 Reference numberISO/IEC 14496-4:2004/Amd.10:2005(E)ISO/IEC 2005 International Organization for Standardization (ISO), 2005. All rights reserved. International Electrotechnical Commission (IEC), 2005. All rights reserved. NOT FOR RESALE. Information technology Coding of audio-visual objects Part 4:

2、Conformance testing AMENDMENT 10: Conformance extensions for simple profile levels 4a and 5 Technologies de linformation Codage des objets audiovisuels Partie 4: Essai de conformit AMENDEMENT 10: Extensions de conformit pour niveaux 4a et 5 de profil simple Amendment 10:2006 toNational Standard of C

3、anadaCAN/CSA-ISO/IEC 14496-4:06Amendment 10:2005 to International Standard ISO/IEC 14496-4:2004 has been adopted withoutmodification (IDT) as Amendment 10:2006 to CAN/CSA-ISO/IEC 14496-4:06. This Amendment wasreviewed by the CSA Technical Committee on Information Technology (TCIT) under the jurisdic

4、tion of theStrategic Steering Committee on Information Technology and deemed acceptable for use in Canada.December 2006(reaffirmed 2011)ISO/IEC 14496-4:2004/Amd.10:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printe

5、d or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liab

6、ility in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is s

7、uitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO/IEC 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or

8、 by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 g120 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09

9、 47 E-mail copyrightiso.org Web www.iso.org ii ISO/IEC 2005 All rights reservedISO/IEC 14496-4:2004/Amd.10:2005(E) ISO/IEC 2005 All rights reserved iiiForeword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system

10、 for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees coll

11、aborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standard

12、s are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication a

13、s an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying any or all such patent

14、 rights. Amendment 10 to ISO/IEC 14496-4:2004 was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 29, Coding of audio, picture, multimedia and hypermedia information. This amendment specifies conformance tests for Levels 4a and 5 of the ISO/IEC 14496-2 Si

15、mple Profile. The bitstreams to be used for conformance testing of these levels accompany this document. ISO/IEC 14496-4:2004/Amd.10:2005(E) ISO/IEC 2005 All rights reserved 1Information technology Coding of audio-visual objects Part 4: Conformance testing AMENDMENT 10: Conformance extensions for si

16、mple profile levels 4a and 5 Add 5.5.3.1.37 after subclause 5.5.3.1.36 and change the following subclauses accordingly: 5.5.3.1.37 Conformance for Simple Profile Levels 4a and 5 5.5.3.1.37.1 Test Bitstream #A6-GE19 Specification: A series of VGA (640x480) resolution P-VOPs with some periodic I-VOPs,

17、 coded at frame rate 30 FPS with data partitioning and bit rate 4000Kbps. The number of MB/s, packet size and bit rate are the maximum allowed for the profile-and-level combination. To achieve the maximum bitrate, several MBs are INTRA coded for each frame. The vbv_occupancy in the VOL header must b

18、e used to begin decode at the proper time. The VBV approaches the maximum, then approaches the minimum after removal of a large frame that is near the vbv_buffer_size. Functional stage: VBV Purpose: Check that the decoder has sufficient buffering and I/O bandwidth for Simple Profile Level 4a. 5.5.3.

19、1.37.2 Test Bitstream #A6-GE20 Specification: A series of Euro-SDTV (720x576) resolution P-VOPs with some periodic I-VOPs, coded at frame rate 30 FPS with data partitioning and bit rate 8000Kbps. The number of MB/s, packet size and bit rate are the maximum allowed for the profile-and-level combinati

20、on. To achieve the maximum bitrate, several MBs are INTRA coded for each frame. The vbv_occupancy in the VOL header must be used to begin decode at the proper time. The VBV approaches the maximum, then approaches the minimum after removal of a large frame that is near the vbv_buffer_size. Functional

21、 stage: VBV Purpose: Check that the decoder has sufficient buffering and I/O bandwidth for Simple Profile Level 5. ISO/IEC 14496-4:2004/Amd.10:2005(E) 2 ISO/IEC 2005 All rights reservedIn subclause 5.5.7, add the following table after Table 10: Table AMD10-1 Normative Test Suites for Simple Profile

22、Levels 4a and 5 NOTE: Each row represents a single bitstream. Legend: S Bitstream is intended for functional test D Bitstream is intended for dynamic test X Bitstream is for functional and dynamic test Categories Bitstream Donated byBitstreamsNameSimple Error Resilient Simple Scalable L0b L1 L2 L3 L

23、4a L5 L0 L1 L2 A6-GE19 Texas Instruments ti_vga.cmp X A6-GE20 Texas Instruments ti_sdtv.cmp X ISO/IEC 14496-4:2004/Amd.10:2005(E) ICS 35.040 ISO/IEC 2005 All rights reserved PRINTEDINCANADAIMPRIMEAU CANADACopyright Notice This Amendment to the International Standard contains information copyright pr

24、otected by the International Organization for Standardization (ISO) and the International Electrotechnical Commission (IEC). Except as permitted under the laws of Canada, no extract of this Amendment to the International Standard may be reproduced, stored in any retrieval system, or transmitted in a

25、ny form or by any means, electronic, photocopying, recording, or otherwise, without prior permission from the Standards Council of Canada (SCC). Requests for permission to reproduce this Amendment to the International Standard or parts thereof should be addressed to Manager, Technical Document Centr

26、e Standards Council of Canada 270 Albert Street, Suite 200 Ottawa, Ontario K1P 6N7 The Canadian adoption of this Amendment to the International Standard contains information copyright protected by the Canadian Standards Association. All rights reserved. No part of this adopted Amendment may be repro

27、duced in any form whatsoever without the prior permission of the publisher. ISO/IEC material is reprinted with permission. Requests for permission to reproduce this adopted Amendment or parts thereof should be addressed to Director, Information Products Canadian Standards Association 5060 Spectrum Way, Suite 100 Mississauga, Ontario L4W 5N6 Copyright violators will be prosecuted to the full extent of the law.