BS DD IEC PAS 62722-1-2011 Luminaire performance General requirements《灯具性能 一般要求》.pdf

《BS DD IEC PAS 62722-1-2011 Luminaire performance General requirements《灯具性能 一般要求》.pdf》由会员分享，可在线阅读，更多相关《BS DD IEC PAS 62722-1-2011 Luminaire performance General requirements《灯具性能 一般要求》.pdf（18页珍藏版）》请在麦多课文档分享上搜索。

1、raising standards worldwideNO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBSI Standards PublicationLuminaire performance Part 1: General requirementsDD IEC/PAS 62722-1:2011National forewordThis Draft for Development is the UK implementation of IEC/PAS 62722-1:2011.The UK parti

2、cipation in its preparation was entrusted by Technical CommitteeCPL/34, Lamps and Related Equipment, to Subcommittee CPL/34/4,Luminaires.A list of organizations represented on this committee can be obtained onrequest to its secretary.This publication does not purport to include all the necessary pro

3、visions of acontract. Users are responsible for its correct application. BSI 2011ISBN 978 0 580 74843 1ICS 29.140.40Compliance with a British Standard cannot confer immunity fromlegal obligations.This Draft for Development was published under the authority of theStandards Policy and Strategy Committ

4、ee on 31 July 2011.Amendments issued since publicationAmd. No. Date Text affectedDRAFT FOR DEVELOPMENTDD IEC/PAS 62722-1:2011IEC/PAS 62722-1 Edition 1.0 2011-06 PUBLICLY AVAILABLE SPECIFICATION PRE-STANDARD Luminaire performance Part 1: General requirements INTERNATIONAL ELECTROTECHNICAL COMMISSION

5、N ICS 29.140.40 PRICE CODE ISBN 978-2-88912-567-8 Registered trademark of the International Electrotechnical Commission colourinsideDD IEC/PAS 62722-1:2011 2 PAS 62722-1 IEC:2011(E) CONTENTS FOREWORD . 3 INTRODUCTION . 5 1 Scope . 6 2 Normative references . 6 3 Terms and definitions . 6 4 General re

6、quirements . 7 5 Light sources and components of luminaires 8 6 Photometric data 8 7 Electrical data 8 8 Luminaire efficacy data. 9 9 Environmental data. 9 9.1 Materials information . 9 9.2 Maintenance instructions . 9 9.3 Disassembly instructions . 9 Annex A (normative) Use of regional standards .

7、10 Annex B (normative) Measurement method of total power of luminaires and associated parasitic power . 11 Annex C (informative) Symbols to assist the communication of instructions for maintenance through life and end of life recycling . 13 Bibliography 14 DD IEC/PAS 62722-1:2011PAS 62722-1 IEC:2011

8、(E) 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ LUMINAIRE PERFORMANCE Part 1: General requirements FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The obje

9、ct of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specificatio

10、ns (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaisi

11、ng with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express,

12、 as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees

13、 in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Co

14、mmittees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not pr

15、ovide any attestation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the l

16、atest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, w

17、hether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is

18、 indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. A PAS is a technical specif

19、ication not fulfilling the requirements for a standard, but made available to the public. IEC-PAS 62722-1 has been processed by subcommittee 34D: Luminaires, of IEC technical committee 34: Lamps and related equipment. The text of this PAS is based on the following document: This PAS was approved for

20、 publication by the P-members of the committee concerned as indicated in the following document Draft PAS Report on voting 34D/998/PAS 34D/1014/RVD Following publication of this PAS, which is a pre-standard publication, the technical committee or subcommittee concerned may transform it into an Inter

21、national Standard. DD IEC/PAS 62722-1:2011 4 PAS 62722-1 IEC:2011(E) This PAS shall remain valid for an initial maximum period of 3 years starting from the publication date. The validity may be extended for a single period up to a maximum of 3 years, at the end of which it shall be published as anot

22、her type of normative document, or shall be withdrawn. IMPORTANT The colour inside logo on the cover page of this publication indicates that it contains colours which are considered to be useful for the correct understanding of its contents. Users should therefore print this document using a colour

23、printer. DD IEC/PAS 62722-1:2011PAS 62722-1 IEC:2011(E) 5 INTRODUCTION The first edition of a performance PAS for luminaires (general requirements) acknowledges the need for defining performance data to be provided, the presentation of this data, the basis of its measurement, and the associated tole

24、rances that may be reasonably expected. Information to support responsible environmental use is also included. Part 2 sections to this Part 1 will be introduced where additional performance requirements for specific types of light source are required. The provisions in the PAS represent the technica

25、l knowledge of experts from the fields of the luminaire industry and associated components such as lamps and controlgear. DD IEC/PAS 62722-1:2011 6 PAS 62722-1 IEC:2011(E) LUMINAIRE PERFORMANCE Part 1: General requirements 1 Scope This PAS covers specific performance and environmental requirements f

26、or luminaires, incorporating electric light sources for operation from supply voltages up to 1 000 V where claims of operational performance are made. Unless otherwise detailed performance data covered under the scope of this PAS are for the luminaires in a condition representative of new manufactur

27、e, with any specified initial aging procedures completed. IEC/PAS 62722-1 covers requirements for luminaires to support energy efficient use and responsible environmental management to the end of life. The object of this Part 1 is to provide a set of requirements which are considered to be generally

28、 applicable to most types of luminaires. Where additional performance requirements for specific types of light source are relevant, these are specified in the IEC 62722-2 series. The IEC 62722-2 series may also cover a wider scope of performance aspects appropriate to the particular light source tec

29、hnology. NOTE The structure of these performance standards also allows for the possibility of Part 3 standards to be introduced in the future should standardisation of performance criteria linked to specific luminaire applications be determined as necessary (e. g. floodlighting, street lighting, etc

30、.). It is the intention that the requirements of this Part 1 are to be met by the provision of information and data provided by the luminaire manufacturer (or responsible vendor). Conformity is considered to be met by the provision of the requested information. Any verification of data is to be cond

31、ucted by the measurement requirements of this PAS. Semi-luminaires are not covered under the scope of this PAS. Luminaires shall be complete. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited

32、 applies. For undated references, the latest edition of the referenced document (including any amendments) applies. CIE 121:1996, The photometry and goniophotometry of luminaires CIE 121-SP1:2009, The photometry and goniophotometry of luminaires Supplement 1: Luminaires for emergency lighting IEC 60

33、598-1, Luminaires Part 1: General requirements and tests IEC 60598-2 (all parts), Luminaires Part 2: Particular requirements NOTE Annex A provides details of regional standards the use of which are preferred in some countries. 3 Terms and definitions For the purposes of all sections of this Part 1,

34、the definitions given in the IEC 60598 series and relevant Part 2 sections apply together with the following: DD IEC/PAS 62722-1:2011PAS 62722-1 IEC:2011(E) 7 3.1 input power electrical power from the mains supply consumed by the light source(s), controlgear and any control circuit in the luminaire,

35、 measured in watts which includes any parasitic power when the luminaire is turned on 3.2 parasitic power electrical power from the mains supply consumed by the charging circuit of emergency lighting luminaires and the standby power for controlgear and control devices in the luminaire when light sou

36、rces are not operating, measured in watts 3.3 standby losses electrical power from the mains supply consumed by the luminaire during the period with light sources not operating, measured in watts NOTE For emergency lighting luminaires this does not include the emergency lighting charging power. 3.4

37、rated emergency lighting charging power electrical power from the mains supply consumed by the charging circuit of emergency luminaires, measured in watts 3.5 luminaire efficacy ratio of the luminaires total lumen output versus its rated input power, excluding any parasitic power losses, expressed a

38、s lumens per watt 3.6 light output ratio (of a luminaire) LOR ratio of the total flux of the luminaire, measured under specified practical conditions with its own lamps and equipment, to the sum of the individual luminous fluxes of the same light sources when operated outside the luminaire with the

39、same equipment, under specified conditions 3.7 rated value quantitative value for a characteristic of a luminaire for specific operating conditions specified in this PAS, or in applicable standards, or assigned by the manufacturer or responsible vendor 3.8 test voltage voltage at which tests are car

40、ried out 4 General requirements 4.1 Luminaires shall meet the requirements of the IEC 60598-2 standards that are appropriate to their design. 4.2 Luminaires shall meet all requirements of this Part 1 and where applicable also the additional requirements of the Part 2 section appropriate to the type

41、of light source used by the luminaire. Where detailed in a Part 2 section alternative methods of measurement or limits to those given in this Part 1 may be specified. DD IEC/PAS 62722-1:2011 8 PAS 62722-1 IEC:2011(E) 4.3 Where it is specified by this standard that data is to be provided, this data m

42、ay be supplied by the manufacturer in printed or electronic formats, via the manufacturers catalogues, website, or similar. 5 Light sources and components of luminaires Any light sources and components delivered with the luminaire shall comply with the requirements of the IEC performance standards t

43、hat are appropriate to them. 6 Photometric data Photometric data shall be available for all variations of the luminaire and any optical attachments or accessories that the luminaire has been specified for use with. Photometric data shall be provided for luminaires in accordance with an established i

44、nternational or regional format as appropriate for the type of luminaire, and with luminous intensity distribution data according to the luminaires intended application. Data shall be available in electronic file format to facilitate its use by lighting design software. NOTE 1 Information regarding

45、acceptable regional standards for photometric data formats is given in Annex A. When measured in accordance with CIE 121 or CIE 121-SP1 the light output ratio (LOR) of the luminaire shall not vary by more than 10 % of the rated value. The distribution of luminous intensity shall generally be in acco

46、rdance with that declared by the manufacturer (method of comparison under consideration). NOTE 2 The allowed photometric variations detailed are to take account of manufacturing tolerances. When measurements are made additional allowance for laboratory measurement uncertainty also needs to be consid

47、ered. All photometric data shall be declared for the luminaire operating at its rated supply voltage. NOTE 3 For the photometric performance of emergency luminaires when operating in emergency mode see also IEC 60598-2-22. Luminaires for tungsten filament lamps may be photometrically rated, electric

48、ally rated and efficacy-rated with lamps of any wattage not exceeding the marked maximum, and any technology (e. g. halogen, self-ballasted compact fluorescent or self-ballasted LED), if these lamps are covered by an available IEC safety standard and are shown to comply with that standard. For these

49、 luminaires the number of lamps, their technology and their wattage shall be given in the luminaire manufacturers catalogue, website or similar. NOTE 4 The use of an ILCOS code according to IEC 61231 is also acceptable. 7 Electrical data Electrical supply data shall be provided for the luminaire and shall include the following: a) rated supply voltage; b) rated input power; c) rated parasitic power of the controls only during the time with the light sources off (standby losses); d) rated emergency li