ARMY MIL-T-51461 (1)-1987 TESTER AIRFLOW-GAS PARTICULATE FILTER UNIT M39《M39气体气流微粒过滤器装置检测器》.pdf

《ARMY MIL-T-51461 (1)-1987 TESTER AIRFLOW-GAS PARTICULATE FILTER UNIT M39《M39气体气流微粒过滤器装置检测器》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-T-51461 (1)-1987 TESTER AIRFLOW-GAS PARTICULATE FILTER UNIT M39《M39气体气流微粒过滤器装置检测器》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-T-51461( EA) AMENDMENT 1 23 September 1987 MILITARY SPECIFICATION TESTER, AIRFLOW, GAS-PARTICULATE FILTER UNIT, M39 c This amendment forms a part of MIL-T-51461(EA) 3 December 1980, and is approved for use within the Chemical Research, Development and Engineering Center (formerly Chemical System

2、s Laboratory), Department of the Aw and is available for use by dl Departments and Agencies of the Department of Defense. dated PAGE 1 Preamble, lines 1 and 2: delete “US Army Armament Research and Development Command“ and substitute “U.S. Army Chemical Research, Development and Engineer- ing Center

3、“. PAGE 1 (and DD Form 1426 following PAGE 6) Beneficial comments block lines 3 and 4, and DD Form 1426 address block: delete “Commander, US Army Armament Research and Development Command, ATTN: DRDAR-TSC-S , Aberdeen Proving Ground, M 21010“ and substitute “Commander, U.S. Army. Chemical Research,

4、Development and Engineering Center, ATTN: SMCCR- SPT-S, Aberdeen Proving Ground, MD 21010-5423“. PAGE 2 2.1, under Drawings and Technical Data Package List (TDPL) : Dglete “U.S. ARMY ARMAMENT -RESEARCH AND DEVELOPMENT COMMAND“ “CHEMICAL SYSTEMS LABORATORY“ and substitute “U.S. ARMY CHEMICAL RESEARCH

5、, DEVELOPMENT AND ENGINEERING CENTER, DEPARTMENT OF THE ARMY“. Delete “PS5-77-2120“ and its title; substitute the following: “SPECIAL PACKAGING INSTRUCTIONS (SPI) r- - P5-77-2120 - Tester, Airflow, Gas-Particulate -Filter Unit, M39.“ AMSC N/A FSC 4240 DISTRIBUTION STATEMENT A. * Approved for public

6、release; distribution is unlimited. Page 1 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MI-T-51461 (EA) AMENDMENT 1 PAGE 3 4.2.2.1, line 1: after “Sampling for examination“ add “and adhesion strength test . 4.2.2.2: delete in its entirety. I

7、PAGE 4 4.2.3.1: add the following to end of text: “Sample calibrated orifice assemblies shall be tested for adhesion strength in accordance with 4.3.2; the acceptance number is zero.“ - 4.2.3.2: delete in its entirety. PAGE 6 5.1: delete lines 2, 3, and 4 and substitute packing, packing, and mark sh

8、all be in accordance with SPI P5-77-2120“. 6.2(b): delete and substitute “(b) Applicable level of unit packing and packing required ( see 5.1) .“ 2 Preparing qct 4vity : Army - ELA Project No. 6680-221) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-