ARMY MIL-DTL-3628 195-1996 DETAIL SPECIFICATION SHEET nBADGE QUALIFICATION AVIATION NAVAL AVIATION OBSERVER AND FLIGHT METEOROLOGIST MARINE CORPS《海军陆战队 海军航空观测员和飞行气象学家 航空资格徽章》.pdf

《ARMY MIL-DTL-3628 195-1996 DETAIL SPECIFICATION SHEET nBADGE QUALIFICATION AVIATION NAVAL AVIATION OBSERVER AND FLIGHT METEOROLOGIST MARINE CORPS《海军陆战队 海军航空观测员和飞行气象学家 航空资格徽章》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-DTL-3628 195-1996 DETAIL SPECIFICATION SHEET nBADGE QUALIFICATION AVIATION NAVAL AVIATION OBSERVER AND FLIGHT METEOROLOGIST MARINE CORPS《海军陆战队 海军航空观测员和飞行气象学家 航空资格徽章》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、40b 2025380 830 = I NOT MEASUREMENT SENSITIVE I MIL-DTL-3628/195 SUPERSEDING 15 November 1996 MIL-B-l0955/22D 20 December 1994 DETAIL SPECIFICATION SHEET BADGE, QUALIFICATION, AVIATION, NAVAL AVIATION OBSERVER AND FLIGHT METEOROLOGIST, MARINE CORPS This specification is approved for use by all Depar

2、tments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet and the issue of MIL-DTL-3628 listed in that issue of the Department of Defense Index of Specifications and Standards (DODISSI specified in the soli

3、citation. MATERIAL: Red Brass FINISH : WINGS: Gold Plated, Matte Finish, Polished Highlights and shall match CENTER BACKGROUND: Gold Plated, Matte Finish and shall match TIOH CENTER RIM AND ANCHOR: Nickel Plated, Mirror-like Polished and shall TIOH Metal Finish Chip Number 8. Metal Finish Chip Numbe

4、r 7. match TIOH Metal Finish Chip Number 16. DIMENSIONS: HEIGHT (Overall) : 3/4 inch (1.91 Cm) (REF) WIDTH (overall) : 2-3/4 inches (6.99 cm) (REF) THICKNESS (At Thickest Point): 0.080 inch f 0.005 inch (0.203 cm f 0.012 cm) msc N/A FSC 8455 DISTRIBUTION STATEMENT A. Approved for public release; dis

5、tribution is unlimited. 1 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3b28/195 = Ob 2025181 777 MIL-DTL-3628/195 NOTES : furnished hub or die. 1. The term (REF) refers to measurements taken from the Government 2. Attaching device sha

6、ll be prong and clutch type. The prongs shall be located on the horizontal center line, equidistant from each end and 1- 3/8 inches f 1/32 inch (3.49 cm k 0.08 cm) apart. 3. The use of a forcer shall not be permitted. CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to i

7、dentify changes with respect to the previous issue due to the extent of the changes. Custodian: Army - IH Navy - NU Review activities: NAVY - MC DLA - CT Preparing activity: Army - IH (Project No. 8455-0865) 2 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-