ARMY A-A-52022 A-2003 REPAIR OUTFITS COLLAPSIBLE TANKS AND DRUMS (ROCTAD)《湿陷坦克和桶的修补装备》.pdf

《ARMY A-A-52022 A-2003 REPAIR OUTFITS COLLAPSIBLE TANKS AND DRUMS (ROCTAD)《湿陷坦克和桶的修补装备》.pdf》由会员分享，可在线阅读，更多相关《ARMY A-A-52022 A-2003 REPAIR OUTFITS COLLAPSIBLE TANKS AND DRUMS (ROCTAD)《湿陷坦克和桶的修补装备》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、INCH-POUND A-A-52022A December 2, 2003 SUPERSEDING A-A-52022 January 14, 1991 COMMERCIAL ITEM DESCRIPTION REPAIR OUTFITS, COLLAPSIBLE TANKS AND DRUMS (ROCTAD) The General Services Administration has authorized the use of this commercial item description, for all federal agencies. 1. SCOPE. This desc

2、ription covers a repair outfit used to repair cuts, abrasions, and punctures on tanks, drums, and berm liners made of elastomer-coated fabrics. 2. CLASSIFICATION. Type I - Turbine Fuel repair outfit (Ref. MIL-DTL-83133) Type II - Diesel Fuel repair outfit (Ref. MIL-DTL-46162) 3. SALIENT CHARACTERIST

3、ICS. 3.1 General. Each repair outfit shall be equipped to repair two seven-inch cuts and four punctures up to one-half inch in diameter. The repair outfits shall form a repair that is resistant to turbine fuel for Type I and referee grade diesel fuel for Type II. The repair outfit shall be capable o

4、f bonding to a coated fabric with any of the following base elastomers; nitrile, polyester polyurethane, polyether polyurethane, or neoprene. The repair outfit shall be capable of repairing tank and drum materials that have been contaminated with various fuels and water. Personnel wearing cold weath

5、er gloves or chemical protective gloves shall be capable of making a repair. a. Contractor shall certify that any substance released by a cured repair to 50 gallons of potable water to be below the EPA Maximum Contaminate Level when tested in accordance with National Sanitation Foundation (NSF) Stan

6、dard 61 or equivalent (see 7.2.4). b. Cured repair shall not contaminate the fuel stored in a repaired turbine fuel container. c. Cured repair shall not contaminate the fuel stored in a repaired diesel fuel container. Beneficial comments, recommendations, additions, deletions, clarifications, etc. a

7、nd any data that may improve this document should be sent by letter to: U.S. Army Tank-automotive and Armaments Command, ATTN: AMSRD-TAR-E/ASI, 6501 E. 11 Mile Road, Warren, MI 48397-5000 AMSC N/A FSC 5430 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. Provided by

8、IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-52022A 2 3.2 Materials. Two component adhesives shall be provided in pre-measured containers. The pre-measured containers shall enable the user to mix the proper proportions of each component to form the approp

9、riate adhesive compound for type I, type II and type III repair outfits. 3.3 Adhesive properties. 3.3.1 Cured repair patch (diesel). The peel adhesion between a cured repair patch and a coated fabric sample shall be 30 pounds per inch (lbs/in.) (13.6 kilograms (kg) per 25 millimeters (mm) minimum wh

10、en tested in accordance with ASTM D413 (machine method, 180 degrees). The coated fabric shall be a virgin sample which is contaminated by soaking in diesel fuel conforming to MIL-DTL-46162 for seven days at room temperature and wiping dry. The coated fabric surface shall then be cleaned and prepared

11、 before applying the repair patch. All four exposed edges of the test sample shall be protected from the diesel fuel during soaking. 3.3.2 Cured repair patch (JP-8 or Jet A). The peel adhesion between a cured repair patch and an aged coated fabric sample shall be 15 lbs/in. (6.8 kg/25 mm) minimum wh

12、en tested in accordance with ASTM D413 (machine method, 180 degrees). The coated fabric shall be a virgin sample that is aged by soaking in JP-8 or Jet A-1 for 14 days at 160 degrees Fahrenheit (F) (71.1 degrees Celsius (C), then 42 days in distilled water. The coated fabric surface shall then be cl

13、eaned and prepared before applying the repair patch. All four exposed edges of the test sample shall be protected from the fuel during soaking. 3.4 Operating conditions. The repair outfit shall be capable of making a repair outdoors in dry weather between 40F (4.4C) and 80F (26.7C). The repaired sec

14、tion of a tank, drum, or berm liner shall have as a minimum the same resistance to damage and leakage as the unrepaired section of fabric when operating under the following conditions: a. Operational use of the equipment at ambient temperatures from -25F (-31.7C) to +125F (+51.7C). b. Folded storage

15、 of the equipment at ambient temperatures from -30F (-34.4C) to +160F. c. Continuous contact with rainwater and ground water. d. Contact with fuel. 3.5 Components. Each repair outfit shall be equipped with all the tools and materials required to make a repair. As a minimum, the repair outfit shall c

16、onsist of the following: a. Patches (compatible for use with fuel or water, as appropriate) 2 each b. Surface roughing tool 1 each c. Hand-held roller. 1 each d. Adhesive. 2 each e. Stirring stick or spatula. 2 each Provided by IHSNot for ResaleNo reproduction or networking permitted without license

17、 from IHS-,-,-A-A-52022A 3 f. Protective gloves, disposable, large size 4 pair g. Adhesive applicator 2 each h. Protective mask. 2 each i. Resealable water resistant carrying case. 1 each j. Set of instructions. 1 each k. Degreaser/solvent cleaner with applicator not less than 4 fl oz. (118.3 millil

18、iters) l. Mixing bowl (required if adhesive must be mixed by user) 2 each m. Razor knife 2 each 3.6 Set of instructions. Instructions shall be provided on a weather resistant card or in a weather resistant pouch. In addition to the manufacturers set of instructions, the pot life of the adhesive comp

19、ound shall be listed at 45F (7.2C), 72F (22.2C), and 90F (32.2C). Also, the cure time of a repair at 45F, 72F, and 90F shall be listed. 3.7 Carrying case. All contents of each repair outfit shall fit into one resealable water-resistant carrying case. Color of the carrying case shall be non-reflectiv

20、e tan. If the protective mask is made of paper it shall be packaged in a transparent virgin polyethylene sealed bag before being placed in the carrying case. In addition to any special marking, each carrying case shall be permanently marked with the following information: a. Repair Outfit for Collap

21、sible Tanks and Drums, Type I or II. b. NSN: (or CAGE) c. MFR/PN: (manufacturers reference/part number) d. Contract No.: e. Date of Manufacture: f. Expiration Date: 3.8 Shelf life. The contents of the repair outfit shall have a minimum shelf life of 4.5 years when stored at 72F. 4. REGULATORY REQUIR

22、EMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR). 5. PRODUCT CONFORMANCE. The products provided shall meet the salient characteristics of this CID, conform to the

23、 producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial marketplace. (see 7.3) The Government reserves the right to require proof of such conformance. 5.1 Responsibility for inspection. The contractor is responsi

24、ble for the performance of all inspections (examinations and tests). Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-52022A 4 6 PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order (see 7.3). 7. NOTES. 7.1

25、Part or Identification Number (PIN). The following PIN (see 7.3) procedure is for Government purposes and does not constitute a requirement for the contractor. The PINs to be used for Repair Outfit Types, Collapsible Tanks And Drums (ROCTAD) acquired to this CID are created as follows: Example of re

26、ference part number: AA52022-1 AA 52022 - X Repair Outfit Type (see 2) 1 - Type I 2 - Type II CID number CID designator 7.2 Source of documents. 7.2.1 The Code of Federal Regulations (CFR) may be obtained from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402 or

27、website: http:/www.access.gpo.gov . 7.2.2 ASTM D413, “Standard Test Methods for Rubber Property - Adhesion to Flexible Substrate” is available from ASTM International, PO Box C700, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959 or website: http:/www.astm.org . 7.2.3 MIL-DTL-83133 “Turbine F

28、uels, Aviation, Kerosene Types, NATO F-34(JP-8), NATO F-35, And JP-8 + 100,” and MIL-DTL-46162 “Fuel, Diesel, Referee Grade” are available from the Document Automation and Production Service, Building 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094 or website: http:/assist.daps.dla.mil/online/st

29、art/ 7.2.4 NSF/ANSI Standard 61, “Drinking Water System Components Health Effects” is available from National Sanitation Foundation International, P.O. Box 130140, 789 N. Dixboro Road, Ann Arbor, MI 48113-0140 or website: www.nsf.org . 7.3 Ordering data. The contract or order should specify the foll

30、owing: a. Title, number and date of this CID. b. Product performance provisions (see 5). Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-52022A 5 c. Packaging requirements (see 6). d. Part or identification number (PIN) required (see 7.1). 7.4 Ma

31、terial safety data sheets (MSDS). Contracting officers should identify those activities requiring copies of MSDSs prepared in accordance with FED-STD-313. The pertinent Government mailing addresses for submission of data are listed in FED-STD-313; and 29 CFR 1910.1200 requires that the MSDS for each

32、 hazardous chemical used in an operation must be readily available to personnel using the material. Contracting officers should identify the activities requiring copies of the MSDS. 7.5 Key words. Cuts Elastomers Patches Punctures MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA-FSS Custodians: Army AT Navy - MC Preparing Activity: Air Force - 99 Army - AT Review Activities: (Project 5430-2716) Army - MI Air Force - 03, 84 DLA - CC, GS, IS Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-