API RP 536-2006 Post-Combustion NOx Control for Fired Equipment in General Refinery Services (SECOND EDITION)《一般炼油厂业务中发射设备的燃烧后的氮氧化物控制.第2版》.pdf

《API RP 536-2006 Post-Combustion NOx Control for Fired Equipment in General Refinery Services (SECOND EDITION)《一般炼油厂业务中发射设备的燃烧后的氮氧化物控制.第2版》.pdf》由会员分享，可在线阅读，更多相关《API RP 536-2006 Post-Combustion NOx Control for Fired Equipment in General Refinery Services (SECOND EDITION)《一般炼油厂业务中发射设备的燃烧后的氮氧化物控制.第2版》.pdf（70页珍藏版）》请在麦多课文档分享上搜索。

1、Post-Combustion NOxControl for Fired Equipment in General Refinery ServicesAPI RECOMMENDED PRACTICE 536SECOND EDITION, DECEMBER 2006REAFFIRMED, SEPTEMBER 2013Post-Combustion NOxControl for Fired Equipment in General Refinery ServicesDownstream SegmentAPI RECOMMENDED PRACTICE 536SECOND EDITION, DECEM

2、BER 2006REAFFIRMED, SEPTEMBER 2013SPECIAL NOTESAPI publications necessarily address problems of a general nature. With respect to particular circumstances, local, state, and federal laws and regulations should be reviewed.Neither API nor any of APIs employees, subcontractors, consultants, committees

3、, or other assignees make any warranty or representation, either express or implied, with respect to the accuracy, completeness, or usefulness of the information contained herein, or assume any liability or responsibility for any use, or the results of such use, of any information or process disclos

4、ed in this publication. Neither API nor any of APIs employees, subcontractors, con-sultants, or other assignees represent that use of this publication would not infringe upon pri-vately owned rights.API publications may be used by anyone desiring to do so. Every effort has been made by the Institute

5、 to assure the accuracy and reliability of the data contained in them; however, the Institute makes no representation, warranty, or guarantee in connection with this publication and hereby expressly disclaims any liability or responsibility for loss or damage resulting from its use or for the violat

6、ion of any authorities having jurisdiction with which this publi-cation may conflict.API publications are published to facilitate the broad availability of proven, sound engineer-ing and operating practices. These publications are not intended to obviate the need for applying sound engineering judgm

7、ent regarding when and where these publications should be utilized. The formulation and publication of API publications is not intended in any way to inhibit anyone from using any other practices.Any manufacturer marking equipment or materials in conformance with the marking requirements of an API s

8、tandard is solely responsible for complying with all the applicable requirements of that standard. API does not represent, warrant, or guarantee that such prod-ucts do in fact conform to the applicable API standard.All rights reserved. No part of this work may be reproduced, stored in a retrieval sy

9、stem, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission from the publisher. Contact the Publisher, API Publishing Services, 1220 L Street, N.W., Washington, D.C. 20005.Copyright 2006 American Petroleum InstituteFOREWORDNothin

10、g contained in any API publication is to be construed as granting any right, by impli-cation or otherwise, for the manufacture, sale, or use of any method, apparatus, or product covered by letters patent. Neither should anything contained in the publication be construed as insuring anyone against li

11、ability for infringement of letters patent.The following definitions apply:Shall: As used in a standard, “shall” denotes a minimum requirement in order to conform to the specification.Should: As used in a standard, “should” denotes a recommedation or that which is advised but not required in order t

12、o conform to the specification.This document was produced under API standardization procedures that ensure appropriate notification and participation in the developmental process and is designated as an API stan-dard. Questions concerning the interpretation of the content of this publication or comm

13、ents and questions concerning the procedures under which this publication was developed should be directed in writing to the Director of Standards, American Petroleum Institute, 1220 L Street, N.W., Washington, D.C. 20005. Requests for permission to reproduce or translate all or any part of the mate

14、rial published herein should also be addressed to the director.Generally, API standards are reviewed and revised, reaffirmed, or withdrawn at least every five years. A one-time extension of up to two years may be added to this review cycle. Status of the publication can be ascertained from the API S

15、tandards Department, telephone (202) 682-8000. A catalog of API publications and materials is published annually and updated quarterly by API, 1220 L Street, N.W., Washington, D.C. 20005.Suggested revisions are invited and should be submitted to the Standards and Publications Department, API, 1220 L

16、 Street, NW, Washington, DC 20005, standardsapi.org.iiiCONTENTSPage1 SCOPE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 APPLICABLE ENVIRONMENTAL REGULATIONS AND REFERENCES . . . . . .12.1 Environmental regulations.

17、. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12.2 U.S. Federal Regulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22.3 Environmental Protection Agency (EPA) References . . . . . . . . . . . . . . . . . . . . .

18、.22.4 National Standards or a source of carrier steam.3. Ammonia supply pump(s).4. Two cartridge filters and/or strainers.5. Ammonia vaporizer utilizing either an air heater or an external source of heat.6. Instrumentation and interconnecting piping for a fully functional system.7. The recommended c

19、omponents and features noted in 5.4.ii. Anhydrous Ammonia: Vaporized anhydrous ammonia is mixed directly with either an air or steam carrier. A vaporizer usually supplies heat to the storage tank to maintain pressure, and the ammonia vapor is drawn from the vapor space in the tank. The pri-mary comp

20、onents in this system are as follows, and Figure 3 illustrates a typical schematic representation of the system.1. Pressurized anhydrous ammonia storage tank.2. Carrier gas supply: two air blowers, or one blower and a backup air source; or a source of carrier steam.3. Ammonia vaporizer.POST-COMBUSTI

21、ON NOXCONTROL FOR FIRED EQUIPMENT IN GENERAL REFINERY SERVICES 134. Ammoniaair static mixer (if required).5. Instrumentation and interconnecting piping for a fully functional system.6. The recommended components and features noted in 5.4.b. Reactant Injection System (RIS), consisting of:1. Flow dist

22、ribution manifold with a series of injector nozzles that introduce the vaporized ammonia/carrier gas mixture to the flue gas stream.2. The recommended features noted in 5.5 and 5.7.c. System controls, provided by either a local control panel or the plants DCS.5.2.2 Urea-Based SNCR SystemsThe primary

23、 components of a urea-based SNCR system are as follows, and Figure 4 illustrates a typical schematic representation of the system.a. Urea Reactant Control and Dilutions System (RCDS), consisting of: 1. A reactant storage tank.2. Two cartridge filters and/or strainers.3. A reactant metering pump.4. A

24、 water pump, or dilution water source connection.5. An in-line static mixer as required.6. A series of flow indicators and regulating valves, as required, balancing the flow of reactant to each reactant injector. 7. All pertinent instrumentation and interconnecting piping for a fully functional syst

25、em. b. Reactant Injection System (RIS), consisting of:1. An atomizing chamber.2. Interconnecting tubing.3. Injector nozzles that introduce the atomized reactant/carrier air mixture into the flue gas stream.c. System controls, provided by either a local control panel and/or the plants DCS.5.3 SCR SYS

26、TEMS OVERVIEWThere are two major types of SCR systems: aqueous ammonia and anhydrous ammonia. The difference lies in the process used in the Reactant Control and Dilution System (RCDS) to vaporize the ammonia and mix it with the carrier air stream to obtain the reactant charge. SCR systems have one

27、of these two RCDS systems, a Reactant Injection System (RIS), a Selective Catalytic Reactor, system controls, and an Induced Draft Fan (if required):a. RCDSi. Aqueous Ammonia: Aqueous ammonia is pumped from the storage tanks and is commonly mixed with a heated carrier air stream in an ammonia vapori

28、zer/mixer. Alternatively, the ammonia can be vaporized in a once-through vaporizer before mixing with either an air or steam carrier. The primary components in this system are as follows, and Figure 5 illustrates a typical sche-matic representation of the system.1. Aqueous ammonia storage tank.2. Ca

29、rrier air supply: two air blowers, or one blower and a backup air source; or a source of carrier steam.3. Ammonia supply pump(s).4. Two cartridge filters and/or strainers.5. Air heater and ammoniaair vaporizer or ammonia vaporizer.6. All instrumentation and interconnecting piping for a fully functio

30、nal system.7. The recommended components and features noted in 5.4.ii. Anhydrous Ammonia: Vaporized anhydrous ammonia is mixed directly with carrier air or steam. A vaporizer usually supplies heat to the storage tank to maintain pressure, and the ammonia vapor is drawn from the vapor space in the ta

31、nk. The primary com-ponents in this system are as follows, and Figure 6 illustrates a typical schematic representation of the system.1. Pressurized anhydrous ammonia storage tank.2. Carrier air supply: two air blowers or one blower and a backup air source, or a source of carrier steam.3. Ammonia vap

32、orizer.POST-COMBUSTION NOXCONTROL FOR FIRED EQUIPMENT IN GENERAL REFINERY SERVICES 15Figure 2SNCR System Schematics Aqueous AmmoniaPOST-COMBUSTION NOXCONTROL FOR FIRED EQUIPMENT IN GENERAL REFINERY SERVICES 17Figure 3SNCR System Schematics Anhydrous AmmoniaPOST-COMBUSTION NOXCONTROL FOR FIRED EQUIPMENT IN GENERAL REFINERY SERVICES 19Figure 4SNCR System Schematics Urea InjectionPOST-COMBUSTION NOXCONTROL FOR FIRED EQUOPMENT IN GENERAL REFINERY SERVICES 21Figure 5SCR System Schematics Aqueous Ammonia