IEEE C62 34-2017 en Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between th.pdf

《IEEE C62 34-2017 en Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between th.pdf》由会员分享，可在线阅读，更多相关《IEEE C62 34-2017 en Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between th.pdf（40页珍藏版）》请在麦多课文档分享上搜索。

1、IEEE Standard for Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between the Transformer Low-Voltage Terminals and the Line Side of the Service Equipment) IEEE Std C62.34-2017 (Revision of IEEE Std C62.34-1996) IEEE P

2、ower and Energy Society Sponsored by the Surge Protective Devices Committee IEEE 3 Park Avenue New York, NY 10016-5997 USAIEEE Std C62.34-2017 (Revision of IEEE Std C62.34-1996) IEEE Standard for Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Second

3、ary Distribution Systems (Between the Transformer Low-Voltage Terminals and the Line Side of the Service Equipment) Sponsor Surge Protective Devices Committee of the IEEE Power and Energy Society Approved 28 September 2017 IEEE-SA Standards BoardAbstract: This standard applies to surge protective de

4、vices designed for application on the low- voltage supply mains (1000 V rms and less, frequency between 48 Hz and 62 Hz) and intended to be connected at locations between, and including, the secondary terminals of the distribution transformer and the line side of the service equipment. Such surge pr

5、otective devices are also known as secondary arresters. This is coordinated with IEEE Std C62.44 (the application guide), NEC Article 285, and ANSI/UL 1449. Keywords: IEEE C62.34, low voltage, secondary arresters, surge protective devices, SPDs, Type 1 SPDs The Institute of Electrical and Electronic

6、s Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2017 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 27 October 2017. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particu

7、lar purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is

8、 wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and iss

9、ued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is

10、 IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent

11、 professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY , OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS;

12、OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY , WHETHER IN CONTRACT, STRICT LIABILITY , OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARD

13、LESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard.4 Copyright

14、2017 IEEE. All rights reserved. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be,

15、 or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IE

16、EE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in docume

17、nts should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reas

18、on, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person

19、 who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standar

20、ds documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory req

21、uirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws.

22、 They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents a

23、vailable for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for comp

24、any or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard fo

25、r educational classroom use can also be obtained through the Copyright Clearance Center.5 Copyright 2017 IEEE. All rights reserved. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new edition

26、s or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to revi

27、ew at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have

28、 the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ ieeexplore .ieee .or g/ xpl/ standards .jsp or contact IEEE a

29、t the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/ standards .ieee .or g. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/ standards .ieee

30、 .org/ findstds/ errata/ index .html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken

31、by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE- SA Website at http:/ standards .ieee .or g/ abo

32、ut/ sasb/ patcom/ patents .html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to appli

33、cants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Paten

34、ts Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any pat

35、ent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association.6 Copyright 2017 IEEE. All rights reserved. Participants At the time this IEEE standard was completed, the 3.6.9 Low V oltage AC Powe

36、r System SPDsLine Side of the Service Equipment Working Group had the following membership: Raymond C. Hill, Technical Editor and Chair Andrea T urner Haa, Vice Chair James Moellmann, Secretary Ken Brown Bryan Cole Vincent Crevenat Dan Ellis Louis Farquhar Ronald Hotchkiss Wilhelm Kapp Joseph L. Koe

37、pfinger Steve Millard Tom Phipps Tony Surtees Jim Tiesi Matt Wakeham Mark Wingate The Working Group is grateful for the contributions of the following individuals: Chrys Chrysanthou Joe Degregoria Ted Dhooge Gary Goedde Bill Goldbach David Jackson Chuck Jensen Dirk Malencia Francois Martzolff Carey

38、Mossop Perry Sloop Hans Steinhoff Frank Waterer Steve Whisenant The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Saleman Alibhay Robert Ashton Thomas Barnes Frank Basciano William Bloethe Gustavo Br

39、unello Thomas Callsen Suresh Channarasappa Weijen Chen Stephen Conrad Gary Donner Louis Farquhar Frank Gerleve David Gilmer Randall Groves Jeffrey Helzer Raymond C. Hill Gary Hoffman Philip Hopkinson Ronald Hotchkiss Laszlo Kadar Yuri Khersonsky Joseph L. Koepfinger Jim Kulchisky Chung-Yiu Lam Willi

40、am Larzelere Michael Lauxman Paul Lindemulder Albert Livshitz Albert Martin Michael Maytum Omar Mazzoni James Moellmann Daleep Mohla R. Murphy Edrin Murzaku Michael Newman Hans-Wo Oertel Lorraine Padden Bansi Patel Christopher Petrola Thomas Phipps Robert Resuali Michael Roberts Thomas Rozek Steven

41、Sano Bartien Sayogo Nikunj Shah David Singleton Jerry Smith Gary Smullin Wayne Stec K. Stump David Tepen Roger Verdolin John Vergis Matthew Wakeham Yingli Wen James Wilson Mark Wingate7 Copyright 2017 IEEE. All rights reserved. When the IEEE-SA Standards Board approved this standard on 28 September

42、2017, it had the following membership: Jean-Phillippe Faure, Chair Gary Hoffman, Vice Chair John D. Kulick, Past Chair Konstantinos Karachalios, Secretary Chuck Adams Masayuki Ariyoshi Ted Burse Stephen Dukes Doug Edwards J. Travis Griffith Michael Janezic Thomas Koshy Joseph L. Koepfinger* Kevin Lu

43、 Daleep Mohla Damir Novosel Ronald C. Petersen Annette D. Reilly Robby Robson Dorothy Stanley Adrian Stephens Mehmet Ulema Phil Wennblom Howard Wolfman Yu Yuan *Member Emeritus8 Copyright 2017 IEEE. All rights reserved. Introduction This introduction is not part of IEEE Std C62.34-2017, IEEE Standar

44、d for Test Methods and Performance of Low-V oltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between the Transformer Low-V oltage Terminals and the Line Side of the Service Equipment). Secondary arresters have been used since 1940 to protect the secondary

45、winding of distribution transformers, kilowatt-hour meters, service entrance equipment, and power equipment loads downstream from breakdown of insulation during lightning strikes and switching surges. Performance criteria for secondary arresters were included in standards for performance of high-vol

46、tage arresters in IEEE Std C62.1-1989 and IEEE Std C62.11-1993. However, IEEE Std C62.1-1989 is no longer in publication and IEEE Std C62.11-1993 has been updated and secondary arresters dropped from its scope. With the proliferation of electronic equipment installed inside buildings, the emphasis h

47、as shifted away from protection of insulation of transformer windings and wiring to protection of vulnerable downstream electronic equipment. Due to increased sensitivity of downstream equipment to surges, the requirements for secondary arresters have necessarily become more stringent. The standards developers have attempted, as far as reasonable and possible, to harmonize with relevant domestic and international standards.