IEC 62542-2013 Environmental standardization for electrical and electronic products and systems - Standardization of environmental aspects - Glossary of terms《电器及电子产品和系统的环境标准化.环境因素的标准化.术语表》.pdf

《IEC 62542-2013 Environmental standardization for electrical and electronic products and systems - Standardization of environmental aspects - Glossary of terms《电器及电子产品和系统的环境标准化.环境因素的标准化.术语表》.pdf》由会员分享，可在线阅读，更多相关《IEC 62542-2013 Environmental standardization for electrical and electronic products and systems - Standardization of environmental aspects - Glossary of terms《电器及电子产品和系统的环境标准化.环境因素的标准化.术语表》.pdf（42页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 62542 Edition 1.0 2013-06 INTERNATIONAL STANDARD NORME INTERNATIONALE Environmental standardization for electrical and electronic products and systems Glossary of terms Normalisation environnementale pour les produits et les systmes lectriques et lectroniques Glossaire des termes IEC62542:2013H

2、ORIZONTAL STANDARD NORME HORIZONTALE colourinsideTHIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2013 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including

3、 photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or yo

4、ur local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les mi

5、crofilms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votr

6、e pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Stan

7、dards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Useful links: IEC publi

8、cations search - www.iec.ch/searchpub The advanced search enables you to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay

9、up to date on all new IEC publications. Just Published details all new publications released. Available on-line and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definition

10、s in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary (IEV) on-line. Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Cus

11、tomer Service Centre: csciec.ch. A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI

12、 Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.iec.ch/searchpub La recherche avance vous permet de trouver des pub

13、lications CEI en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications de la CEI. Just Published

14、 dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi qu

15、e les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (VEI) en ligne. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 625

16、42 Edition 1.0 2013-06 INTERNATIONAL STANDARD NORME INTERNATIONALE Environmental standardization for electrical and electronic products and systems Glossary of terms Normalisation environnementale pour les produits et les systmes lectriques et lectroniques Glossaire des termes INTERNATIONAL ELECTROT

17、ECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE R ICS 01.120; 13.020.30; 29.020; 31.020 PRICE CODE CODE PRIX ISBN 978-2-83220-838-0 HORIZONTAL STANDARD NORME HORIZONTALE Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechniqu

18、e Internationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colourinside 2 62542 IEC:2013 CONTENTS FOREWORD . 3 INTRODUCTION . 5 1 Scope . 6 2 Normative referen

19、ces . 6 3 General terms relating to environmental protection and management . 6 4 Terms relating to determination and declaration of substances and materials . 9 5 Terms relating to energy efficiency and power consumption . 11 6 Terms relating to resource conservation and re-use . 13 Annex A (inform

20、ative) Operating conditions of equipment in respect of power demand 16 Annex B (informative) Index of terms . 17 Bibliography 18 Table A.1 Operating conditions of equipment in respect to power demand . 16 62542 IEC:2013 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ ENVIRONMENTAL STANDARDIZATION FOR

21、ELECTRICAL AND ELECTRONIC PRODUCTS AND SYSTEMS GLOSSARY OF TERMS FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote internationa

22、l co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter refer

23、red to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising with the IEC also participate in

24、this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an internati

25、onal consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable

26、 efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publ

27、ications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity.

28、 Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7

29、) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for co

30、sts (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct appli

31、cation of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 62542 has been prepared by IEC techn

32、ical committee 111: Environmental standardization for electrical and electronic products and systems. It has the status of a horizontal standard in accordance with IEC Guide 108. The text of this standard is based on the following documents: FDIS Report on voting 111/302/FDIS 111/312/RVD Full inform

33、ation on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. 4 62542 IEC:2013 The committee has decided that the contents of this publication will remain u

34、nchanged until the stability date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTANT The colour inside logo on the cover page o

35、f this publication indicates that it contains colours which are considered to be useful for the correct understanding of its contents. Users should therefore print this document using a colour printer. 62542 IEC:2013 5 INTRODUCTION The definitions noted in this International Standard are intended to

36、 be considered by all new and existing IEC standards under maintenance that are meant to fulfil standardization needs, associated directly or indirectly, with an environmental topic or which may reference environmental aspects/impacts, even if the standard is not exclusively an environmental one. In

37、 addition this standard aims to utilise and harmonize definitions in other related documents. This standard will be updated periodically as relevant international standardization documents evolve. Wherever possible, the terms and definitions included herein have been taken from other IEC or ISO deli

38、verables, either verbatim or modified if appropriate so as to make them suitable for use in a wide range of IEC deliverables on environmental matters. This standard also contains definitions for terms that are likely to be required by IEC deliverables on environmental matters, but are not yet descri

39、bed elsewhere. 6 62542 IEC:2013 ENVIRONMENTAL STANDARDIZATION FOR ELECTRICAL AND ELECTRONIC PRODUCTS AND SYSTEMS GLOSSARY OF TERMS 1 Scope This International Standard specifies generic terms and definitions that are related to environmental standardization within the IEC. It serves as a glossary of

40、terminology to be considered for environmental aspects of relevant work in IEC. The terms cover environmental issues that are relevant for electrotechnical products across all product life cycle stages, including but not limited to design and supply chain aspects in general, use and declaration of m

41、aterials, analytics of environmentally relevant substances, aspects relating to climate protection, power consumption and energy efficiency, environmental information, end of life treatment. This horizontal standard is primarily intended for use by technical committees in the preparation of standard

42、s in accordance with the principles laid down in IEC Guide 108. One of the responsibilities of a technical committee is, wherever applicable, to make use of horizontal standards in the preparation of its publications. The contents of this horizontal standard will not apply unless specifically referr

43、ed to or included in the relevant publications. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition

44、 of the referenced document (including any amendments) applies. Guide 108, Guidelines for ensuring the coherency of IEC publications Application of horizontal standards 3 General terms relating to environmental protection and management 3.1 design and development activities that take an idea or requ

45、irement and transform these into a product Note 1 to entry: The process of design and development usually follows a series of defined steps starting with an initial idea, transforming that into a formal specification, and resulting in the creation of a working prototype and whatever documentation is

46、 required to support production of the goods or provision of the service. SOURCE: IEC 62430:2009, definition 3.1 62542 IEC:2013 7 3.2 electronic assembly set of components, at least one of which is an electronic component, assembled into a single unit EXAMPLE Group of components mounted on a printed

47、 wiring board printed circuit board. 3.3 electronic component electronic device that cannot be taken apart without destruction or impairment of its intended use EXAMPLE Resistors, capacitors, diodes, integrated circuits, hybrids, application specific integrated circuits, wound components and relays.

48、 Note 1 to entry: Electronic components are sometimes called electronic parts, or piece parts. 3.4 emission direct or indirect release from a product or process into the air, water or soil EXAMPLE A release could include one or more substances, heat, light, sound, electromagnetic fields, etc. 3.5 en

49、vironment surroundings in which a product or system exists, including air, water, land, natural resources, flora, fauna, humans and their interrelation SOURCE: ISO 14001:2004, definition 3.5, modified “in which an organization operates” replaced by “in which a product or system exists” 3.6 environmental aspect element of an organizations activities or products that can interact with the environment Note 1 to entry: A si