UL SUBJECT 2749-2011 OUTLINE OF INVESTIGATION FOR SEASONAL USE LED DRIVERS AND NON-INTEGRAL LED LIGHTING STRINGS (Issue 2)《季节性使用的LED驱动器和非整数的LED灯串的调查大纲 (议题2)》.pdf

《UL SUBJECT 2749-2011 OUTLINE OF INVESTIGATION FOR SEASONAL USE LED DRIVERS AND NON-INTEGRAL LED LIGHTING STRINGS (Issue 2)《季节性使用的LED驱动器和非整数的LED灯串的调查大纲 (议题2)》.pdf》由会员分享，可在线阅读，更多相关《UL SUBJECT 2749-2011 OUTLINE OF INVESTIGATION FOR SEASONAL USE LED DRIVERS AND NON-INTEGRAL LED LIGHTING STRINGS (Issue 2)《季节性使用的LED驱动器和非整数的LED灯串的调查大纲 (议题2)》.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION ORDISTRIBUTION WITHOUT PERMISSION FROM ULJune 17, 20111SUBJECT 2749OUTLINE OF INVESTIGATIONFORSEASONAL USE LED DRIVERS AND NON-INTEGRAL LED LIGHTINGSTRINGSIssue Number: 2JUNE 17, 2011Summary of TopicsThe second issue of the Outline of I

2、nvestigation for Seasonal Use LEDDrivers and Non-Integral LED Lighting Strings was published to clarify therequirement in 6.1.COPYRIGHT 2011 UNDERWRITERS LABORATORIES INC.UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION ORDISTRIBUTION WITHOUT PERMISSION FROM ULJUNE 17, 2011SUBJECT 274

3、92No Text on This PageUL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION ORDISTRIBUTION WITHOUT PERMISSION FROM ULCONTENTSINTRODUCTION1 Scope .42 Units of Measurement .43 Undated References 44 Components 4CONSTRUCTION5 LED Drivers 56 Non-Integral Lighting Strings .5MARKINGS AND INSTRUCT

4、IONS7 Markings .58 Instruction Manual 6JUNE 17, 2011 SUBJECT 2749 3UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION ORDISTRIBUTION WITHOUT PERMISSION FROM ULINTRODUCTION1 Scope1.1 This outline covers the requirements for drivers for use with light-emitting-diode (LED) decorativelighti

5、ng applications and non-integral light-emitting-diode lighting strings. A non-integral lighting string is anLED lighting string that is provided with one or more fittings that are not of a standard type NEMAconfiguration. These requirements supplement those described in the referenced standards.2 Un

6、its of Measurement2.1 In addition to being stated in the inch/pound units that are customary in the USA, each of therequirements in this outline is also stated in units that make the requirement conveniently usable incountries employing the metric system (practical SI). Equivalent although not neces

7、sarily exactlyidentical results are to be expected from applying a requirement in USA or metric terms. Equipmentcalibrated in metric units is to be used when a requirement is applied in metric terms.3 Undated References3.1 Any undated reference to a code or standard appearing in the requirements of

8、this outline shall beinterpreted as referring to the latest edition of that code or standard.4 Components4.1 Except as indicated in 4.2 a component (including gaskets and polymeric materials) of a productcovered by this outline of investigation shall comply with the requirements for that component.4

9、.2 A component is not required to comply with a specific requirement that:a) Involves a feature or characteristic not required in the application of the component in theproduct covered by this outline of investigation, orb) Is superseded by a requirement in this outline of investigation.4.3 A compon

10、ent shall be used in accordance with its rating established for the intended conditions ofuse.4.4 Specific components are incomplete in construction features or restricted in performance capabilities.Such components are intended for use only under limited conditions, such as certain temperatures not

11、exceeding specified limits, and shall be used only under those specific conditions.JUNE 17, 2011SUBJECT 27494UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION ORDISTRIBUTION WITHOUT PERMISSION FROM ULCONSTRUCTION5 LED Drivers5.1 An LED driver shall comply with the construction, perform

12、ance, and production requirements of theStandard for Class 2 Power Units, UL 1310, and as specified below.5.2 An LED driver intended for outdoor use as marked on the device shall comply with the Outdoor Useperformance requirements of the Standard for Class 2 Power Units, UL 1310, including the Stand

13、ingWater Immersion Test. As a result of the Rain Test, the LED driver shall comply with the raintightrequirements.5.3 An LED driver shall comply with the Standard for Class 2 Power Units, UL 1310, Normal TemperatureTest requirements under conditions of maximum obtainable output current and maximum o

14、btainableoutput power.5.4 With reference to 8.1, the combination of the driver and the non-integral lighting string shall complywith the applicable requirements specified in the Standard for Seasonal and Holiday Decorative Products,UL 588.6 Non-Integral Lighting Strings6.1 A non-integral lighting st

15、ring shall comply with the applicable requirements described in the Standardfor Seasonal and Holiday Decorative Products, UL 588, for lighting strings that are located in the outputof a Class 2 power unit; however, the Exceptions for products located in a Class 2 circuit with a maximumavailable powe

16、r of 15 Watts do not apply to non-integral lighting strings, regardless of the available powerof the LED driver.6.2 A non-integral lighting string shall be provided with non-standard type connectors. The connectorshall be provided with a strain relief means such that the pull exerted on the supply c

17、ord cannot betransmitted directly to the terminals, splices or internal wiring of the connector. Compliance shall bedetermined by the Strain Relief Test, Section 46 of the Standard for Seasonal and Holiday DecorativeProducts, UL 588.MARKINGS AND INSTRUCTIONS7 Markings7.1 An LED driver shall not be m

18、arked with any Class designation such as Class 1, Class 2, or Class 3.7.2 In addition to the markings of Section 116, Product/Cord Tag Markings, of the Standard for Seasonaland Holiday Decorative Products, UL 588, an LED driver shall employ the following markings:a) Output voltage rating;b) Output c

19、urrent rating not exceeding 5 amperes, or output volt-ampere or watt rating notexceeding 100 VA or 100 W;c) Indication of output type (ac or dc) and frequency if ac;d) “For use only with UL Listed non-integral LED light string rated_Watts”. The blankshould be filled in with the suitable rating.JUNE

20、17, 2011 SUBJECT 2749 5UL COPYRIGHTED MATERIAL NOT AUTHORIZED FOR FURTHER REPRODUCTION ORDISTRIBUTION WITHOUT PERMISSION FROM UL7.3 In addition to the required markings specified in Section 116, Product/Cord Tag Markings, of theStandard for Seasonal and Holiday Decorative Products, UL 588, the non-i

21、ntegral lighting string shall bemarked within 3 inches of the male connector, “Caution: To reduce the risk of fire or electric shock, useonly with UL Listed seasonal use LED drivers rated _Watts.” The blank should be filled in with thesuitable rating.8 Instruction Manual8.1 The instruction manual fo

22、r the LED driver shall include information on the product(s) intended forinterconnection consistent with the markings. In addition, it shall contain the following statement orequivalent: “If the connector of this driver does not properly fit into the connector of the lighting string, donot modify th

23、e product and discard the product if the connector is damaged.”8.2 In addition to the applicable requirements from Section 120 123 of the Standard for Seasonal andHoliday Decorative Products, UL 588, the instruction manual for the non-integral lighting string shallinclude the following statement or equivalent: “If the connector of this lighting string does not properly fitinto the connector of the driver, do not modify the product and discard product if the connector isdamaged.”JUNE 17, 2011SUBJECT 27496